Miele G 5675 - Manual

Use ~ To reduce the risk of injury, do not allow children to play in, on or near thedishwasher. It is possible for smallfingers may be pinched in the door. ~ Only use the dishwasher if all panels are properly in place. ~ Do not tamper with the controls. ~ Do not sit or stand on the door or baskets o...

~ This model offers a Drying Plus feature, i.e. the door will automaticallyopen, without an audible signal firstbeing given, at the end of the programreleasing warm air from the dishwasher.Use caution, the air may be hot! ~ Advise the user of the Drying Plus feature to avoid injuries by walking,bump...

a Upper spray arm (not visible) b Cutlery tray c Upper basket d Middle spray arm e Air inlet for drying (depending on model) f Lower spray arm g Triple filter system h Data plate i Optical interface j Rinse aid reservoir k Dual compartment detergent dispenser l Salt container Guide to the dishwasher...

Control panel a Display b Delay start button , with indicator light c Turbo button with indicator light d Intensive lower basket button withindicator light e Program selection f Program selector button g On/Off K button with indicator light h Optical Interface(in-operation indicator light) This oper...

Energy saving washing This dishwasher is economical in theuse of water and electricity. For bestresults follow these tips: ^ For lowest energy consumption youmay connect the dishwasher to acold water source. ^ For fastest possible wash times, withslightly higher energy consumption,connect the dishwa...

T open the door The door will open automatically at theend of the program to aid in the dryingprocess. This function can be deactivated (see"Settings - Drying Plus"). ^ Pull the handle to open the door. If the door is opened during operation,the rinsing function is automaticallycanceled. , K...

Display The following functions can be selectedor set on the display: – program– options– delay start– settings While a program is running, thefollowing appears in the display: – the program segment– the approximate remaining running time – any faults or messages To save energy, the dishwasher turns...

Every dishwasher is tested beforeleaving the factory. Any waterremaining in the machine is from thefinal factory test and does notindicate that the machine has beenused. Filling the salt container To achieve good cleaning results, thedishwasher needs soft water (water thatis low in minerals). Hard w...

^ Place the provided funnel over thesalt container and carefully fill it withsalt. The salt container holdsapprox. 4.4 lbs (2 kg) of salt,depending on the type of salt. ^ Clean any excess salt from thethreads of the container opening.Screw the lid on firmly . ^ Immediately after each refill, run the...

Rinse aid Rinse aid helps to prevent spotting ondishes and glassware.The rinse aid is filled in the reservoirand the set amount will beautomatically dosed. , Filling the rinse aid reservoir with detergent (liquid or powder) willdamage the reservoir. Only pourrinse aid formulated for residentialdishw...

Rinse aid indicator When the ( Refill rinse aid message appears, the reservoir containssufficient rinse aid for 2 - 3 programsonly. ^ Add rinse aid once the program hasfinished. ^ Confirm with the center button. The "Refill rinse aid" message will goout. If using "Tab" detergent prod...

, Do not wash items soiled with ash, sand, wax, grease or paint inthe dishwasher.Ash and sand do not dissolve andwill be distributed throughout theinside of the dishwasher.Wax, grease and paint will causepermanent discoloration anddamage to the dishwasher. ^ Scrape food from dishes beforeplacing the...

Typical load for 10 place settings with cutlery tray Upper basket Lower basket Cutlery tray Loading the dishwasher 20

Typical load for 16 place settings with cutlery tray Upper basket Lower basket Cutlery tray Loading the dishwasher 21

Upper basket , Always use the dishwasher with the upper and lower basket inserted(except during the Tall items program, if available). ^ Load the upper basket with small,lightweight, or delicate items such ascups, saucers, glasses, dessertbowls, etc.Shallow pans can also be placed inthe upper basket...

Adjusting the height: You can set the support bar at twodifferent heights. ^ Pull the support bar upwards andclick it back into position at therequired height. Use the low setting for small glassesand tumblers. Use the high setting for tall glasses andstem ware. Loading the dishwasher 24

Adjusting the upper basket In order to gain more space for talleritems the upper basket can be adjustedon three levels with 2 cm between eachlevel. The upper basket can also be set at anangle with one side high and the otherside low. Make sure, however, that thebasket can slide smoothly in and out o...

Lower basket ^ Place larger and heavier items suchas plates, serving platters,saucepans, bowls, etc. in the lowerbasket.It can also be used for glasses, cups,small plates and saucers. Dishwasher with cutlery tray Dishwasher with cutlery basket Heavily soiled items ^ Place very large plates in the ce...

Cutlery Split cutlery tray (depending on model) ^ Arrange the cutlery as shown in thecutlery tray. For easier unloading cutlery should begrouped in zones, one for knives, onefor forks, one for spoons, etc. Spoon heads should be placed incontact with at least one of the serratedretainers on the base ...

Cutlery basket (depending on model) The cutlery basket can be placedanywhere on the front rows of spikes inthe lower basket. ^ To avoid risk of injury, knives andforks should be placed with thehandles upwards in the basket.However, cutlery placed handledown in the basket will come outcleaner and dri...

Optional dishwasher accessories are available from your Miele dealer, Miele orMieleusa.com (depending on your model some may already be supplied with yourmachine as standard). If you would like to... the following accessory will needto be ordered... ...wash a Miele Cappuccinatore ... a Cappuccinator...

Detergent , Dishwasher detergents contain irritant and corrosive ingredients.Avoid inhaling or swallowingdishwasher detergent.Keep children away from detergent.Keep detergent out of the reach ofchildren. Keep children away fromthe dishwasher when the door isopen. There could still be detergentresidu...

Turning on ^ Open the water supply, if closed. ^ Open the door. ^ Make sure the spray arms can rotatefreely. ^ Press the K button to turn the dishwasher on. The last program selected will appearin the display and the appropriateindicator light will come on.After a short while, the estimatedprogram d...

Program guide When to use Program sequence Pre-rinse Main wash Interim rinse Final rinse Drying 1 2 1 2 Pots & Pans For normally soiled pots & pans with dried on food , and heavily soiled dishware, use120% detergentrecommended. X X X X X Normal Program for completelywashing a full load of no...

At the end of a program At the end of a program the opticalcontrol light flashes slowly with the doorclosed. If the door has opened slightly, and themessage O Finished or Drying Plus appears in the display, this indicatesthat the program has finished. In the "Normal" program, the dryingfan w...

Interrupting a program A program is interrupted as soon as thedoor is opened.If the door is closed again, the programwill continue from where it wasinterrupted. , Water in the dishwasher is hot. Danger of scalding.Only open the door if absolutelynecessary and exercise extremecaution when doing so. B...

Intensive lower basket The "Intensive lower basket" additionaloption allows you to wash heavily soileditems in the lower basket while washingmore delicate items in the upperbasket. Cleaning performance in the lowerbasket is intensified in programs wherethis function is available.Depending on...

Delay start The start time of a program can bedelayed. The start time can be delayedfrom 30 minutes to 24 hours. The delayis set in 30 minute increments. When using the "Delay start"function, make sure that thedetergent compartment is dry beforeadding detergent. Wipe dry with acloth if neces...

The "Settings" menu allowsyou to change standardsettings Opening the "Settings" menu ^ Press the K button to turn the dishwasher off. ^ Press and hold the "Program" button. ^ Turn the dishwasher on with the K button and hold the "Program" buttondown for at least 4 sec...

Water hardness Your dishwasher is fitted with a watersoftener which you need to program tothe water hardness level in your area. – The dishwasher must be correctly programmed to match the hardnessof your water. – Your local water authority will be able to advise you of the exact waterhardness level ...

Rinse aid For best results the rinse aid dosagecan be adjusted.The dosage can be set between 0-6 ml.The factory default dosage setting is3 ml rinse aid. If spots appear on the dishes: – Use a higher setting for rinse aid. If smearing or streaking show:– Use a lower setting for rinse aid. ^ Select th...

Drying Plus The Drying Plus function automaticallyopens the door slightly at the end of aprogram with a drying phase (except"Extra quiet"), in order to improve thedrying process. (see the "Programguide"). This function can also be deactivated. ^ Select the desired setting andconfirm ...

Contrast There are seven different displaycontrast settings. ^ Select the desired contrast andconfirm with the center button. Filter check This selection allows you to set thenumber of cycles run before the filtercheck message shows.You can select between 30 and 60cycles. The "Filter check" ...

, Repairs should only be carried out by a qualified and trained person in accordance with local and national safety regulations. Unauthorized repairscould cause personal injury or machine damage. Technical faults Problem Possible fault Solution After the dishwasher wasturned on with the K button, th...

Faults in the water intake/water drain Problem Possible fault Solution One of the followingfaults appears on thedisplay: Before fixing the fault: – Press the K button to turn the dishwasher off. 2 Open water supply The water supply valveis closed. Open the water supply valve allthe way. 2 Water inta...

General problems with the dishwasher Problem Possible fault Solution The indicators and thedisplay is dark. Onlythe "Start/Stop" K indicator flashesslowly. The display goes into"Standby" mode to saveenergy Press the K button. Standby is ended. Detergent residue is leftin the dispense...

Sounds Problem Possible fault Solution There is a knockingnoise in the washcabinet The spray arm is hitting anitem in the basket. Interrupt the program,rearrange items blockingthe spray arms. There is a rattlingnoise in the washcabinet Items are not secure in thewash cabinet. Interrupt the program, ...

Poor cleaning results Problem Possible fault Solution The dishes are notclean. The dishes were notloaded correctly. See "Loading thedishwasher". The program was notpowerful enough. Select a more intensiveprogram (see "ProgramGuide"). Not enough detergent wasdispensed. Use more deterg...

Problem Possible fault Solution Dishes are not dry,glasses andcutlery arespotted. The rinse aid setting may betoo low, or the rinse aidreservoir is empty. Increase the dosage, refillthe reservoir or switch therinse aid product whenrefilling (see "Rinse aid"). Dishes were taken out toosoon. L...

Problem Possible fault Solution Glasses have abrown or bluediscoloration; filmcannot be wiped off. Detergent deposits. Change detergent rightaway. Glasses are dull anddiscolored; filmcannot be wiped off. Glasses are not dishwashersafe. The surface isaffected. There is no remedy.Only use dishwasher s...

Repairs In the event of a fault which you cannotcorrect yourself please contact theMiele Service Department at the phonenumber on the back of this booklet. ^ Please quote the model type andnumber of your appliance. These can be found on the data platealong the right edge of the door. PC Update The P...

User Maintenance Instructions To prevent accidentsand machine damage,read these instructions before installation or use.

Check and clean your dishwasherregularly. This will help avoid faultsand problems. , Abrasive cleaning agents, all-purpose cleaners, thinner orammonium cleaners should not beused on the dishwasher.They will damage the surface. Wash cabinet Generally, the wash cabinet is selfcleaning if the correct a...

Indicator reflector The reflector of the optical interface islocated in the steam deflector beneaththe counter top. ^ Clean as necessary with a dampcloth. Control panel ^ Clean the control panel as necessarywith a damp cloth. , The appliance front and controls are not scratch proof.Remove spills imm...

Triple filter system The triple filter system in the base of thewash cabinet retains coarse dirt fromthe suds solution, preventing it fromreaching the circulation system andre-entering the cabinet through thespray arms. , The dishwasher must not be used without all the filters in place. Collection o...

Cleaning the spray arms Sometimes particles of food get stuckin the spray arm jets. The spray armsshould be inspected and cleaned every4 - 6 months. ^ Turn off the dishwasher beforecleaning. Removing the spray arms ^ Remove the cutlery tray (if present). ^ Push the upper spray arm up to engage the i...

Installation Instructions Please refer to the Installation Diagram supplied with these instructions. Information is subject to change. Please refer to our website to obtain the mostcurrent product specification, technical & warranty information.

, Installation, repairs and other work by unqualified persons couldbe dangerous. Check that the voltage, frequencyand fuse rating shown on the dataplate match the household mainssupply. The power outlet must be accessibleafter installation. Do not use anextension cord to connect thedishwasher to the...

Hardwired electrical connection It is possible to hardwire this applianceto an existing power cable. , CAUTION: Before servicing, disconnect the power supply byeither removing the fuse, shutting offthe power main or manually"tripping" the circuit breaker. Installation work and repairs should...

Connection to the water supply , Installation, repairs and other work by unqualified persons could bedangerous. , Do not drink water from the dishwasher! – The dishwasher can heat its own water to the temperature required by thewash program. This allows forconnection of the machine to either ahot (m...

Drainage – The machine comes equipped with a built-in non-return valve on thedischarge side to prevent wastewater from flowing back into thedishwasher. – The dishwasher is equipped with a 5 ft (1.5 m) flexible drain hose with aninternal diameter of 7/8" (22 mm). – Drain hose extensions and adapt...

General requirements for measuring noise The dishwasher must be loaded with 16 place settings and the Normal program must be used. Installation requirements for measuring noise The dishwasher must be installed as follows:. ^ Install the dishwasher into an appropriate housing unit. ^ Secure the front...

^ Push the insulation mat supplied (depending on model) under the plinth until itis up against the appliance feet a . ^ Attach the toe-kick so that it is flush with the door front b . Noise measurement 69