Nady W1KU - Manual

6 Quick User Controls Guide HT-1KU Handheld Transmitter 23 30 31 32 25 27 28 29 26 IR H L RF 22 37 40 24 38 39 22. BATTERY COVER Unscrew to insert two AA alkaline batteries 23. MIC BALL Windscreen 2 4. LCD DISPLAY For indication of GRP (00-09)/CH (00-99), INPUT AUDIO LEVEL, and BATTERY status (1 bar...

Buttons Function The Power Button (12) is used to turn the receiver on or off. When the button is pressed, the lit blue backlight on the lCD Display (2) indicates the receiver is on. Press the Power button again to turn off the receiver. The backlight on the LCD will turn off indicating the receiver...

9 Installing antennas Install antennas by connecting the two antennas (19) included with your system to the two rF Connectors (18) located on the back of your W-1KU receiver. The optimal positions of the antennas are 45 degrees from the receiver and 90 degrees from each other. For maximum range, it ...

At maximum receiver volume setting, as indicated by the Volume display, the system output is approximately +4dB higher than a direct cord-to-amp connection. Note: As when making any connection, make sure the amplifier or mixing board volume is at the minimum level before plugging in the receiver to ...

11 a radio signal on the same channel as the receiver. The Signal Strength and Diversity Indicators on the receiver’s LCD display will then light up, indicating that the IR link is completed. If no action is taken during the three seconds of active data transfer, the receiver and the transmitter uni...

be on, indicating a received signal from the transmitter. Adjust the volume of the receiver per Connecting Audio Output . Note: Avoid acoustic feedback (howling or screeching) by taking care in selecting PA volume, transmitter location and speaker placement. Note: The RF Signal meter and the Diversi...

13 more at three seconds, indicating that the IR transmission is over. Upon successful data transfer (usually in less than two seconds) the transmitter’s backlight will light up and the transmitter will transmit a radio signal on the same channel as the receiver. The Signal Strength and Diversity In...

15 Specifications SYSTeM OVerall SPeCIFICaTIOnS Operating Frequency range 672MHz-697MHz (US) Freq. Synthesized (1000 channels switchable) 25kHz/step Pll system frequency stability <0.005% Frequency response 30Hz-18kHz +/-3dB Dynamic range 120dB Harmonic Distortion <0.5% Modulation FM (F3E) +/-...

16 Cautions and Troubleshooting Feedback Avoid acoustic feedback (howling or screeching) by taking care in selecting PA volume, transmitter location and speaker placement. Please also note the pickup pattern characteristics of the microphone selected. Unidirectional mics are more resistant to feedba...

17 Miscellaneous Tips For optimum operation with external • antennas, low loss RF shielded cable should be used and the length of the cable should not exceed 10’ (3 m).The receiver antennas should be kept • away from any metal surfaces whenever possible as they can reflect away or shield the incomin...

18 Frequency Frequency Plan Band 1: 672.000-696.975MHz 25KHz per step (1000 Channels) U.S. Accessories Part number Description IC-U1K Instrument cable included for BT-1KU/GT transmitter, 3.5mm locking mini plug to 1⁄4” AC-W1KU 15-18VDC/400mA AC/DC receiver power supply adapter included RMK-1KUS Sing...

19 One Year Limited Warranty Nady Systems, Inc. warrants to the original consumer purchaser that the unit is free from any defects in material or workmanship for a period of one year from the date of original retail purchase. If any such defect is discovered within the warranty period, Nady Systems,...