Mitsubishi DLP HC3200- User Manual
Mitsubishi DLP HC3200– User Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
1
DLP
Projector
HC3200
Controlling the projector using a personal computer
This projector can be controlled by connecting a personal computer with RS-232C terminal.
PC-controllable functions:
•
Turning the power ON or OFF
•
Changing input signals
•
Inputting commands by pressing the buttons on the control panel and remote control
•
Menu setting
Connection
Important:
•
Make sure that your computer and projector are turned off before connection.
•
Boot up the computer first, and then plug the power cord of the projector.
(If you do not follow this instruction, the Com por t may not function.)
•
Adapters may be necessary depending on the PC connected to this projector. Contact your dealer for details.
1) Interface
This projector uses RXD, TXD and GND lines for RS-232C control.
For RS-232C cable, the cross cable should be used.
2) Control command diagram
The command consists of the address code, function code, data code, and end code. The length of the command
varies among the functions.
[Address code]
30h 30h (In ASCII code, ‘0’ ‘0’) fixed.
[Function code]
A code of each fixed control move.
[Data code]
A code of each fixed control data (number) and not always indicated.
[End code]
0Dh (In ASCII code,
‘
’) fixed.
PROTOCOL
RS-232C
BAUD RATE
9600 [bps]
DATA LENGTH
8 [bits]
PARITY BIT
NONE
STOP BIT
1 [bit]
FLOW CONTROL
NONE
Address code
Function code
Data code
End code
HEX
30h 30h
Function
Data
0Dh
ASCII
‘0’ ‘0’
Function
Data
‘
’
1
2
3
4
5
6
7
8
To RS-232C
terminal
D-SUB 9-pin
RS-232C cable
Mini-DIN 8-pin
To SERIAL terminal
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
