Neumann D1761 - Manual

Important notes 2 - English A26361-D1761-Z120-1-6319 Important notes With the mainboard installed you must open the system to access the mainboard. How to dismantle and reassemble the system is described in the operating manual accompanying the system. Connecting cables for peripherals must be adequ...

List of features A26361-D1761-Z120-1-6319 English - 3 List of features Onboard features D1761-A Chipset SiS661FX /964L Board size µATX VGA ü Audio / 6-channel / S/PDIF 5.1 ü / ü / - Buzzer / int. Speaker Support - / ü LAN 1 Gbit / 100 Mbit / 10 Mbit - / ü / ü LAN / with Alert-on-LAN / WoL / Boot - /...

List of features A26361-D1761-Z120-1-6319 English - 5 Special features Your mainboard is available in different configuration levels. Depending on the configuration, your mainboard is equipped with or supports the features described in the following. Silent Drives Hard disks and optical drives (CD-R...

6 - English A26361-D1761-Z120-1-6319 Brief instructions on installing mainboard If you have purchased a separate mainboard, you can install it in your system in accordance with the following brief instructions. The activities described here assume a basic knowledge of PCs and cannot be carried out b...

Brief instructions on installing mainboard A26361-D1761-Z120-1-6319 English - 7 ► Should no suitable connection field be provided in the case, then you must install the connection field (1) provided. Ensure the plate is aligned properly so that the connections are suitable for the mainboard later. ►...

8 - English A26361-D1761-Z120-1-6319 Interfaces and connectors The positions of the interfaces and connectors are shown on page "Cover". The components and connectors marked are not necessarily present on the mainboard. External ports The positions of the external ports are shown on page ...

Internal ports and connectors A26361-D1761-Z120-1-6319 English - 9 Internal ports and connectors The positions of the internal ports and connectors are shown on the Cover. Additional information on some ports is also provided here. Hard disk connection An ultra ATA/66 or ultra ATA/100 hard disk must...

Internal ports and connectors 10 - English A26361-D1761-Z120-1-6319 Using external audio connections 123 Analogue 2-channel audio output With the 2-channel configuration the functions Line-Out, Line-In and MIC are available. 1 = Line-In (blue) 2 = Line-Out (front channels, green) 3 = MIC (red) 123 A...

Pin assignment of internal ports A26361-D1761-Z120-1-6319 English - 11 Pin assignment of internal ports The pin assignment of some internal connections is shown in English in the following. i Some of the following connectors may be optional! Front panel Watch the poling of the LEDs. The positive pol...

Pin assignment of internal ports A26361-D1761-Z120-1-6319 English - 13 Floppy interface 1 Pin Signal Pin Signal 1 GND 18 Step DIR (low asserted) 2 FDHDIN (low asserted) 19 GND 3 GND 20 Step Pulse (low asserted) 4 not connected 21 GND 5 Key 22 Write Data (low asserted) 6 not connected 23 GND 7 GND 24...

Pin assignment of internal ports 14 - English A26361-D1761-Z120-1-6319 ATA interface 1 2 Pin Signal Pin Signal 1 Reset drive (low asserted) 2 GND 3 Data 7 (high asserted) 4 Data 8 (high asserted) 5 Data 6 (high asserted) 6 Data 9 (high asserted) 7 Data 5 (high asserted) 8 Data 10 (high asserted) 9 D...

Pin assignment of internal ports A26361-D1761-Z120-1-6319 English - 15 Power supply ATX 1 11 Pin Signal Pin Signal 1 +3.3V(P3V3P) 11 +3.3V(P3V3P) 2 +3.3V(P3V3P) 12 -12V (P12VN) 3 GND 13 GND 4 +5V (VCC) 14 PS on (low asserted) 5 GND 15 GND 6 +5V (VCC) 16 GND 7 GND 17 GND 8 Powergood (high asserted) 1...

16 - English A26361-D1761-Z120-1-6319 Settings with switches and jumpers Setting via control-panel plug connector A C 12 12 B 12 Pin pair A inserted = Skipping system and BIOS Setup password Pin pair B inserted = System BIOS recovery Pin pair C inserted = factory setting i Please pay attention on th...

A26361-D1761-Z120-1-6319 English - 17 Add-on modules / Upgrading ! Exit energy-saving mode, switch off the system and remove the power plug from the mains outlet, before carrying out any of the procedures described in this chapter! Even when you have switched off the device, parts (e.g. memory modul...

Replacing processor 18 - English A26361-D1761-Z120-1-6319 Mounting heat sink Be sure to use heat conducting material between the processor and the heat sink. If a heat conducting pad (rubber-like foil) is already applied to the heat sink, then use it. Otherwise you must apply a very thin layer of he...

Upgrading main memory A26361-D1761-Z120-1-6319 English - 19 Upgrading main memory Technical data Technology: DDR 333 or DDR 400 unbuffered DIMM modules 184-Pin; 2.5 V; 64 Bit, without ECC Size: 128 Mbyte to 2 Gbyte 333 DDR-SDRAM 128 Mbyte to 2 Gbyte 400 DDR-SDRAM Granularity: 128, 256, 512 or 1024 M...

Upgrading AGP screen controllers A26361-D1761-Z120-1-6319 English - 21 Upgrading AGP screen controllers Technical data: The AGP slot supports the modes 4x/8x with 32 bits and 66 MHz. Only 1.5 V AGP graphics cards are supported. i Some older 3.3 V AGP graphics cards are coded like 1.5 V AGP graphics ...

Adding PCI cards 22 - English A26361-D1761-Z120-1-6319 Multifunctional expansion cards or expansion cards with integrated PCI-PCI bridge: These expansion cards require up to four PCI interrupts: INT A, INT B, INT C, INT D. How many and which of these interrupts are used is specified in the documenta...

Replacing the lithium battery A26361-D1761-Z120-1-6319 English - 23 Replacing the lithium battery In order to permanently save the system information, a lithium battery is installed to provide the CMOS-memory with a current. A corresponding error message notifies the user when the charge is too low ...

BIOS update 24 - English A26361-D1761-Z120-1-6319 BIOS update When should a BIOS update be carried out? Fujitsu Siemens Computers makes new BIOS versions available to ensure compatibility to new operating systems, new software or new hardware. In addition, new BIOS functions can also be integrated. ...

Microcode Update A26361-D1761-Z120-1-6319 English - 25 ► Close the casing as described in the operating manual. ► Remove the floppy disk from the drive. ► Start the PC and invoke BIOS Setup . ► Select the menu item Reset Configuration in the menu Advanced and change the setting to Yes . ► Save the c...

A26361-D1761-Z120-1-6319 English - 27 Annex Electrical Properties Loadability for connections and fuses i Make sure that the connected devices do not overload the connections. Fuse no. Fuse Connection Maximum loadability 1 750 mA Keyboard port Not specified Mouse port Not specified Gameport Not spec...

APM and ACPI system status, energy-saving modes 28 - English A26361-D1761-Z120-1-6319 APM and ACPI system status, energy-saving modes System status ACPI Status ) 1 APM Status Power LED I ) 2 Power LED II ) 3 Power consumptio n Wake-up time Normal operation G0 S0 On On/Off On Normal Simple energy- sa...

Mainboard Revision and BIOS Version A26361-D1761-Z120-1-6319 English - 29 Mainboard Revision and BIOS Version The compatibility, e.g. with new processors, can be independent of the BIOS version or the revision status of the mainboard used. Mainboard Revision The revision status of the mainboard exac...

30 - English A26361-D1761-Z120-1-6319 Error messages This chapter contains error messages generated by the mainboard. Available CPUs do not support the same bus frequency - System halted! Memory type mixing detected Non Fujitsu Siemens Memory Module detected - Warranty void There are more than 32 32...

34 - English A26361-D1761-Z120-1-6319 Glossary The technical terms and abbreviations given below represent only a selection of the full list of common technical terms and abbreviations. Not all technical terms and abbreviations listed here are valid for the described mainboard. ACPI Advanced Configu...