Monessen TPB24 - Manual

Table of Contents:

• Page 2 – CONTENTS
• Page 3 – IMPORTANT SAFETY INFORMATION; Please leave these instructions with the appliance.; CARBON MONOXIDE POISONING:; ARNING
• Page 4 – MASSACHUSSETTS RESIDENTS ONLY:
• Page 5 – MAKE SURE YOU HAVE RECEIVED ALL PARTS:; CAUTION; WHAT YOU WILL NEED FOR INSTALLATION:; GETTING STARTED
• Page 6 – PRODUCT FEATURES; SPECIFICATIONS; NATURAL GAS; natural gas systems operating at higher pressure.; IGNITION CONTROLS; OFF; - All gas to the gas logs is shut off at the valve.; IGN; THERMAL GENERATOR
• Page 7 – GENERAL INSTALLATION INFORMATION; CODES; or; National Fire Protection Association, Inc.; Batterymarch Park; ADEQUATE COMBUSTION AND VENTILATION AIR; , defines a confined space as a space whose volume is less than 50; UNUSUALLY TIGHT CONSTRUCTION IS DEFINED AS CONSTRUCTION WHERE...; ) or less with openings gasketed or sealed
• Page 8 – Figure 1 - Example of a Large Room with 1/2 Wall Divider
• Page 9 – FIREPLACE AND HEARTH DIMENSIONS; Figure 2 - Hearth Minimum Dimension
• Page 10 – PLACEMENT IN A FIREPLACE WITH A RESTRICTIVE BARRIER; IMPORTANT INFORMATION FOR THE INSTALLATION OF THIS GAS LOG SET; fully
• Page 11 – CLEARANCES; HEIGHT REQUIREMENTS; Sidewall and ceiling clearances:; sides
• Page 12 – be at least 1/2” thick. Sheet metal should not be installed onto; Refer to “Installing Vented Applications” found on page 18.; CLEARANCES and HEIGHT REQUIREMENTS
• Page 13 – Figure 6 - Measuring Heat Resistant Material for Mantel
• Page 14 – Figure 8 - Minimum Mantel Clearance with Hood - All Models
• Page 15 – Figure 9 - Minimum Mantel Clearance with No Hood — TPB24/30; The bottom of the mantel may project from the wall a maxi-; Figure 10 is an example of an unsafe mantel installation.; OR; • Remove the mantel
• Page 16 – FLOOR CLEARANCE; The gas log heater must be installed at least 1; Figure 11 - Minimum Clearance above Combustible Flooring
• Page 17 – FIREPLACE PREPARATION; BEFORE FULLY INSTALLING THE UNIT:; • Turn; the gas supply to the fireplace or firebox.; Do not seal the chimney flue damper.; INSTALLING VENTED APPLICATIONS; rial and minimum mantel requirements do not apply.; this cleaning performed annually after installation.; DAMPER STOP INSTALLATION:; to prevent full closure
• Page 18 – PLACING AND SECURING APPLIANCE; fireplace or firebox.
• Page 19 – CONNECTING THE GAS; Figure 15 - Gas Connection
• Page 20 – CHECKING GAS PRESSURE; The heater gas inlet connection is a; MILLI-VOLT VALVE CONTROL; Figure 16 - Pressure Test Point Location
• Page 21 – The milli-volt valve is a self-powered combination gas control; THAT DOES NOT REQUIRE 110 VAC TO OPER-; Figure 17 - Wiring Diagram
• Page 22 – CONNECTING REMOTE RECEIVER; Figure 18 - Installing Remote Receiver; B. Thermopile Output Reading Check; NOTICE
• Page 23 – LOG PLACEMENT; Before you begin; After handling the logs, wash your hands gently with; Figure 20 - Installing Right Base
• Page 24 – Left Base Log
• Page 25 – Left Top Log
• Page 26 – PLACING ROCK WOOL; See Figure 26; provided with log set.; Pins
• Page 27 – RISER AND STEEL BAR GRATE INSTALLATION; OPTIONAL RISER INSTALLATION; Figure 27 - Placing Burner on Riser; STEEL BAR GRATE INSTALLATION; Figure 29 - Installing Steel Bar Grate
• Page 28 – CAST IRON GRATE INSTALLATION; OPTIONAL CAST IRON GRATE AND ANDIRON INSTALLATION; ANDIRON INSTALLATION
• Page 29 – PLACING THE DECORATIVE ROCK; FLAME APPEARANCE; periodically check the flames visually during operation.; CHECKING THE PILOT FLAME; It should just touch the top of the ther-; MILLI-VOLT CONTROL AND THERMOSTAT CONTROL; Figure 33 - Correct Appearance of Pilot Flame
• Page 30 – OPERATING INSTRUCTIONS; Avoid any drafts that alter burner fl ame patterns.; Do not allow fans to blow directly into the fireplace. Do not place; CHECKING THE BURNER FLAME
• Page 31 – Figure 36 - Location of Piezo Ignitor, Control Knobs and Switch; WHAT TO DO IF YOU SMELL GAS:; • Do not attempt to light any appliance.; FOR YOUR SAFETY READ BEFORE LIGHTING; Piezo
• Page 32 – NOTE: If you are running the heater for the fi rst time, it may be; MILLI-VOLT CONTROL LIGHTING INSTRUCTIONS; TO TURN OFF GAS TO HEATER
• Page 33 – CLEANING AND SERVICING; • External case should be dusted and wiped with a wet soapy cloth.; MATCH LIGHTING INSTRUCTIONS
• Page 34 – Note: All troubleshooting items are listed in order of operation.; TROUBLESHOOTING; OBSERVED PROBLEM POSSIBLE CAUSE
• Page 36 – BURNER ASSEMBLY
• Page 37 – REPLACEMENT PARTS LIST; REPLACEMENT PARTS ARE AVAILABLE THROUGH YOUR RETAILER.; CIGA; ACCESSORIES SOLD SEPARATELY
• Page 38 – CHARRED TIMBER LOGS
• Page 39 – NOTES
• Page 40 – MASSACHUSETTS RESIDENTS ONLY:
• Page 41 – SPECIAL REQUIREMENTS CONTINUED; “GAS VENT DIRECTLY BELOW. KEEP CLEAR OF ALL OBSTRUCTIONS.”; NFPA 54 as adopted by the Board and
• Page 42 – MONESSEN HEARTH SYSTEMS; LIMITED LIFETIME WARRANTY POLICY; LIFETIME WARRANTY