Moxa TN-5308 - Manual
Moxa TN-5308 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 7 – Wiring Requirements
- Page 8 – Connecting the Power Supply
- Page 9 – Connecting the Data Lines; Cross-Over Cable Wiring
Moxa ToughNet Switch
TN-5308 Series
Layer 2 M12 unmanaged Ethernet switches
Hardware Installation Guide
First Edition, May 2009
©
2009 Moxa Inc. All rights reserved.
Reproduction without permission is prohibited.
P/N: 1802053080010
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
— 6 — Wiring Requirements WARNING Turn the power off before disconnecting modules or wires. The correct power supply voltage is listed on the product label. Check the voltage of your power source to make sure you are using the correct voltage. Do NOT use a voltage greater than what is specified on t...
— 7 — ATTENTION This product is intended to be mounted to a well-grounded mounting surface such as a metal panel. Connecting the Power Supply The M12/M23 A-coded 5-pin male connector on the TN-5308-LV/MV front panel is used for the DC power input. You have to prepare a power cord with M12/M23 A-code...
— 8 — Connecting the Data Lines 10/100BaseT(X) Ethernet Port Connection All TN-5308 models have 8 10/100BaseT(X) Ethernet ports (4-pin shielded M12 connectors with D coding). The 10/100TX ports located on the TN-5308’s front panel are used to connect to Ethernet-enabled devices. Most users configure...
