McCulloch 2500CXL - Manual

7 76 cm HARNESS ADJUSTMENT FOR BALANCE 10 -- 30 cm above ground 15 cm below waist 76 cm ATTACHING THE SHIELD WARNING: The shield must be prop- erly installed. The shield provides partial protection to the operator and others from the risk of thrown objects, and is equipped with a line limiter blade ...

9 NOTE: To remove blade, insert screwdriver into aligned holes. Unthread the nut and remove parts. Be sure to store parts and instructions for future use. ATTACHING THE TRANSPORT GUARD NOTE: The transport guard must always be attached to the blade when the machine is be- ing transported or in storag...

13 S As you move forward to the next area to cut, be sure to maintain your balance and footing. Cut using the 2 o’clock to 4 o’clock position of the blade 2 o’clock 4 o’clock RECOMMENDED CUTTING POSITION WARNING: The operator or others must not try to clear away cut material with the engine running ...

14 WARNING: Inspect the area to be cultivated before starting the unit. Remove all debris and hard and sharp objects such as rocks, vines, branches, rope, string, etc. S Avoid heavy contact with solid objects that might stop the tines. If heavy contact occurs, stop the engine and inspect the unit fo...

15 S Do not operate the unit faster than the speed needed to prune. Do not run the unit at high speed when not pruning. S Always stop the unit when work is delayed or when walking from one cutting location to another. S If you strike or become entangled with a foreign object, stop the engine immedia...

16 1. Clean the cover and the area around it to keep dirt from falling into the carburetor chamber when the cover is removed. 2. Remove parts as illustrated. NOTE: Do not clean filter in gasoline or other flammable solvent to avoid creating a fire haz- ard or producing harmful evaporative emis- sion...

17 Idle Speed Adjustment Allow engine to idle. Adjust speed until engine runs without trimmer head moving or spinning (idle speed too fast) or engine stalling (idle speed too slow). S Turn idle speed screw clockwise to in- crease engine speed if engine stalls or dies. S Turn idle speed screw counter...

19 DECLARATION OF CONFORMITY EC Declaration of Conformity (Only applies to Europe) We, Husqvarna AB , SE-561 82 Huskvarna, Sweden, tel: +46--36--146500, as authorised representative in the Community, declare that the brushcutter model McCulloch 2500CXL with serial numbers dating from 2009 and onward...

20 TECHNICAL DATA SHEET M ODEL: 2500CXL Cylinder displacement, cm 3 25 At maximum engine power, rpm 8000 Maximum rotational frequency of the spindle 10000 Engine speed at recommended maximum spindle rotational frequency 7400 Recommended speed idling, rpm 2900 Maximum engine power, measured in accord...