Maytag MAT20MNAWW0 - Installation Manual

6 INSTALLATION INSTRUCTIONS It is necessary to remove all shipping materials for proper operation and to avoid excessive noise from washer. 1. Move washer to within 4 ft (1.2 m) of its final location; it must be in a fully upright position. NOTE: To avoid floor damage, set washer onto cardboard befo...

7 1. Move the washer to its final location. Place a level on top edges of washer. Use side seam as a guide to check levelness of sides. Check levelness of front using lid, as shown. Rock washer back and forth to make sure all four feet make solid contact with floor. LEVEL WASHER IMPORTANT: Level was...

8 8" (203 mm) Proper routing of the drain hose avoids damage to your floor due to water leakage. Remove drain hose from the washer basket 1. Remove cap from the washer drain port on the back of the washer. 2. If clamp is not already in place on elbow end of drain hose, slide it over end as shown...

9 DRAIN SYSTEM Drain system can be installed using a floor drain, wall standpipe, floor standpipe, or laundry tub. Select method you need. Floor standpipe drain system Minimum diameter for a standpipe drain: 2" (51 mm). Minimum carry-away capacity: 10 gal. (38 L) per minute. Top of standpipe mus...

10 CONNECT INLET HOSES Connect Inlet Hoses to Washer 1. Attach cold water hose to cold water inlet valve marked with a blue ring. Screw coupling by hand until it is snug. 2. Attach hot water hose to hot water inlet valve marked with a red ring. Screw coupling by hand until it is snug. 3. Use pliers ...

11 ELECTRICAL REQUIREMENTS n A 120-volt, 60 Hz., AC-only, 15- or 20-amp, fused electrical supply is required. A time-delay fuse or circuit breaker is recommended. It is recommended that a separate circuit breaker serving only this appliance be provided. n This washer is equipped with a power supply ...

12 INSTALLING COIN SLIDE AND COIN BOX The coin slide mechanism, service door lock and key, and coin box lock and key are not included with some models, but can be obtained from the usual industry sources.Remove the service door of the meter case by lifting it up at the back. Install the money-accept...

13 WASHER MAINTENANCE It is recommended that fiberglass items not be washed in coin-operated washers. If these items are washed in the washer, run the washer through a complete cycle to rinse any residue away that might be left in the washer. Operating Tips Transporting Your Washer n Shut off both w...

14 Contact your authorized Commercial Laundry distributor. To locate your authorized Commercial Laundry distributor, or for web inquiries, visit www.MaytagCommercialLaundry.com . If you cannot locate your distributor, the Commercial Laundry Support Center will answer any questions about operating or...

15 ELECTRONIC CONTROLS SET-UP INSTRUCTIONS Basic Operation of Commercial Washer n For additional information, see www.MaytagCommercialLaundry.com . IMPORTANT Electrostatic Discharge (ESD) Sensitive Electronics ESD problems are present everywhere. ESD may damage or weaken the electronic control assem...

16 ELECTRONIC CONTROLS SET-UP INSTRUCTIONS Control Set-Up Procedures IMPORTANT: Read all instructions before operating. The lower fabric setting key pads and the digital display are used to set up the controls. The display can contain four numbers and/or letters and a decimal point. These are used t...