Mitsubishi X30- User Manual
Mitsubishi X30– User Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – interrupt vector addresses must be set to a ‘dummy_int’ label.
- Page 3 – all
- Page 7 – DB9 connector and to the PC RS-232 port.
- Page 9 – Click on the Erase button to erase the Flash ROM.
- Page 10 – Remove power on the SK board and remove the CNVss jumper.; KD30 Debugging; Go to TM Project Bar and click the Debug button.
- Page 13 – d. Click the OK button. LMC30 will now be created in the TM Project Bar.; Writing the Target Program to M16C/62 Flash in the SK Board; type all “00” on the ID field. Click the OK button.
www.m16canz.com
1
MITSUBISHI M16C/62 MCU
STARTER KIT BOARD
(MSA0654-MEAUST)
INSTALLATION PROCEDURE
Version 2.0
06-Jun-02
Prepared by Alan Suyko
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
www.m16canz.com 2 I. SOFTWARE TOOL VERSIONS: C Compiler: NC30WA Version 5.00 Release 1 or later Integrated Development Environment: Tool Manager Version 3.11 or later Debugger: KD30 Version 3.00 Release 1 or later Monitor Program: Version 2.00 or later Flash programmer: Flash Start Version 1.0.0.7 o...
www.m16canz.com 3 III. PROJECT CREATION PROCEDURE: 1. Run Tool Manager 3.11 (TM Project Bar). Create a new project by clicking the New Project button in the Project Bar. This will launch the Project Editor and Project Editor wizard. • PE Wizard Step 1: Select the Target chip (choose M16C Family) and...
www.m16canz.com 7 Flash Start Setup 1. Register Flash Start in Tool Manager by clicking the Tool Register button. 2. Select the Application tab and fill in the Name and File Path fields. 3. Click the OK button. Flash Start will now be available from the TM Project Bar. Monitor Program Installation 1...
