Mitsubishi SRK20ZJ-S- User Manual

– 4 – Name of each part and its function INDOOR UNIT Air filter Removes dust or dirt from the inlet air. Page 17 Air Inlet panel Draws the indoor air. Page 17 Drain hose Drains water from the indoor unit. Left/right airflow direction adjustment louver Page 10 Up/down airflow direction adjustment fla...

– 5 – Unit display section 3D AUTO light (green) Illuminates during 3D AUTO operation. HI POWER light (green) Illuminates during HIGH POWER operation. TIMER light (yellow) Illuminates during TIMER operation. This button can be used for turning on/off the unit when remotecontrol is not available. Pag...

– 6 – Remote control handling Replacing the batteries The following cases signify exhausted batteries. Replace old batteries with new ones. • Receiving beep is not emitted when a signal is transmitted. • Display fades away. NOTE • Do not use old and new batteries together. • Remove the batteries whe...

– 7 – Operation section FAN SPEED button Each time the button is pressed, the display is switched over in turn. • The above illustration shows all controls, but in practiceonly the relevant parts are shown. OPERATION MODE select button Each time the button pressed, the display is switched over in tu...

– 8 – AUTO HI MED LO • When changing FAN SPEED from HI to LO, the sound ofrefrigerant flowing may be heard. NOTE Temperature adjustment during AUTO ■ Air temperature adjustment is possible even during automatic operation. There are 6 levels of adjustment possible with the button or the button. Durin...

– 9 – COOL/HEAT/DRY/FAN mode operation Airflow direction adjustment procedure. Page 10 Point the remote control toward the air-conditioner, and Press the MODE select button. Move the [ mark] to the required operation position. (Cool), (Heat), (Dry), (Fan) Press the ON/OFF button. Press the TEMP butt...

– 10 – Airflow direction adjustment Adjusting airflow direction ■ Up/down direction can be adjusted with the AIRFLOW (UP/DOWN) button on the remote control. Every time you press this button the mode changes as follows:Change on AIRFLOW (UP/DOWN) mode. ■ Left/right direction can be adjusted with the ...

– 11 – ■ If it is pressed while the unit is off SLEEP TIMER operation starts with the previous operation settings, and the airconditioning is turned off after the set time elapses. ■ If it is pressed while the unit is running The air conditioner is turned off after the set time elapses.Every time th...

– 13 – ALLERGEN CLEAR operation Aim the remote control at the air-conditioner. Press the ALLERGEN CLEAR button. 1 ■ The power of enzymes is used to eliminate allergy-causing allergens that accumulate onthe allergen clear filter. To stop: Press the ON/OFF orALLERGEN CLEAR button. • Since the room tem...

– 14 – HIGH POWER/ECONOMY operation 2 If the air-conditioner is not operating, point the remote control toward the air conditioner, and Press the ON/OFF button. Press the HI POWER/ECONO button. • When the operating mode is AUTO, COOL or HEAT Every time the HI POWER/ECONO button is pressed, the displ...

– 15 – SELF CLEAN operation 1 In order to active CLEAN operation, press the CLEAN switchwith the tip of a ballpoint pen. Every time the CLEAN switch is pressed, the display is switchedin the order of: No display ■ CLEAN operation should be run after AUTO, COOL and DRY operation to remove the moistur...

– 17 – Turn off the power supply. Remove the air filter Maintenance Cleaning the air filter Standard interval is once every two week Do not use the following articles: • Hot water (40°C or more)It may deform or discolour the unit. • Petrol, paint thinner, benzine or cleanser, etc.They may deform or ...

– 18 – Stop the unit and turn off the power supply. The unit consumes appr. 2W even when the unit is not operating.Turning off the power supply will help saving energy consumption and cost. At the beginning of the season Ensure that the earth wiring is not snapped nordisconnected. Make sure that the...

– 19 – Proper installation Pay attention to operating noises! • When you install the unit, take care to choose a place that can comfortably stand the weight of the unit and does not increase the operating noiseor vibration. If vibration is transmitted through the house, fix the unit with the aid of ...

– 20 – Airflow is not blown out for 5 to 10 min. or blown out notwarm wind for a moment at HEATING operation. RUN light blinks slowly (1.5 sec ON, 0.5 sec OFF) Notice T h e u n i t d o e s n o t r e s t a r t i m m e d i a t e l y a f t e r y o u h a v estopped it. (RUN light is on) Not operating? A...

– 21 – Contact your dealer ■ Turn off the power switch immediately and inform your dealer in any of the following situations: The fuse or switch blows continu-ously. The cable becomes extremely hot.The covering of the cable is cracked. T h e T V , r a d i o o r o t h e r e q u i p m e n tstarts to m...

– 22 – Self diagnosis function ■ We are constantly trying to do better service to our customers by installing such judges that show abnormality of each function as follows: Outdoor temperature sensor error • Broken outdoor sensor wire, poor connector connection Description of trouble Room temperatur...

AIR-CONDITIONING & REFRIGERATION SYSTEMS HEADQUARTERS 16-5, 2-Chome, Kounan, Minato-ku, Tokyo, 108-8215, JapanFax: (03) 6716-5926 MITSUBISHI HEAVY INDUSTRIES EUROPE, LTD. AIR-CONDITIONER DIVISION 3rd Floor Thavies Inn House 3-4 Holborn Circus London EC1N 2HA, ENGLANDPhone: 44(0)20 7842 8171Fax: ...