Page 2 - Contents
IMPORTANT SAFETY INSTRUCTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Description of the cooktop . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 KM 5621. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ...
Page 3 - SAVE THESE INSTRUCTIONS; Correct usage; IMPORTANT SAFETY INSTRUCTIONS
WARNING- When using yourappliance follow basicprecautions, including thefollowing: Read all instructions beforeinstallation or use to preventinjury and appliance damage. This appliance conforms to alluniform safety codes andregulations. Keep these operating instructionsin a safe place and pass them ...
Page 4 - Technical safety; Do not
Technical safety ~ Installation, repair and maintenance work should be performed by a Mieleauthorized service technician. Work byunqualified persons could bedangerous and may void the warranty. ~ Be sure your appliance is properly installed and grounded by a qualifiedtechnician. ~ Before installing ...
Page 5 - Safety
Safety ~ DO NOT TOUCH THE COOKING AREA OR THE VICINITY AROUND THECOOKING AREA - During operation,the cooking area and its surroundingswill get hot and can cause burns. Whenthe cooktop is shut off, the surface mayremain hot enough to cause harm, eventhough the glow is not visible throughthe dark glas...
Page 8 - Description of the cooktop
KM 5621 ac Variable burner bd Standard burner e Residual heat indicator Burner data Burner C Diameter Output in Watts at 208/240 V inch cm Left front a 4 3 / 4 " / 8 1 / 4 " 12 / 21 900 / 2400 Left rear b 5 11 / 16 " 14.5 1200 Right rear c 4 3 / 4 " / 7 1 / 16 " 12 / 18 700 / 180...
Page 11 - Before using for the first time
Clean the cooktop ^ Before using for the first time, cleanthe appliance with a damp cloth anddry with a soft cloth. Do not use liquid dish soap to cleanthe cooktop, this may causepermanent blue discolorations. Heat the cooktop Only for facet cooktops:A small gap between the cooktopand the work surfa...
Page 12 - How the burners operate
One-zone burners use one heatingstrip; two-zone burners and grill zoneshave two heating strips. Depending onthe model, the heating strips may beseparated by a ring. Each burner has overheating protection(internal temperature limiter) feature toprevent the ceramic glass fromoverheating (see "Over...
Page 13 - Operation
The burners are turned on when thecorresponding control knob is pressedin and rotated to the desired outputlevel. Control knobs for one-ring burners canbe rotated 360°. Burners can be turnedon and off by turning the knobs to rightor to left. Control knobs for variable burners havea stop. Burners can...
Page 14 - Residual heat indicator
Residual heat indicator After turning on a burner, for examplethe left front, a specified temperature isreached, the associated residual heatindicator lights up. After turning off the burner, the residualheat indicator will go out. The residualheat indicator will turn off once thecooking zone is saf...
Page 15 - Energy saving tips; Selecting cookware
– Use cookware with thick, flat, smooth bottoms. Slightly concave bottomswill also work adequately. Pans withconvex bottoms will not cook well. cold hot – Cast iron, glass or stoneware should not be used because they have poorheat transfer and may scratch thecooktop surface. – Also unsuitable is pla...
Page 16 - Overheat protection
Each cooking zone is equipped with atemperature limiter. This featureautomatically turns off the heatingelement before the glass ceramicbecomes too hot. Once the ceramicsurface has cooled to a safetemperature the heating element willautomatically turn back on. The overheat protection may beactivated...
Page 17 - Ceramic surfaces; aluminum foil; immediately; Cleaning and Care
Do not use a steam cleaner to cleanthis appliance. Steam couldpenetrate electrical components andcause a short circuit. Pressurizedsteam could cause permanentdamage to the surface. Do not use any sharp pointedobjects which could damage theseal between the ceramic surface,the surrounding frame and th...
Page 18 - Problem; Frequently asked questions
, Repairs should be carried out only by an authorized technician in accordance with local and national safety regulations. Unauthorized repairscould cause injury or appliance damage. Problem Possible cause Solution Burners do not heatup when turned on The circuit breaker hastripped. Check whether a ...
Page 19 - Technical Service
In the event of a fault which you cannoteasily fix yourself, please contact theMiele Technical Service Department atthe address on the back of this booklet. When contacting Technical Serviceplease quote the serial number andmodel of the appliance. Adhere rating label sticker suppliedwith the applian...
Page 21 - Installation Instructions; before
Installation Instructions IMPORTANT: SAVE FOR THE LOCAL ELECTRICAL INSPECTOR'S USE Information is subject to change. Please refer to our website to obtain the mostcurrent product specification, technical & warranty information. To prevent accidentsand appliance damageread these instructions befo...
Page 22 - IMPORTANT INSTALLATION SAFETY INSTRUCTIONS
Note to the installer:Please leave this instruction bookwith the consumer for the localelectrical inspector’s use. The minimum distances given inthese Installation Instructions mustbe observed in order to ensure safeoperation. Failure to do so increasesthe risk of fire. The cabinetry and venting hoo...
Page 23 - Safety distance from divider
Safety distance from divider Installation of a divider under thecooktop is not required. If a divider is fitted under the cooktop,the distance between the upper edgeof the work surface and the upper edgeof the divider must be at least 4 ½ "(110 mm). A gap of at least 1 3/8"" (35 mm) must...
Page 25 - Safety distance from the wall covering; Cooktops flush with the countertop; Installation
Safety distance from the wall covering If a wall covering is installed, a minimum safety distance must be maintainedbetween the countertop cut-out and the covering, since high temperatures candamage these materials. If the covering is made of a combustible material (such as wood), the distancebetwee...
Page 27 - Installation dimensions
KM 5621 a Spring clips b Front c Installation height d Power cord, L = 56 11/16" (1440 mm) e Rating label Installation dimensions 27 (75 mm) 15/16" 2 20 1/16" (558 mm) 21 15/16" 22 5/16" 3/8" 20 2 2 b (75 mm) 3/8" 3/8" (567 mm) a a (60 mm) (60 mm) b (509 mm) (544 mm) ...
Page 30 - Wood or solid surface countertop
The exact positions of the springclamps and the support bars (forbeveled cooktops only) are shown inthe "Installation dimensions" of eachunit. Facet cooktops: A special sealing strip ensures theslip-proof seating of the cooktop inthe cutout. The gap between theframe and the countertop will n...
Page 31 - Granite countertop
Granite countertop Strong double-sided adhesive tapeand silicon are required forinstallation (not included). ^ Using adhesive tape c attach the spring clips and the securing strips(for facet cooktops only) The spring clips and the securingstrips must be on or flush with thetop edge of the cooktop. ^...
Page 32 - Insert the cooktop
Insert the cooktop ^ Feed the power cord down throughthe cut-out. ^ Place the cooktop lightly on thespring clips. ^ With a hand on each side of theappliance press down evenly on theedges until it clicks into position.When doing so make sure that theappliance seal sits tightly on thecountertop to ens...
Page 33 - Power supply; Electrical connection
, CAUTION: Before installation or servicing, disconnect the powersupply by either removing the fuse,shutting off the main power ormanually "tripping" the circuitbreaker. Installation work and repairs shouldonly be performed by a qualifiedtechnician in accordance with allapplicable codes and ...
Page 34 - Help protect our environment
Disposal of packing materials The cardboard box and packingmaterials are biodegradable andrecyclable. Please recycle. Ensure that any plastic wrappings,bags, etc. are disposed of safely andkept out of the reach of children.Danger of suffocation! Disposal of an old appliance Old appliances contain ma...