Meade TE827W - Manual - manualsarea.com

Page 2 - Table of Contents

Table of Contents IntroductionStandard Package ContentsInstallationBefore you beginThermo-Hygrometer SensorRain GaugeAnemometer (wind sensor)Main UnitBattery installationButtons and ControlsNavigating through the modesCustomizing your Weather StationUsing Different Weather ModesPressure and Weather ...

Page 3 - INTRODUCTION; In this package you will find:

INTRODUCTION Thank you for selecting a Meade Instruments Semi-professional weather station! This compact and easy-to-use product features a wide variety of time and weather data, such as precise atomic time, perpetual calendar, air temperature, relative humidity, barometric pressure, wind speed and ...

Page 4 - Components; STANDARD PACKAGE CONTENTS; Picture

Main Unit AC/DC 7.5V power adaptor Thermo Hygrometer Sensor Rain Gauge Consists of: Funnel shaped top with battery compartment Rain Gauge bucket Bucket see-saw mechanism Protective screen Anemometer Consists of: Wind CupsWind Vane Anemometer arm Anemometer base Mounting hardware 4 screws for securin...

Page 6 - FEATURES; C. Rain gauge bucket feet

C. RESET Resets all readings D. CHANNEL SWITCH Selects the desired transmission channel from 1 to 3 E. WALL-MOUNT RECESSED OPENING Attaches the remote sensor to the wall Note: Install the batteries and select the channel before mounting the sensor.Battery installation • Remove the screws from the ba...

Page 7 - Holds two AA-size batteries; Battery installation

G H I F E D D. Funnel-shaped top with battery compartment Contains battery compartment and rainfall counting electronics E. Battery compartment Holds two AA-size batteries F. Screws Secure battery compartment cover G. Built-in leveler Allows leveling rain gauge on uneven surfaces H. Bucket see-saw m...

Page 8 - F. BATTERY COMPARTMENT

A B E G F H C D ANEMOMETER (WIND SENSOR) FEATURES • Wind speed and wind direction measurement• Remote wind speed and wind direction data transmission to the main unit via 433 MHz signal• Operating range 100 feet (30 meters) • Wall or pole mount A. WIND VANE Measures wind direction B. WIND CUPS Measu...

Page 9 - MAIN UNIT

Battery installation • Remove four (4) screws from the battery compartment with a small Phillips screwdriver.• Open the battery compartment and install 2 “AA” size alkaline batteries (not included) matching the polarities shown.• Replace the battery compartment door and secure the screws. Aligning •...

Page 10 - Operation; temperature and humidity readings and default time; BUTTONS AND CONTROLS

Operation Once the main unit is powered, the display will show all available LCD segments for a moment. IMPORTANT: All of the display functions will be locked, allowing setting your local altitude or sea level pressure parameters. The locked display will show the pressure and weather forecast icon a...

Page 11 - button to cycle through the modes clockwise or; DOWN; - Places the main unit on the table or other horizontal surface

NAVIGATING THROUGH THE MODES The main unit has five (5) different modes (windows) displaying separate data: Weather Forecast, Clock & Alarm, Temperature and Humidity, Rain, and Wind. When a specific mode is selected the corresponding icon begins flashing.Press UP button to cycle through the mode...

Page 16 - Undefined data

Icon RC Reception Strength Undefined data Reception failed for 24 hours Weak signal, but can be decoded Strong signal (Flashing) Programming Time Alarms • In the Clock and Alarm Mode, press the ALARM/CHART selecting the desired alarm. • Press and hold ALARM/CHART button until the hour digit will fla...

Page 17 - Searching for remote sensor signals

Icon Status Searching for remote sensor signals Corresponding remote sensor successfully linked No signals received for more than 15 minutes TEMPERATURE AND HUMIDITY MODE The weather station supports up to 3 remote thermo-hygrometers corresponding to a separate channel of the temperature and relativ...

Page 20 - PRECAUTIONS

PRECAUTIONS This product is engineered to give you years of satisfactory service if handled carefully. Here are a few precautions:• Do not immerse the units in water.• Do not clean the units with abrasive or corrosive materials. They may scratch the plastic parts and corrode the electronic circuits....

Page 21 - Appendix - City Codes; US and Canadian Cities; World Cities

Appendix - City Codes City codes are used for presetting setting Latitude and Longitude. These codes affect time zones and DST settings. US and Canadian Cities City Code Zone DST City Code Zone DST t e s f f O t e s f f O Atlanta, Ga. ATL -5 SU Memphis, Tenn. MEM -6 SU Austin, Tex. AUS -6 SU Miami, ...

Page 22 - = Iraq and Syria DST

City Code Zone DST City Code Zone DST t e s f f O t e s f f O Kinshasa, Congo FIH 1 NO Oslo, Norway OSL 1 SE Kuala Lumpur, Malaysia KUL 8 NO Panama City, Panama PTY -5 NO La Paz, Bolivia LPB -4 NO Paris, France PAR 1 SE Lima, Peru LIM -5 NO Perth, Australia PER 8 NO Lisbon, Portugal LIS 0 SE Prague,...

Page 24 - • If batteries or parts are swallowed, see a doctor immediately.

Weight (without batteries) Main unit: 8.15oz (231g) Remote Thermo-Hygrometer: 2.29oz (65g) Remote Anemometer: 11.12oz (315g) Remote Rain gauge: 10.24oz (290g) DimensionsMain unit: 7.31 (L) x 5.39 (H) x 1.26 (D) inches / 185.8 (L) x 136.9 (H) x 32 (D) mmRemote Thermo - Hygrometer: 2.37 (L) x 4 (H) x ...

Page 25 - STANDARD WARRANTY INFORMATION; . Each returned part or product must

STANDARD WARRANTY INFORMATION This product is warranted by Meade Instruments Corp. (MIC) to be free of defects in materials and workmanship for a period of ONE YEAR from date of original retail purchase in the U.S.A. MIC will repair or replace the product, or part thereof, found upon inspection by M...

Meade TE827W - Manual

Table of Contents:

Summary

Other Meade Models