Page 2 - INDEX
S31NUK5120(3)2001-04 INDEX INTRODUCTION / GENERAL INFORMATION ............................................................................. 1UNPACKING .................................................................................................................................. 2TECHNICAL DATA .....
Page 3 - If not, request assistance from the service centre.; SAFETY- ACCIDENT PREVENTION; INTRODUCTION / GENERAL INFORMATION
S31NUK5120(3)2001-04 This manual will help you get the most from your Nilfisk SR1100 - SR1200. Read it thoroughly before operating the machine. Specifications and details are subject to change without prior notice. SPARE PARTS AND MAINTENANCE Repairs, when required, should be performed by Nilfisk-Ad...
Page 4 - UNPACKING; - envelope with cables for batteries and
S31NUK5120(3)2001-04 UNPACKING Please check that the following items are supplied with the machine: 1 - envelope with cables for batteries and connector for battery-charger. 2 - technical documents (Spare Parts Catalogue, Manual for Use and Maintenance and - for the petrol version only - Use and Mai...
Page 5 - TECHNICAL DATA; VERSION
S31NUK5120(3)2001-04 TECHNICAL DATA 3 VERSION SR 1100B - SR 5110B SR 1100P - SR 5110P SR 1200B - SR 5120B SR 1200P - SR 5120P Voltage 24V 24V 24V 24V Engine model / Honda G150 -K1 144 cc / Honda G150 -K1 144 cc Nominal Power at 3600 RPM / 3,8 Hp - 2,8 Kw / 3,8 Hp - 2,8 Kw Power at 3200 RPM setting /...
Page 7 - PRELIMINARY OPERATIONS
S31NUK5120(3)2001-04 Both versions of the machine, petrol and battery, require a 24 V battery set. Depending on the country where the machine is sold three possibilities can occur: 1 - the battery is supplied with the machine and it is set, complete with acid solution 2 - the battery is supplied wit...
Page 8 - - If the batteries are installed but not filled with
S31NUK5120(3)2001-04 PRELIMINARY OPERATIONS 2 - If the batteries are installed but not filled with acid solution they must be filled with a solution of sulphuric acid (density between 1,270 Kg and 1,290 Kg at 25°C temperature) according to the instructions specified below and in the Battery User Man...
Page 9 - UNLEADED PETROL; and
S31NUK5120(3)2001-04 Connect the battery connector to the machine. 3 - If the machine is not equipped with batteries they must be procured and mounted. It is recommended to get the assistance of qualified personnel to choose and set the batteries. The electric cables supplied with the machine can be...
Page 10 - USE; Note; START/STOP OF THE PETROL ENGINE
S31NUK5120(3)2001-04 USE Insert the ignition key into the panel and turn it clockwise: the display will show all zeros and after about three seconds the battery voltage will appear. Note : the temporary lighting of the two side brush indicators and the short sound from the reverse speed acoustic ind...
Page 11 - USE OF THE WORKING PROGRAMS
S31NUK5120(3)2001-04 P1 P2 USE OF THE WORKING PROGRAMS Once the machine has been turned on and eventually after starting the petrol engine, choose one of the two working programs P1 and P2 according to your cleaning need and press the relevant button: P1 is the “light cleaning program” (for internal...
Page 12 - Press the accelerator pedal to start the job.; : by releasing the accelerator pedal (or
S31NUK5120(3)2001-04 USE It is possible to adjust the side brush/es turning speed by means of the dedicated knob. Select the forward speed by means of the command lever. Press the accelerator pedal to start the job. Note : by releasing the accelerator pedal (or setting the command lever to the neutr...
Page 13 - or
S31NUK5120(3)2001-04 1 4 2 3 To collect light and bulky debris lift the front flap using the left pedal (do not press the pedal down for a long time, not to reduce the suction capability of the machine). The machine gets an automatic breaking function when the accelerator pedal is released; when nec...
Page 15 - - protection against the deep discharge of the
S31NUK5120(3)2001-04 USE FURTHER PERFORMANCES OF THE MACHINE WITH PETROL ENGINE The machine equipped with the petrol engine is able to work with full performance even if the petrol engine is turned Off; this could occur just because the machine run out of the fuel or when it is necessary to work in ...
Page 16 - Warning; : the following operations must be done; : when the brush is replaced set the
S31NUK5120(3)2001-04 Warning : the following operations must be done with the machine in Off condition and master key out, on a flat floor. When the side brush is worn its height must be adjusted. Loosen the knob. Turn the adjusting disk and move its position of one hole. And tighten the knob. To ch...
Page 17 - MAIN BRUSH REPLACEMENT
S31NUK5120(3)2001-04 MAIN BRUSH REPLACEMENT Warning : the following operations must be done with the machine in Off condition and master key out. This machine is equipped with an automatic control of the main brush pressure; this also means that the position of the main brush is automatically adjust...
Page 18 - Remove the worn out brush.
S31NUK5120(3)2001-04 Remove the worn out brush. Fit the new brush in its compartment, paying attention to the engagement of the plastic adapter with the hub on the opposite side of the compartment. Fit the lid of the main brush compartment using the three knobs previously removed. MAIN BRUSH REPLACE...
Page 19 - FILTER CLEANING AND REPLACEMENT; The panel filter requires a regular cleaning.
S31NUK5120(3)2001-04 FILTER CLEANING AND REPLACEMENT The panel filter requires a regular cleaning. Lift the lid. Remove the lid of the filter compartment. Disconnect the electric cable of the filter-shaker motor (the machine must first be switched off and the key out). Loosen the two screws with but...
Page 23 - : the engine oil must be replaced the
S31NUK5120(3)2001-04 MAINTENANCE OF THE PETROL ENGINE (HONDA) MAINTENANCE OF THE PETROL ENGINE (HONDA) First: read thoroughly the Use and Maintenance Manual of the engine.Here below some recommendations are pointed out. Check the engine oil level at each working session; for possible fill up read th...
Page 24 - : it is suggested to remove the oil when the; : keep the emptying hose lifted and open; MAINTENANCE
S31NUK5120(3)2001-04 A B Remove the cap from the engine oil emptying hose and let the oil come out. Note : it is suggested to remove the oil when the engine is warm. Dispose of the used oil in proper special containers. Note : keep the emptying hose lifted and open during filling. Take a funnel and ...
Page 27 - OPTIONAL ITEMS; Battery charger
S31NUK5120(3)2001-04 OPTIONAL ITEMS High capacity batteries both for the petrol version and for the battery version. Battery charger Different types of main bushes and side brushes Polyester panel filter (it can be washed) -Mini containers-Flashing beacon on support-Rollbar-Flashing beacon on rollba...
Page 29 - SERVICE ADDRESS
S31NUK5120(3)2001-04 SERVICE ADDRESS AUSTRALIA Nilfisk-Advance Pty. Ltd.ACN 003 762 623Head office: 17 Leeds Street, Rhodes, N. S. W. 2138Tel.(02) 9736 1244 - Fax (02) 9736 3910Customer Responce Centre:Tel.1 800 011 013 BELGIQUE/BELGIË/LUXEMBOURG Nilfisk-Advance s.a./n.v.Doornveld/Sphere Business Pa...
