Page 2 - Contents
Warning and Safety instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Caring for the environment . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 Guide to the appliance . . . . . . . . . . . . . . . . . . . . . . . . . . . . ...
Page 4 - Correct application; Warning and Safety instructions
This steam oven conforms to currentsafety requirements. Improper usecan, however, present a risk of bothpersonal injury and damage toproperty. To avoid the risk of accidents anddamage to the appliance, pleaseread these instructions carefullybefore installation and before usingit for the first time.T...
Page 7 - Correct use
Correct use ~ For added protection, it is advisable to use heat-resistant pot holders orgloves when using the appliance. Donot let them get damp or wet, as thiscauses heat to transfer through thematerial more quickly with the risk ofscalding or burning yourself. ~ If the oven is still hot, steam wil...
Page 9 - Caring for the environment
Disposal of the packingmaterial The transport and protective packinghas been selected from materials whichare environmentally friendly fordisposal, and should be recycled. Ensure that any plastic wrappings,bags, etc. are disposed of safely andkept out of the reach of babies andyoung children. Danger...
Page 10 - Front view; Guide to the appliance
Front view a Control panel b Ventilation outlet c Door seal d Steam channel e Compartment for water container f Water container (with insert) g Contact point for water container h Shelf levels i Steam inlet j Drip channel in the oven k Floor heater l Temperature sensor m Steam outlet Guide to the ap...
Page 11 - Accessories supplied; Condensate tray DGG 17; For placing your own cooking containers on; Silicone grease; For lubricating the coupling seal on the water container
Accessories supplied The accessories supplied with your appliance as well as arange of optional ones are available to order from Miele (see"Optional accessories"). Condensate tray DGG 17 To catch excess moisture325 x 350 x 40 mm (W x D x H) DGGL 8 1 perforated cooking containerGross capacity...
Page 12 - Descaling tablets; For descaling the water container.; Control panel; For switching on and off
Descaling tablets For descaling the water container. Control panel a For switching on and off b For setting the temperature and cooking duration c For confirming an entry d Display Guide to the appliance 12
Page 13 - Sensors; For calling up programming; Display; = no water or water container not present; Description of the functions
Sensors Lightly touch the sensors to operate the appliance. Anaudible tone will sound each time a sensor is pressed. Youcan deactivate this, if wished (see "Programming"). s - For switching the appliance on and off- For calling up the descaling process s + ? For calling up programming ? - Fo...
Page 14 - symbol is flashing, either the water container is not; Noises
Condensate tray When you are using perforated containers, place thecondensate tray on the floor of the appliance to collect anydrops of liquid and allow them to be removed easily. Water container The maximum water level is 1.2 litres, the minimum 0.75 litres.The water level markers are located insid...
Page 15 - Temperature; Recommended temperature
Temperature The steam oven has a temperature range of 40 °C to 100 °C.The appliance is set at 100 °C when the oven is switched on.You can alter the temperature in 5 °C steps. Recommended temperature 100 °C:For cooking all types of food,Reheating,Menu cooking (whole meals)Bottling,Extracting juice wi...
Page 16 - Cooking phase
Heating-up phase During the heating-up phase the oven compartment is heatedto the set temperature. The display will show the temperatureof the cooking compartment as it rises. The duration of the heating-up phase will depend on thequantity and the temperature of the food. In general theheating-up ph...
Page 17 - Cleaning for the first time; Remove any protective foil and adhesive labels.; Water container; Before using for the first time
Please stick the extra data plate for the appliance suppliedwith this documentation in the space provided in the "Aftersales service" section of this booklet. Cleaning for the first time Remove any protective foil and adhesive labels. Water container Take the water container out of the appli...
Page 18 - Setting the correct boiling point for water; If you; move house; , the appliance will need to be re-set for
Setting the correct boiling point for water The boiling point for water at a high altitude above sea levelwill be lower than the boiling point for water at sea level. Toadjust the boiling point for the altitude in your area, fill thewater container with mains tap water (see "Operation /Preparing...
Page 19 - Preparing the appliance for use; mains tap water; Setting the temperature and duration; Operation
Preparing the appliance for use ^ Fill the water container with mains tap water up to at leastthe "min" marker. You do not need to remove the insert. Only use mains tap water . Never use distilled or mineral water or other liquids. ^ Push the water container into the appliance until itconnec...
Page 20 - At the end of the duration; Switch the appliance off.; After use; Remove the condensate tray and empty it.
At the end of the duration At the end of the set cooking duration, an audible tone willsound, 3 zeros will appear and "h" will flash in the display. ^ Switch the appliance off. The fan will continue to run for a while after the oven has beenswitched off. If you want to reduce the run-on time...
Page 21 - During operation; Interrupting operation; Operation will resume when the door is closed.; Changing the temperature
During operation Interrupting operation Operation is interrupted as soon as the door is opened. Theheating will be switched off and the cooking duration remainsstored in memory. Steam will escape when the door is opened. Step backfrom the steam oven and wait until the steam hasdissipated. When putti...
Page 22 - Insufficient water; Insufficient water is indicated by the flashing
Insufficient water Insufficient water is indicated by the flashing p symbol and an audible tone. ^ Remove the water container and fill it with fresh tap water. ^ Push the water container into the appliance until itconnects. ^ Close the door. Operation will continue. Operation 22
Page 23 - Do not; Additional functions
Pre-heat Your appliance has a pre-heating function. This heats theoven interior to approx. 40 °C. The heating-up time is thenshorter as the oven interior is pre-heated and therefore thecooking process takes less time. The appliance is delivered with the pre-heating functiondeactivated. If you wish t...
Page 24 - Programming
The standard settings listed in the chart can be altered. Several settings can bealtered in succession. Programme Status* P 1 S 0 S 1 Factory default settings reinstated P 2 Demonstrationmode S 0 Off, the appliance will heat up S 1 On, the appliance will not heat up P 3 Audible tonevolume S 1 Very q...
Page 25 - switched off
Before you begin, ensure that the appliance is switched off . ^ Touch and hold the s sensor. ^ While the s sensor is being touched, touch the ? sensor once briefly. P1 will appear in the display. ^ Touch the ; or ? sensor until the programme you want appears highlighted in the display. ^ Confirm wit...
Page 26 - Do not use a steam cleaning appliance to clean this; Cleaning and care
Miele offer a range of branded cleaning and conditioningproducts. See "Optional accessories". , Do not use a steam cleaning appliance to clean this appliance. The steam could reach the electricalcomponents and cause a short circuit. Switch the appliance off and allow it to cool down to a saf...
Page 27 - Appliance front; To avoid damaging your appliance, do not use:; – cleaning agents containing descaling agents,
Appliance front Remove any soiling immediately.If this is not done, it might become impossible to removeand could cause the surface to alter or discolour. Clean the front using a damp Miele microfibre E-cloth or witha clean sponge and a solution of hot water and washing-upliquid. After cleaning dry ...
Page 28 - Oven interior; After prolonged use, the; floor heater; can become; door seal; with a new one if it becomes porous or; Drip tray, rack and cooking containers
Oven interior Dry the oven interior, oven interior roof, door seal, dripchannel, inside of the door and the compartment for the watercontainer after each use. Use a sponge or absorbent cloth towipe off the condensate which has built up in thecompartment. Remove grease deposits with a clean sponge an...
Page 29 - Remove, empty and dry the water container after each use.
Water container Remove, empty and dry the water container after each use. ^ Release the insert by pushing the catches on the sides intowards each other and the pull it out of the container. ^ After cleaning, dry both parts of the insert thoroughlybefore replacing it in the water container. When repl...
Page 30 - Coupling seal; – Remove any silicone grease from your skin either by
Coupling seal If the water container becomes difficult to remove andreplace or the fault message F20 appears, rub a small amount of the silicone grease supplied (see "Guide to theappliance / Accessories supplied") into the inside of thecoupling seal. Do not take the seal out to lubricate it!...
Page 31 - Descaling; manually
Descaling For optimum cleaning results we recommend that you useMiele descaling tablets to descale your steam oven (see"Optional accessories"). A proprietary citric acid baseddescaling agent can also be used. Follow the manufacturer'sinstructions on the packaging. Ensure that the descaling a...
Page 33 - Removing and refitting the door; To remove the door; Flip up the release levers in front of the door hinges.; To refit the door; Fit the door on the hinges.
Removing and refitting the door It is much easier to clean the steam oven interior if youremove the door first. To remove the door ^ Open the door fully. ^ Flip up the release levers in front of the door hinges. ^ Slowly close the door until the raised levers are touchingthe frame. ^ Holding the doo...
Page 34 - Problem solving guide
, Installation work and repairs to electrical appliances must only be carried out by a suitably qualified andcompetent person in strict accordance with current localand national safety regulations (BS 7671 in the UK).Repairs and other work by unqualified persons could bedangerous. The manufacturer c...
Page 37 - These products can be ordered at:; Cooking containers; Optional accessories
Miele offers a comprehensive range of useful accessories aswell as cleaning and conditioning products for yourappliance. These products can be ordered at: or from Miele (see back cover for contact details) or from yourMiele dealer. Cooking containers There is a wide range of perforated and solid coo...
Page 39 - Cleaning and care products; For descaling the water container
DGD 1/2 Lid for 325 x 265 mm cooking containers Condensate tray DGG 17 To catch excess moisture325 x 350 x 40 mm (W x D x H) Rack For placing your own cooking containers on Cleaning and care products Miele descaling tablets6 tablets For descaling the water container Ceramic and stainless steel hob c...
Page 40 - Removes finger marks and light soiling; Other accessories
E-cloth (microfibre cloth) Removes finger marks and light soiling Silicone grease For lubricating the coupling seal.Please read the relevant instructions in "Cleaning and care". Other accessories Multi-purpose casserole dish KMB 5000-S Die-cast aluminium casserole dish with anti-stick surfac...
Page 41 - Safety instructions for installation
~ Before connecting the appliance, make sure that the connection data on the data plate (voltage and frequency)match the mains electricity supply.This data must correspond in order to avoid the risk ofdamage to the appliance. Consult a qualified electrician if inany doubt. ~ The socket and on-off sw...
Page 42 - Installation in a tall unit; Steam oven; Appliance and building-in dimensions
Installation in a tall unit * Appliances with glass front** Appliances with metal front a Steam oven b Building-in recess c Inlet for mains connection cable to the appliance d Recommended position for electrical socket.Important: Do not position behind the appliance! e Mains connection cable Applian...
Page 43 - Installation in a base unit
Installation in a base unit If the steam oven is being installed underneath a hob, please follow theinstructions for building in the hob and also take the building-in height for thehob into account. * Appliances with glass front** Appliances with metal front a Steam oven b Building-in recess c Inlet...
Page 44 - Installation in a tall unit in combination with an oven
Installation in a tall unit in combination with an oven * Appliances with glass front** Appliances with metal front a Steam oven b Building-in recess c Inlet for mains connection cable to the appliance d Recommended position for electrical socket.Important: Do not position behind the appliance! e Ma...
Page 45 - Installing the appliance
^ Push the appliance into the recess and align it. ^ Secure the appliance by screwing the two wood screws3.5 x 25 mm i (supplied) into the vertical trim on either side of the appliance (see illustration). Installing the appliance 45
Page 46 - Electrical connection
All electrical work should be carried out by a suitablyqualified and competent person, in strict accordance withcurrent local and national safety regulations (BS 7671 inthe UK). Installation, repairs and other work by unqualified personscould be dangerous. The manufacturer cannot be heldliable for u...
Page 48 - After sales service, data plate
In the event of any faults which you cannot remedy yourself, or if the appliance isunder guarantee, please contact: – Your Miele dealer, or – the Miele Customer Contact Centre (see back cover for address). Please note that telephone calls may be monitored and recorded to improveour service. When con...