Monte Carlo 4CO28 - Manual

Monte Carlo 4CO28

Monte Carlo 4CO28 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
Page: / 5

Table of Contents:

  • Page 2 – OBSERVE THE FOLLOWING: READ AND SAVE THESE INSTRUCTIONS; AFETY; TOOLS REQUIRED; Phillips Screwdriver Wire Cutters Pliers Step Ladder; Tighten the 2 Set screws on the Yoke; Installation
  • Page 3 – FFlluusshh M; House
  • Page 4 – Install switch cap to fan using the 3
  • Page 5 – ROUBLE; Customer Service Center at the; be locked, securely fasten a; Customer Service Center:; Trouble
Loading the manual

Q

UALITY

C

EILING FANS

Ceiling Fan Installation Instructions

For 4CO28 Series Fans

READ AND SAVE THESE INSTRUCTIONS

Total fan weight

O

WNER

S

M

ANUAL

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 2 - OBSERVE THE FOLLOWING: READ AND SAVE THESE INSTRUCTIONS; AFETY; TOOLS REQUIRED; Phillips Screwdriver Wire Cutters Pliers Step Ladder; Tighten the 2 Set screws on the Yoke; Installation

Installation work and electrical wiring must be done by qualified person(s) in accordance with applicable codes ANSI/NFPA 70-1999), including fire-rated construction. Use this unit only in the manner intended by the manufacturer. If you have any questions contact the manufacturer. After making the w...

Page 3 - FFlluusshh M; House

Hang fan from mounting bracket by the hands free hook into a closed hole on the edge of the Canopy. Note: For Canadian mounting refer to Step #8. For Canadian installation in both flush and down- rod mode the safety cable must be installed into the house structure beams using the 3” lag screws provi...

Page 4 - Install switch cap to fan using the 3

Place blade holders onto blades aligning holes in blade holder with holes in blade. Make sure that the side of the blade you select is facing downward. Install 3 screws and fiber wash- ers to back side of blade as shown. Tighten screws securely. Repeat this process 3 more times until all blades are ...

Other Monte Carlo Models

All Monte Carlo Other