MB QUART FX1.400 - Manual
MB QUART FX1.400 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Index; D-Class Mono Amplifiers; TECHNICAL DATA; General Instructions; WARRANTY; FOR EXTENDED WARRANTY INFORMATION, PLEASE VISIT
- Page 3 – Power and ground connections:
- Page 4 – LEVEL
- Page 5 – TROUBLE SHOOTING; Causes of overheating:
- Page 6 – Channel Full Range Stereo:; Interconnect cable checklist:; Switch setting checklist:; - Refer to the section; Minimum final loudspeaker impedances:
- Page 7 – Channel Full Range Stereo:; “Settings for Best Performance”
- Page 8 – Mono Amplifiers; Refer to the section; MONO; CHASSIS GROUND; DESIGNATED
System Design
The success of any car stereo system relies on several factors, such as
the system design, execution of the installation, and system setup. Please
remember that any system is only as good as its weakest link.
Please remember that higher power systems are not necessarily useful
purely for high sound pressure levels, but also to establish a headroom
capability, to reproduce musical peaks cleanly without distortion.
Lower power amplifiers will clip earlier than their more powerful cousins,
and cause loudspeaker failure when overdriven, due to the harmonics
generated by a clipped signal, thus overheating voice coils.
Amplifiers should be mounted with the fins running horizontally for best
convection cooling, to minimize overheating. Purchase the best quality
RCA cables you can afford, for reliability and less engine noise
interference in the audio system.
It is highly recommended that the amplifier be mounted to a board of MDF
or other solid structure using the 4 mounting screws provided. Avoid
mounting the amplifier to metal as this can introduce noise and other
unwanted issues. When mounting the amplifier, ensure that it is mounted
HORIZONTALLY, as shown in the diagram above, for optimal heat
dissipation. Mounting amplifiers to speaker enclosures is not
recommended as this can cause damage to the amplifier components.
When choosing a location for mounting the amplifier, ensure that you
check for clearance from wires, gas tank, electrical devices and brake
lines etc.
Congratulations!
By purchasing an amplifier from MB Quart, you have decided on a product
of the highest technical quality. MB Quart wishes you great enjoyment with
your amplifier. Should you have any questions about this system or other
MB Quart products, please email us at [email protected]
Installation Manual
WOOD
FORMULA
www.mbquart.com
FX2.60 / FX4.50 / FX4.70 / FX4.100 / FX1.400 / FX1.600
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Index 1 2 3 4 5 6 7 8 WARRANTY TROUBLE SHOOTING FX2.60 2-Channel Amplifiers FX4.50 / FX4.70 / FX4.100 4-Channel Amplifiers FX1.400 / FX1.600 D-Class Mono Amplifiers TECHNICAL DATA INSTALLATION INSTRUCTIONS General Instructions Settings for Best Performance 1 WARRANTY 1 FOR EXTENDED WARRANTY INFORMAT...
General Instructions INSTALLATION INSTRUCTIONS 2 General: Run the wiring so that RCA cables are at least 18“ away from power and speaker cables. Keep RCA cables away from electrical devices in the vehicle that can cause electrical noise, such as electric fuel pumps, emission control modules and othe...
Settings for Best Performance INSTALLATION INSTRUCTIONS 3 FX1.400 / FX1.600 General: At this point you are ready to get more specific on the settings for your amplifier. Subsonic: This setting acts as a low frequency cut off for your system bass reproduction. The point that you set it at cuts off an...
