Page 3 - Contents
iii Contents Broadband ADSL2+ ModemSetup Manual Connecting the Modem to the Internet ................................................................................ 1 What’s in the Box? ............................................................................................................. 1 T...
Page 5 - Resource CD; The Bottom Label
Connecting the Modem to the Internet 1 Connecting the Modem to the Internet This chapter describes how to set up the modem on your Local Area Network (LAN) and connect to the Internet. It describes how to set up your modem for Internet access and configure basic wireless connectivity. What’s in the ...
Page 6 - The Front Panel; The modem front panel shown below contains status LEDs.
2 Connecting the Modem to the Internet The Front Panel The modem front panel shown below contains status LEDs. You can use the LEDs to verify various conditions. Table 1 describes each LED. Figure 2 Table 1. LED Descriptions Label Activity Description 1) Power Solid Green Power on. Off Power off. Re...
Page 8 - The Rear Panel; What You Need Before You Begin
4 Connecting the Modem to the Internet The Rear Panel The rear panel of the modem contains port connections. Viewed from left to right, the rear panel contains the following elements: 1. RJ-11 ADSL port for connecting the modem to an ADSL line 2. Factory Default Reset push button 3. Local Ethernet R...
Page 9 - Internet Configuration Requirements; Multiplexing Method; Installation Requirements
Connecting the Modem to the Internet 5 Internet Configuration Requirements Depending on how your ISP set up your Internet account, you need one or more of these configuration parameters to connect your modem to the Internet: • Virtual Path Identifier (VPI)/Virtual Channel Identifier (VCI) parameters...
Page 10 - Smart Wizard Setup
6 Connecting the Modem to the Internet Two Setup Methods: 1) Smart Wizard Setup 2) Manual Setup You have two methods available for setting up your modem:• Smart Wizard Setup : Use the Smart Wizard on the CD to assist you with setting up your modem. – This option is the easiest. The Smart Wizard on t...
Page 11 - Manual Setup; Use the topics and procedures below to manually set up your modem.; Understanding ADSL Microfilters; ADSL Microfilter
Connecting the Modem to the Internet 7 Manual Setup Use the topics and procedures below to manually set up your modem. Understanding ADSL Microfilters ADSL technology uses the same wires as your telephone service. However, ADSL adds signals to the telephone lines which create noise in the telephone ...
Page 12 - Computers Set to DHCP; Manually Setting Up Your Modem; There are four steps to setting up your modem:
8 Connecting the Modem to the Internet Computers Set to DHCP For the initial connection to your modem, your computer has to be set to automatically get its TCP/IP configuration from the modem via DHCP. This is usually the case. The NETGEAR Smart Wizard CD automatically takes care of this requirement...
Page 13 - Two-Line Filter Example; . Insert the two-line filter into the phone outlet and connect the
Connecting the Modem to the Internet 9 b. Two-Line Filter Example . Insert the two-line filter into the phone outlet and connect the phone to the phone line connector ( A) : 2. Connect the modem to the ADSL filter. a. Using the included phone cable with RJ-11 jacks, connect the ADSL port ( B) of the...
Page 14 - Connect the Ethernet cable from the modem LAN port (
10 Connecting the Modem to the Internet b. Connect the Ethernet cable from the modem LAN port ( D) to the Ethernet adapter in your computer. c. Now, turn on your computer. If software usually logs you in to your Internet connection, do not run that software. Cancel it if it starts automatically. d. ...
Page 15 - admin; “Preparing Your Network” on page 22
Connecting the Modem to the Internet 11 3. Log in to the modem. a. Type http://192.168.0.1 in the address field of a browser such as Internet Explorer. This login window opens: b. Enter admin for the user name and password for the password, both in lower case letters. Figure 10 Your computer needs t...
Page 16 - After logging in, the Setup Wizard screen displays.
12 Connecting the Modem to the Internet After logging in, the Setup Wizard screen displays. 4. Connect to the Internet You are now ready to configure your modem to connect to the Internet. There are two ways you can configure your modem to connect to the Internet: a. Let the modem Setup Wizard auto-...
Page 17 - Troubleshooting; Basic Functioning
Troubleshooting 13 Troubleshooting This chapter gives information about troubleshooting your Broadband ADSL2+ Modem DM111Pv2. After each problem description, instructions are provided to help you diagnose and solve the problem. For the common problems listed, go to the section indicated. • Is the mo...
Page 18 - Power LED Not On; If the Power and other LEDs are off when your modem is turned on:; Power LED Never Turns Green; Cycle the power to see if the modem recovers.; ADSL LED not On or Blinking
14 Troubleshooting c. The ADSL port LED is lit, indicating that your modem is synchronized to your ISP’s DSLAM. d. The Internet LED is lit to indicate that you have an Internet connection. If any of these conditions does not occur, refer to the appropriate following section. Power LED Not On If the ...
Page 19 - Log in to the modem interface and select; ADSL Settings; from the Setup section of the main; LAN or Internet Port LEDs Not On
Troubleshooting 15 If you have just installed the modem and the ADSL LED has never been solid on, check the following: • Disconnect all telephones on the line. If this solves the problem, reconnect the telephones one at a time, being careful to use a microfilter on each telephone. If the microfilter...
Page 20 - User Manual; Troubleshooting the Web Management Interface; “Preparing Your Network” on; Refresh
16 Troubleshooting • If the LAN port is lit, but the Internet port is not, log in to the modem interface, note the modem and ADSL status, run the diagnostics test, and contact your ISP’s technical support representative. See the User Manual for detailed information. Troubleshooting the Web Managemen...
Page 21 - Apply; Troubleshooting the Internet Connection; “Log in to; Modem Status; “Troubleshooting PPPoE or PPPoA” on page 18
Troubleshooting 17 If the modem does not save changes you have made in the Web Management Interface, check the following: • When entering configuration settings, be sure to click the Apply button before moving to another menu or tab, or your changes are lost. • Click the Refresh or Reload button in ...
Page 22 - Troubleshooting PPPoE or PPPoA; Diagnostics; Troubleshooting Internet Browsing
18 Troubleshooting Troubleshooting PPPoE or PPPoA The PPPoA or PPPoA connection can be debugged as follows: 1. Access the Main Menu of the modem at http://192.168.0.1 . 2. Under the Maintenance heading, select the Diagnostics . 3. Click Run Diagnostic Tests . 4. If all of the steps indicate “OK” the...
Page 23 - Restoring the Default Configuration and Password; password; Use the Erase function of the Web Management Interface.; Using the Reset Button; Release the Default Reset button and wait for the modem to reboot.
Troubleshooting 19 Restoring the Default Configuration and Password This section explains how to restore the factory default configuration settings, changing the modem’s administration password to password and the IP address to 192.168.0.1. You can erase the current configuration and restore factory...
Page 24 - This appendix provides technical specifications for the modem.; General Specifications
Technical Specifications 20 Technical Specifications This appendix provides technical specifications for the modem. General Specifications Network Protocol and Standards Compatibility Data and Routing Protocols: TCP/IP (Optional)RIP-1 (Optional)RIP-2 (Optional)DHCP (Optional)PPPoE or PPPoARFC 1483/R...
Page 26 - Related Documents
Related Documents 22 Related Documents This appendix provides links to reference documents you can use to gain a more complete understanding of the technologies used in your NETGEAR product. Document Link TCP/IP Networking Basics http://documentation.netgear.com/reference/enu/tcpip/index.htm Prepari...
