MSI K9NGM4 Series- User Manual
MSI K9NGM4 Series– User Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – PDF created with pdfFactory Pro trial version
- Page 3 – Safety Instructions
- Page 4 – INTRODUCTION; Layout
- Page 5 – SPECIFICATIONS
- Page 6 – Floppy; Connectors; Slots; Form Factor
- Page 7 – REAR PANEL; CPU Installation Procedures for Socket AM2
- Page 8 – Installing AMD Socket AM2 CPU Cooler Set; Installing Memory Modules
- Page 9 – ATX 12V Power Connector: JPW1; Floppy Disk Drive Connector: FDD1
- Page 10 – Chassis Intrusion Connector: JCI1
- Page 11 – Front Panel Audio Connector: JAUD1; TPM Module connector: JTPM1; Clear CMOS Jumper: JBAT1; PCI (Peripheral Component Interconnect) Express Slot
- Page 13 – BIOS Setup; Main Page
- Page 14 – Cell Menu
- Page 16 – Load Optimized Defaults
FCC-B Radio Frequency Interference Statement
This equipment has been tested and f ound to comply with the limits for a class B digital
device, pursuant to part 15 of the FCC rules. These limits are designed to provide
reasonable protection against harmful interf erence in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instruction manual, may cause harmful interf erence to radio
communications. However, there is no guarantee that interf erence will occur in a particular
installation. If this equipment does cause harmful interf erence to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interf erence by one or more of the measures listed below.
n
Reorient or relocate the receiving antenna.
n
Increase the separation between the equipment and receiver.
n
Connect the equipment into an outlet on a circuit diff erent from that to which the
receiver is connected.
n
Consult the dealer or an experienced radio/ television technician f or help.
Notice 1
The changes or modifications not expressly approved by the party responsible f or
compliance could void the user
’
s authority to operate the equipment.
Notice 2
Shielded interf ace cables and A.C. power cord, if any, must be used in order to comply with
the emission limits.
VOIR LA NOTICE D
’
NSTALLATION AVANT DE RACCORDER AU RESEAU.
Micro-Star International
MS-7506
G52-75061X1
PDF created with pdfFactory Pro trial version
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Copyright Notice The material in this document is the intellectual property of MICRO-STAR INTERNATIONAL. W e take every care in the preparation of this document, but no guarantee is given as to the correctness of its contents. Our products are under continual improvement and we reserve the right to ...
Safety Instructions n Always read the saf ety instructions carefully. n Keep this User Manual f or future ref erence. n Keep this equipment away from humidity. n Lay this equipment on a reliable flat surf ace bef ore setting it up. n The openings on the enclosure are f or air convection hence protec...
1 INTRODUCTION Thank you f or choosing the K9NGM4 Series (MS-7506 V1.X) Micro-ATX mainboard. The K9NGM4 Series is design based on NVIDIA ® MCP68S / MCP68PVNT single chipset f or optimal system efficiency. Designed to fit the advanced AMD ® Socket AM2 Athlon TM 64, Athlon TM 64 X2 and Sempron TM proc...
-User-Manual/webp/1.webp){kind=small}
-OC-Guide-User-Manual/webp/1.webp){kind=small}