Page 2 - • Effective Distance of the Remote; CONTENTS
Contents ................................................................................................................................................................................1 Important Safety Instructions ......................................................................................
Page 3 - IMPORTANT SAFETY INSTRUCTIONS; an outdoor antenna.; All operating and use instructions should be followed.; WATER AND MOISTURE; in a wet basement, or near a swimming pool.; GROUNDING OR POLARIZATION; Do not defeat the safety purpose of the polarized plug.; CAUTION; RISK OF ELECTRIC SHOCK
IMPORTANT SAFETY INSTRUCTIONS 2 Before using the unit, be sure to read all operating instructions carefully. Please note that these are general precautions and may not pertain to your unit. For example, this unit may not have the capability to be connected to an outdoor antenna. 1. READ INSTRUCTIONS...
Page 4 - IMPORTANT SAFETY INSTRUCTIONS (CONTINUED)
13. LIGHTNING To protect your product from a lightning storm, or when it is left unattended and unused for long periods of time, unplug it from the wall outlet and disconnect the antenna or cable system. This will prevent damage to the product due to lightning and power-line surges. 14. POWER LINES ...
Page 5 - LOCATION OF CONTROLS; FRONT; Use only the AC adapter provided with this unit. Using another AC
1 2 3 4 5 6 7 11 10 13 12 14 8 9 1. POWER Button - Press to turn the TV on; the POWER indicator will light green and picture will appear in approximately five seconds. Press again to turn the TV off; the Power indicator will light red. 2. CHANNEL Down Button - Press to select a lower numbered channe...
Page 6 - REAR PANEL
1 6 5 7 8 2 3 4 5 LOCATION OF CONTROLS (CONTINUED) 1. HDTV IN Jacks (R/L/P R /P B /Y) 2. S IN Jacks (R/L/S)3. AV IN Jacks (R/L/V)4. VGA IN Jack5. UHF/VHF Antenna Jack6. AUDIO OUT Jacks (R/L)7. VGA AUDIO IN Jacks (R/L)8. COMPONENT IN Jacks (R/L/C R /C B /Y) REAR PANEL
Page 7 - REMOTE CONTROL
REMOTE CONTROL 6 16 17 1819 20 21 22 24 23 26 25 2829 27 1 23 4567 9 8 11 10 13 12 15 14 1. RECALL Button 2. CH LOCK Button 3. TV/AV/PC Button 4. CHANNEL Up Button 5. VOLUME Down Button 6. CHANNEL Down Button 7. MTS Button 8. VIDEO MODE Button 9. WIDE Button 10. AUDIO MODE Button 11. SRS (Surround S...
Page 8 - BATTERY INSTALLATION; BATTERY PRECAUTIONS; Why is the remote control not working properly?; EFFECTIVE DISTANCE OF THE REMOTE CONTROL TRANSMITTER
REMOTE CONTROL (CONTINUED) 7 BATTERY INSTALLATION + + – – 1 Open the battery compartment cover. Install two “AAA” batteries, paying attention to the polarity diagram in the battery compartment. Replace the battery compartment cover. BATTERY PRECAUTIONS Follow these precautions when using batteries i...
Page 9 - FOR SUBSCRIBERS TO BASIC CABLE TV SERVICE; connect the CATV 75 ohm coaxial cable to the VHF/UHF jack on the; FOR SUBSCRIBERS TO SCRAMBLED CABLE TV SERVICE OR SATELLITE; converter/descrambler or satellite box to select channels.; INCOMING; DESCRAMBLER OR; I connected my cable, why can’t I get channels above 69?
CABLE (CATV)/SATELLITE CONNECTIONS 8 This TV has an extended tuning range and can tune most cable channels without using a Cable TV converter box. Some Cable TV companies offer “premium pay channels” in which the signal is scrambled. Descrambling these signals for normal viewing requires the use of ...
Page 10 - OUTDOOR ANTENNA CONNECTIONS; Antenna (Single 75 ohm cable; OR
9 OUTDOOR ANTENNA CONNECTIONS OUTDOOR VHF/UHF ANTENNA CONNECTION (ANTENNA NOT SUPPLIED) Follow the instructions for the type of antenna system you intend to use. Combination VHF/UHF Antenna (Single 75 ohm cable or 300 ohm twin-lead wire) Separate VHF/UHF Antennas Combination VHF/UHF Antenna (Separat...
Page 11 - VCR CONNECTIONS; CONNECTION USING COAXIAL CABLE:; TV or CATV; appears on the TV screen and press PLAY on the VCR to
10 VCR CONNECTIONS CONNECTION USING COAXIAL CABLE: Follow the instructions below to connect a VCR to your television using a 75 ohm coaxial cable. (CABLES NOT INCLUDED.) 1. Connect the cable, satellite or incoming antenna to the VHF/UHF IN jack on the rear of the VCR. 2. Connect a 75 ohm coaxial cab...
Page 13 - DVD CONNECTIONS; Connect the DVD’s video OUT jack to the TV’s video AV IN jack.
12 DVD CONNECTIONS 1. Connect the left and right audio cable from the DVD’s Audio OUT jacks to the TV’s audio left and right AV IN jacks. Connect the DVD’s video OUT jack to the TV’s video AV IN jack. 2. Press the TV/VIDEO/PC button until AV appears on the TV screen and press PLAY on the DVD to watc...
Page 14 - STEREO CONNECTION; DVD PLAYER; CONNECTION USING COMPONENT CABLES:; Refer to the stereo system’s owner’s manual for instructions.; STEREO
13 DVD CONNECTIONS (CONTINUED) STEREO CONNECTION 1. Connect the left and right audio cable from the DVD’s Audio OUT jacks to the TV’s audio left and right AV IN jacks. 2. Connect a video cable from the DVD’s Y, Pb, Pr OUT jacks to the TVs AV2 DVD IN (Cr, Cb, Y) jacks. 3. Press the TV/VIDEO/PC button...
Page 15 - Refer to the computer’s owner’s manual for instructions.
14 HDTV CONNECTION COMPUTER CONNECTION 1. Connect the left and right audio cable from the HDTV’s Audio OUT jacks to the TV’s HDTV left and right Audio IN jacks. 2. Connect a video cable from the Y, Pb, Pr OUT jacks to the TV’s HDTV IN jacks. 3. Press the TV/VIDEO/PC button until Y Pb Pr appears on t...
Page 16 - FIGURE 1
Please follow the instructions and figure below to install the unit using the supplied wall brackets and Hook Assemblies: 1. Before wall mounting the unit, you must remove the base stand as follows: a. Remove the two screws, then remove the base cover as shown in figure 1. b. Remove the eight screws...
Page 17 - BB; FIGURE 4
2. Drill four 5mm holes through the wall for each bracket, or if there is a stud behind the wall where you are putting the bracket, drill four 5mm holes through the wall and into the studs for each bracket. See below figure 3 for lengths. 3. Secure the Hook Assemblies (A) to the TV by inserting the ...
Page 18 - CLOCK SETTING
17 CLOCK SETTING Press the POWER button ❶ to turn on the TV; the POWER indicator will light green. Press the MENU button ❷ ; the MENU screen will appear. 2 1 Press the CHANNEL UP ❶ or DOWN ❷ button until SYSTEM SETTING is selected, then press the VOLUME UP button ❸ to select it. Press the CHANNEL UP...
Page 19 - SETTING THE AIR/CABLE OPTION
18 SETTING THE AIR/CABLE OPTION Set the AIR/CABLE option as follows: Press the POWER button ❶ to turn on the TV; the POWER indicator will light green. Press the MENU button ❷ ; the MENU screen will appear. 1 Press the CHANNEL UP ❶ or DOWN ❷ button until SYSTEM SETTING is selected, then press the VOL...
Page 20 - SETTING THE CHANNELS INTO MEMORY; Why can’t I access TUNING?
SETTING THE CHANNELS INTO MEMORY 19 This TV is equipped with a channel memory feature which allows channels to skip up or down to the next channels set into memory, skipping over unwanted channels. Before selecting channels, they must be programmed into the TV’s memory. In addition to normal VHF/UHF...
Page 21 - ADDING AND SKIPPING CHANNELS
ADDING AND SKIPPING CHANNELS 20 After setting channels into memory, you can add or delete channels as follows: Press the POWER button ❶ to turn on the TV; the POWER indicator will light green. Press the MENU button ❷ ; the MENU screen will appear 1 2 1 Press the CHANNEL UP ❶ or DOWN ❷ button until C...
Page 22 - SETTING FAVORITE CHANNELS
21 SETTING FAVORITE CHANNELS Set up to ten channels into the Favorite Channel Preferences to easily access the channel. Set as follows: Press the POWER button ❶ to turn on the TV; the POWER indicator will light green. Press the MENU button ❷ ; the MENU screen will appear 1 2 1 Press the CHANNEL UP ❶...
Page 23 - SETTING THE SLEEP TIMER
22 SETTING THE SLEEP TIMER To set the TV to turn off after a preset amount of time, follow the steps below: Press the POWER button ❶ to turn on the TV; the POWER indicator will light green. Press the MENU button ❷ ; the MENU screen will appear 1 Press the CHANNEL UP ❶ or DOWN ❷ button until SYSTEM S...
Page 24 - TV OPERATION; For proper operation, before selecting channels, they; Why do I only receive 69 channels, when my cable goes much higher?
TV OPERATION 23 Adjust the volume level by pressing the VOLUME UP ❶ or DOWN ❷ button. The volume level will be indicated on the screen by a green numerical display between 0 and 100 where 0 is the lowest setting and 100 is the loudest. 1 2 3 For proper operation, before selecting channels, they must...
Page 25 - MTS
TV OPERATION (CONTINUED) 24 MUTE RECALL Repeatedly press this button to cycle through the device(s) connected to the INPUT jacks (TV/CATV, AV, S-VIDEO, COMPONENT, YPbPr and PC). 1 TV/AV/PC Press to select one of the following sound modes: STEREO : Select for channels that are broadcasting in stereo....
Page 28 - CLOSED CAPTIONS; When I press the RECALL or MUTE button, the captions
WHAT IS CLOSED CAPTIONING? This television has the capability to decode and display Closed Captioned television programs. Closed Captioning will display text on the screen for hearing impaired viewers or it will translate and display text in another language. CLOSED CAPTIONING WITH A VCR Closed Capt...
Page 36 - CHANGING THE PASSWORD
35 Enter the V-CHIP menu screen as described on page 32. 1 Press the CHANNEL UP ❶ or DOWN ❷ button until PA S S W O R D S E T T I N G i s s e l e c t e d , t h e n p r e s s t h e VOLUME UP button ❸ to select it. 2 3 1 2 Use the VOLUME UP ❶ or DOWN ❷ buttons to select the first digit (0-9), then use...
Page 37 - SETTING THE ON TIMER; Does the clock have to be set before using the On Timer?
36 SETTING THE ON TIMER Press the POWER button ❶ to turn on the TV; the POWER indicator will light green. Press the MENU button ❷ ; the MENU screen will appear. 1 2 1 Press the CHANNEL UP ❶ or DOWN ❷ button until SYSTEM SETTING is selected, then press the VOLUME UP button ❸ to select it. Press the C...
Page 38 - TROUBLESHOOTING GUIDE
SYMPTOM POSSIBLE CAUSE POSSIBLE SOLUTION POWER No power. The AC power cord is not Connect the AC power cord to connected. the AC outlet. TV BROADCAST RECEPTION TV station experiencing problems. Try another channel. Poor or no picture. Picture control is not adjusted. Check picture control adjustment...
Page 39 - RECEPTION DISTURBANCES; lamps, electric drills and other electric appliances.; RADIO FREQUENCY INTERFERENCE:; cases, causes loss of contrast in the picture.; PICTURE SIZE VARIATION:; CONTRAST or BRIGHTNESS setting.
RECEPTION DISTURBANCES 38 IGNITION: Black spots or horizontal streaks may appear, picture may flutter or drift. Usually caused by interference from automobile ignition systems, neon lamps, electric drills and other electric appliances. GHOSTS: Ghosts are caused by the television signal following two...
Page 40 - SPECIFICATIONS
Item Characteristics Specifications LCD Panel Type Super IPS/Super MVA Active Display Area 643.2 (H) * 385.92(V)mm (29.6” diagonal) Pixel Pitch 0.1675mm*0.5025mm*RGB Max.Resolution WXGA 1280*768 Contrast Ratio 500:1(Typical) Brightness 500 cd/m2(Typical) Response Time 25ms Display Color 16.7M colors...
Page 41 - CARE AND MAINTENANCE; THIS PRODUCT TO YOUR PLACE OF PURCHASE OR MEMOREX.
Audio System 3D Surround Yes Amplifier 4W(10% THD max.) Speaker 10W Terminals AV1 RCA for CVBS,Audio R/L S S Din for S-Video,Audio R/L COMPONENT(Y Cb Cr) RCA for YUV and Audio R/L HDTV(Y Pb Pr) RCA for YUV and Audio R/L PC Analog Port D-sub 15pin VGA PC Stereo input RCA,Audio R/L Audio Line Out RCA,...
