Page 2 - I. GENERAL OPERATION; SAFETY RULES; Safe Operation Practices for Ride-On Mowers; con nect spark plug wire; WARNING
2 I. GENERAL OPERATION • Read, understand, and follow all instructions on the machine and in the manual before starting. • Do not put hands or feet near rotating parts or under the machine. Keep clear of the discharge opening at all times. • Only allow responsible adults, who are familiar with the i...
Page 3 - SAFE HANDLING OF GASOLINE
3 • Be sure the area is clear of bystanders before operat- ing. Stop machine if anyone enters the area. • Never carry passengers.• Do not mow in reverse unless absolutely necessary. Al ways look down and behind before and while back-ing. • Never carry children, even with the blades shut off. They ma...
Page 4 - TABLE OF CONTENTS; CONGRATULATIONS; CUSTOMER RESPONSIBILITIES; PRODUCT SPECIFICATIONS
4 TABLE OF CONTENTS SAFETY RULES ......................................................... 2-3PRODUCT SPECIFICATIONS ....................................... 4CUSTOMER RESPONSIBILITIES ................................. 4ASSEMBLY ................................................................. 6-8OPE...
Page 5 - CONTENTS OF HARDWARE PACK; Steering Wheel
5 CONTENTS OF HARDWARE PACK Steering Wheel Steering Wheel Insert (1) Large Flat Washer Steering Boot Steering Wheel Adapter Seat (2) Keys Slope Sheet Key (1) Oil Drain Tube (1) Washer 17/32 x 1-3/16 x 12 Gauge (1) Hex Bolt 5/16-18 x 4 (1) 5/16 Lock Washer Steering Extension Shaft (1) Bolt
Page 6 - ASSEMBLY; TOOLS REQUIRED FOR ASSEMBLY; UNPACK CARTON; ASSEMBLE EXTENSION SHAFT AND BOOT
6 ASSEMBLY TOOLS REQUIRED FOR ASSEMBLY A socket wrench set will make assembly easier. Stan dard wrench sizes are listed. (1) 1/2" wrench Utility knife (2) 3/4" wrench Tire pres sure gauge Pliers When right or left hand is mentioned in this man ual, it means when you are in the operating po s...
Page 8 - CHECK TIRE PRESSURE; CHECKLIST
8 ASSEMBLY CHECK TIRE PRESSURE The tires on your tractor were overinfl ated at the factory for shipping purposes. Correct tire pressure is important for best cutting performance.• Reduce tire pressure to PSI shown on tires. CHECK DECK LEVELNESS For best cutting results, mower housing should be prope...
Page 9 - OPERATION
9 OPERATION These symbols may appear on your tractor or in literature supplied with the product. Learn and understand their mean-ing. DANGER, KEEP HANDS AND FEET AWAY FREE WHEEL (Automatic Models only) KEEP AREA CLEAR SLOPE HAZARDS 15 15 (SEE SAFETY RULES SECTION) BATTERY REVERSE FORWARD FAST SLOW E...
Page 10 - KNOW YOUR TRACTOR
10 02829 OPERATION KNOW YOUR TRACTOR READ THIS OWNER'S MANUAL AND SAFETY RULES BEFORE OPERATING YOUR TRACTOR Compare the illustrations with your tractor to familiarize yourself with the locations of various controls and ad just ments. Save this manual for future reference. ATTACHMENT CLUTCH LEVER - ...
Page 11 - HOW TO USE YOUR TRACTOR
11 NOTE: Under certain conditions when tractor is standing idle with the engine running, hot engine exhaust gases may cause “brown ing” of grass. To eliminate this possibility, al-ways stop engine when stopping tractor on grass areas. CAUTION: Always stop tractor com- plete ly, as described above, b...
Page 12 - TO OPERATE ON HILLS; TO TRANSPORT; NOTE; TOW I N G C A RT S A N D OT H E R AT; Do not mow in reverse unless
12 TO OPERATE ON HILLS WARNING: Do not drive up or down hills with slopes great er than 15° and do not drive across any slope. • Choose the slowest speed before starting up or down hills. • Avoid stopping or changing speed on hills.• If stopping is absolutely necessary, push clutch/brake pedal quick...
Page 13 - ADD GASOLINE; BEFORE STARTING THE ENGINE; CHECK ENGINE OIL LEVEL
13 OPERATION TO START ENGINE (See Fig. 4) When starting the engine for the fi rst time or if the engine has run out of fuel, it will take extra cranking time to move fuel from the tank to the engine.• Sit on seat in operating position, depress clutch/brake pedal and set parking brake. • Place gear s...
Page 14 - MOWING TIPS
14 MOWING TIPS • Mower should be properly leveled for best mowing per- for mance. See "TO LEVEL MOWER HOUSING" in the Service and Adjustments section of this manual. • The left hand side of mower should be used for trim- ming. • Drive so that clippings are discharged onto the area that has b...
Page 15 - LUBRICATION CHART; MAINTENANCE; GENERAL RECOMMENDATIONS; BEFORE EACH USE
15 MAINTENANCE LUBRICATION CHART d SPINDLE ZERK d FRONT WHEEL BEARING ZERK c SAE 30 OR 10W30 MOTOR OIL d GENERAL PURPOSE GREASE e REFER TO MAINTENANCE “ENGINE” SECTION IMPORTANT: DO NOT OIL OR GREASE THE PIVOT POINTS WHICH HAVE SPECIAL NYLON BEARINGS. VISCOUS LU BRI CANTS WILL ATTRACT DUST AND DIRT ...
Page 16 - TRACTOR; BRAKE OPERATION
16 MAINTENANCE FIG. 8 TO SHARPEN BLADE (See Fig. 9) NOTE: We do not recommend sharpening blade - but if you do, be sure the blade is balanced. Care should be taken to keep the blade balanced. An un- bal anced blade will cause excessive vibration and even tual dam age to mower and engine.• The blade ...
Page 17 - BATTERY; TRANSAXLE COOLING; ENGINE; LUBRICATION
17 FIG. 9 BATTERY Your tractor has a battery charging system which is suf fi cient for normal use. However, periodic charging of the battery with an automotive charger will extend its life.• Keep battery and terminals clean.• Keep battery bolts tight.• Keep small vent holes open.• Recharge at 6-10 a...
Page 18 - CLEANING; AIR FILTER
18 MAINTENANCE CLEANING • Clean engine, battery, seat, fi nish, etc. of all foreign matter. • Keep fi nished surfaces and wheels free of all gasoline, oil, etc. • Protect painted surfaces with automotive type wax. We do not recommend using a garden hose or pressure washer to clean your tractor unles...
Page 19 - SERVICE AND ADJUSTMENTS
19 SERVICE AND ADJUSTMENTS WARNING: TO AVOID SE RI OUS IN JU RY, BEFORE PERFORMING ANY SERVICE OR ADJUST- MENTS: • Depress clutch/brake pedal fully and set parking brake. • Place gearshift lever in neutral (N) position. • Place attachment clutch in “DISENGAGED” position. • Turn ignition key to “STOP...
Page 20 - TO LEVEL MOWER HOUSING
20 TO REPLACE MOWER BLADE DRIVE BELT (See Fig. 18) The mower blade drive belt may be replaced without tools. Park the tractor on level surface. Engage parking brake. BELT REMOVAL -• Remove mower from tractor (See “TO REMOVE MOW ER” in this section of this manual). • Work belt off both mandrel pulley...
Page 21 - TO CHECK AND ADJUST BRAKE
21 SERVICE AND ADJUSTMENTS FIG. 18 FIG. 20 TO REPLACE MOTION DRIVE BELT (See Fig. 20) Park the tractor on level surface. En gage parking brake. For as sis tance, there is a belt installation guide decal on bottom side of left footrest. BELT REMOVAL -• Remove mower (See “TO RE MOVE MOWER” in this sec...
Page 24 - STORAGE; FUEL SYSTEM; ENGINE OIL; OTHER
24 STORAGE Immediately prepare your tractor for storage at the end of the season or if the tractor will not be used for 30 days or more. WARNING: Never store the trac tor with gas o line in the tank inside a building where fumes may reach an open fl ame or spark. Allow the engine to cool before stor...
Page 25 - TROUBLESHOOTING POINTS; PROBLEM
25 TROUBLESHOOTING POINTS Will not start 1. Out of fuel. 1. Fill fuel tank. 2. Engine not “CHOKED” properly. 2. See “TO START ENGINE” in Operation section. 3. Engine fl ooded. 3. Wait several minutes before attempting to start. 4. Bad spark plug. 4. Replace spark plug. 5. Dirty air fi lter. 5. Clean...
Page 27 - LIMITED WARRANTY
27 LIMITED WARRANTY The Manufacturer warrants to the original consumer purchaser that this product as manufactured is free from defects in materi-als and work man ship. For a period of two (2) years from date of purchase by the original consumer purchaser, we will repair or replace, at our option, w...
Page 28 - SUGGESTED GUIDE FOR SIGHTING SLOPES FOR SAFE OPERATION
15 DEGREES MAX. FOLD ALO NG DO TTED LINE THIS IS A 15 DEG REE SLO PE ONLY RIDE UP AND DOWN HILL,NOT ACROSS HILL SUGGESTED GUIDE FOR SIGHTING SLOPES FOR SAFE OPERATION WARNING: To avoid serious injury, operate your tractor up and down the face of slopes, never across the face. Do not mowslopes greate...
