Monessen MJ27NR - Manual

Table of Contents:

• Page 2 – CONTENTS; Placement in a Fireplace
• Page 3 – IMPORTANT SAFETY INFORMATION; National Fuel; INSTALLER; CARBON MONOXIDE POISONING:; burns, explosion or carbon monoxide poisoning.; ARNING
• Page 4 – utility) gas wells. This gas is commonly; Massachussetts resiDents only:
• Page 5 – MAkE SuRE YOu hAvE RECEIvED ALL PARTS:; GETTING STARTED; G l o v e s a r e r e c o m m e n d e d w h e n; CAUTION; Do not attempt to install any part of the
• Page 6 – NATURAL GAS; Gas Inlet Pressure:; IGNITION CONTROLS; - All gas to the gas logs is shut off at the valve.; THERMAL GENERATOR; for remote activation.
• Page 7 – GENERAL INSTALLATION INFORMATION; CODES; or; National Fire Protection Association, Inc.; Batterymarch Park; ADEQUATE COMBUSTION AND VENTILATION AIR; , defines a confined space as a space whose; UNUSUALLY TIGHT CONSTRUCTION IS DEFINED AS CONSTRUCTION WHERE...
• Page 9 – or BUF; the minimum hearth dimensions shown below.; DO NOT install this appliance in a factory-built fireplace that
• Page 10 – PLACEMENT IN A FIREPLACE wITh A RESTRICTIvE BARRIER; IMPORTANT INFORMATION FOR ThE INSTALLATION OF ThIS GAS LOG SET; fully open; will extend the battery life.; Minimum Depth of Fireplace/Firebox; overheat and malfunction.; located outside the firebox.; NOTE
• Page 11 – CLEARANCES and HEIGHT REQUIREMENTS; Sidewall and ceiling clearances:; The; The dimensions shown in; Figures 4 through 11; and defined in the fireplace manufacturer's
• Page 12 – fireplace opening, measure the heat resistant material height,; be at least 1/2” thick. Sheet metal should not be; Hood not required
• Page 13 – resistant material shown in; Heat Resistant; shown on; OR
• Page 14 – A mantel may project from the wall a; mum; The bottom of the mantel may project
• Page 15 – Figure 9 is an example of an unsafe mantel instal-; • Remove the mantel
• Page 16 – FLOOR CLEARANCE; The gas log heater must be installed at least 1
• Page 17 – BEFORE INSTALLING ThE APPLIANCE:; prevent full closure of the fireplace damper blade; FIREPLACE PREPARATION; BEFORE FULLY INSTALLING THE UNIT:; the gas supply to the fireplace or firebox.; Do not seal the chimney flue; INSTALLING vENTED APPLICATIONS; Since, the gas logs are operated with the damper open,; gas logs. This log set may be installed as a vented log set.; Before installing in a solid fuel burning; a positive draft, contact your dealer for assistance.
• Page 18 – PLACING AND SECuRING APPLIANCE; inside the front edge of the fireplace or firebox.; controls during operation.; Screw
• Page 19 – CONNECTING THE GAS; only
• Page 20 – ChECkING GAS PRESSuRE; When tightening up the joint to the valve, hold the valve; MILLIVOLT VALVE CONTROL; turn captured screw clockwise firmly to re-seal. Do; DO NOT uSE AN OPEN FLAME.; C o n n e c t i n g d i r e c t l y t o a n
• Page 21 – The Millivolt valve is a self-powered combination gas control; ThAT DOES NOT REquIRE 110 vAC TO OPER; Label all wires prior to disconnection when servicing controls.
• Page 22 – CONNECTING REMOTE RECEIVER; A. COMPLETE MILLIvOLT SYSTEM ChECk; in wall or other location outside the fireplace.; NOTICE
• Page 23 – PLACE ROCk wOOL; in front of the rear deflector shield; LOG PLACEMENT; Before you begin; • Use only rock wool
• Page 24 – Place log #8 on right bracket next to
• Page 26 – PLACE FLICkERING EMBERS; Figure 28 - Place Flickering Bright Embers; third right tong on the grate as shown
• Page 27 – ANDIRON and ROCK INSTALLATION; ANDIRON INSTALLATION; Bolts; Assembly Instructions; Affix bracket to andiron using 2; PLACING ThE DECORATIvE ROCk; few hours to vent the odor.
• Page 28 – FLAME APPEARANCE; Figure 31 - Correct Appearance of Pilot Flame
• Page 29 – Burner will have a random pattern of yellow flames as shown in; OPERATING INSTRuCTIONS; Avoid any drafts that alter burner flame patterns.; Do not allow fans to blow directly into the; CHECKING THE BURNER FLAME
• Page 30 – WHAT TO DO IF YOU SMELL GAS:; • If you cannot reach your gas supplier, call the fire department.; FOR YOUR SAFETY READ BEFORE LIGHTING; If you do not follow these instruction
• Page 31 – should ignite in the Max. Height Setting.; Millivolt CONTROL LIGHTING INSTRUCTIONS; TO TURN OFF GAS TO HEATER; Turn control knob clockwise
• Page 32 – CLEANING AND SERVICING; recommended to prevent malfunction and/or sooting.; • Do not use cleaning fluid to clean logs or any part of heater.; Refer to parts diagram for location of items; brush or pipe cleaners.; Turn off heater and allow to cool before; soap and water. Refer to manual for correct log placement.; MATCH LIGHTING INSTRUCTIONS
• Page 33 – Note: All troubleshooting items are listed in order of operation.; TROUBLESHOOTING; OBSERvED PROBLEM POSSIBLE CAuSE; Turn appliance OFF and allow to cool before
• Page 34 – gas supplier immediately.; Burner backfires during
• Page 35 – Item Description; ODS Pilot Assembly; REPLACEMENT PARTS; failure to use only parts specifically
• Page 36 – LOGS; REPLACEMENT PARTS LIST; REPLACEMENT PARTS ARE AVAILABLE THROUGH YOUR RETAILER.; F a i l u r e t o p o s i t i o n t h e p a r t s i n
• Page 37 – MASSAChUSETTS RESIDENTS ONly:
• Page 38 – NOTES
• Page 39 – LIMITED LIFETIME wARRANTY POLICY; LIFETIME WARRANTY; Vent Free Ceramic Fiber Logs and Aluminized Burners.; BASIC WARRANTY; warranty repair must be accompanied by a dated proof of purchase.
• Page 40 – MHSC