Monessen DEB20 - Manual

Table of Contents:

• Page 2 – CONTENTS; Placement in a Fireplace with; Control
• Page 3 – IMPORTANT SAFETY INFORMATION; Vented; Please leave these instructions with the appliance.; CARBON MONOXIDE POISONING:; ARNING
• Page 5 – MAKE SURE YOU HAVE RECEIVED ALL PARTS:; GETTING STARTED; Do not attempt to install any part of the appliance unless you; from loose fi bers. Logs are fragile — handle with care.; CAUTION
• Page 6 – PRODUCT FEATURES; SPECIFICATIONS; NATURAL GAS; natural gas systems operating at higher pressure.; Gas Inlet Pressure: 10; Manual Pressure
• Page 7 – IGNITION CONTROLS; - All gas to the gas logs is shut off at the valve.; - Variable position corresponding to desired flame height.; - All gas to the gas logs is shut off at the valve.; IGN; THERMAL GENERATOR
• Page 8 – GENERAL INSTALLATION INFORMATION; CODES; or; National Fire Protection Association, Inc.; Batterymarch Park; ADEQUATE COMBUSTION AND VENTILATION AIR; , defines a confined space as a space whose volume is less than 50; UNUSUALLY TIGHT CONSTRUCTION IS DEFINED AS CONSTRUCTION WHERE...; ) or less with openings gasketed or sealed
• Page 9 – Figure 1 - Example of a Large Room with 1/2 Wall Divider
• Page 10 – Model; FIREPLACE AND HEARTH DIMENSIONS; Figure 2 - Hearth Minimum Dimension
• Page 11 – Minimum Depth of Fireplace/Firebox; PLACEMENT IN A FIREPLACE WITH A RESTRICTIVE BARRIER; IMPORTANT INFORMATION FOR THE INSTALLATION OF THIS GAS LOG SET; fully; RNING
• Page 12 – CLEARANCES; HEIGHT REQUIREMENTS; Sidewall and ceiling clearances:; sides
• Page 13 – be at least 1/2” thick. Sheet metal should not be installed; Refer to “Installing Vented Applications” found on page 18.; CLEARANCES and HEIGHT REQUIREMENTS
• Page 14 – Figure 6 - Measuring Heat Resistant Material for Mantel
• Page 15 – HEIGHT REQUIRMENTS; Figure 8 - Minimum Mantel Clearance with Hood - All Models
• Page 16 – The bottom of the mantel may project from the wall a; Figure 10 is an example of an unsafe mantel installation.; • Remove the mantel
• Page 17 – FLOOR CLEARANCE; Figure 11 - Minimum Clearance above Combustible Flooring
• Page 18 – FIREPLACE PREPARATION; BEFORE FULLY INSTALLING THE UNIT:; • Turn; the gas supply to the fireplace or firebox.; Do not seal the chimney flue damper.; INSTALLING VENTED APPLICATIONS; rial and minimum mantel requirements do not apply.; Have this cleaning performed annually after installation.; Install and operate the appliance as directed in this manual.; to prevent full closure
• Page 19 – PLACING AND SECURING APPLIANCE; fireplace or firebox.
• Page 20 – CONNECTING THE GAS; Figure 15 - Gas Connection
• Page 21 – CHECKING GAS PRESSURE; The heater gas inlet connection is a; MANUAL CONTROL; If the pressure is not as specified,; DO NOT USE AN OPEN FLAME.; Test Port “OUT”
• Page 22 – The milli-volt valve is a self-powered combination gas control; THAT DOES NOT REQUIRE 110 VAC TO OPER-; Figure 18 - Wiring Diagram
• Page 23 – CONNECTING REMOTE RECEIVER; Do not let the wire touch the grate
• Page 25 – OPERATION OF THERMOSTAT SENSOR; how often the unit cycles by turning the control knob on the sensor.
• Page 26 – LOG PLACEMENT; INSTALLING LOGS ON GRATE (See Figures 25 and 26 ); Before you begin; After handling the logs, wash your hands gently; Rest
• Page 27 – PLACING THE DECORATIVE ROCK; CHECKING THE PILOT FLAME; It should just touch the top of the ther-; Figure 29 - Correct Appearance of Pilot Flame
• Page 28 – OPERATING INSTRUCTIONS; Avoid any drafts that alter burner fl ame patterns.; Do not allow fans to blow directly into the fireplace. Do not place; CHECKING THE BURNER FLAME; Glowing Embers
• Page 29 – WHAT TO DO IF YOU SMELL GAS:; • Do not attempt to light any appliance.; Piezo; FOR YOUR SAFETY READ BEFORE LIGHTING
• Page 30 – Figure 33 - IGN Position; Refer to Figure 32, page 29; MANUAL CONTROL LIGHTING INSTRUCTIONS; TO TURN OFF GAS TO HEATER
• Page 31 – NOTE: If you are running the heater for the fi rst time, it may be; LIGHTING INSTRUCTIONS; Figure 37 - Control Cover Plate for Milli-Volt
• Page 32 – CLEANING AND SERVICING; • External case should be dusted and wiped with a wet soapy cloth.; MATCH LIGHTING INSTRUCTIONS
• Page 33 – OBSERVED PROBLEM; POSSIBLE CAUSE; Note: All troubleshooting items are listed in order of operation.; TROUBLESHOOTING
• Page 35 – BURNER ASSEMBLY
• Page 36 – REPLACEMENT PARTS LIST; REPLACEMENT PARTS ARE AVAILABLE THROUGH YOUR RETAILER.
• Page 37 – LOGS
• Page 38 – NOTES; NOTE REGARDING VENTED PRODUCTS; MASSACHUSETTS RESIDENTS ONLY:
• Page 39 – SPECIAL REQUIREMENTS CONTINUED; “GAS VENT DIRECTLY BELOW. KEEP CLEAR OF ALL OBSTRUCTIONS.”; NFPA 54 as adopted by the Board and
• Page 40 – MONESSEN HEARTH SYSTEMS; LIMITED LIFETIME WARRANTY POLICY; LIFETIME WARRANTY