Maxtor NAS 6000 - Manual
Maxtor NAS 6000 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – : Installation Requirements
- Page 3 – : Configure Your MaxAttach
- Page 4 – : Worldwide Support Contacts
Revision 2.0.03A
1
000001576
MaxAttach NAS 6000
MaxAttach NAS 6000
Quick Start Card
Quick Start Card
This Quick Start Card is only for a single MaxAttach NAS 6000 Base Unit
enclosed within a cabinet or a single rack-mountable Base Unit. For other
configurations, see the
MaxAttach NAS 6000
Installation and Configuration Guide
on the enclosed
MaxAttach NAS 6000 Installation and Documentation CD
.
Welcome to the
MaxAttach NAS 60 00
Thank you for choosing a MaxAttach NAS
6000 system. Take a moment to ver ify the
contents in your box and note the model
and serial numbers for future reference.
The procedures outlined here assume that
you have purchased a MaxAttach NAS
6000 Base Unit system enclosed within a
cabinet, or a rack-mountable MaxAttach
Base Unit system, and that you are highly
familiar with networking and system
administration basics. If not, please refer to either the appropr iate
Getting Started
Guide
based on your system’s configuration, or the
Installation and Configuration
Guide
on the enclosed CD.
Box Contents
E q ui p m e n t :
n
MaxAttach NAS 6000 file server (with rack mount hardware if required)
n
EMU/CPU Serial Cable (for rack mount systems)
n
Two AC power cords
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Revision 2.0.03A 2 000001576 D o cu m en t a t i o n : n Quick Start Card n MaxAttach NAS 6000 End User License Agreement (EULA) n MaxAttach NAS 6000 Release Notes n MaxAttach NAS 6000 Installation and Documentation CD containing: n MaxNeighborhood Discovery and Setup Wizard application n MaxAttach ...
Revision 2.0.03A 3 000001576 4: Reseat All Hard Disk Drives Reseat each hard drive to make sure shipping vibration has not dislodged them. Be sure to replace the dr ive in its original as-shipped Drive Bay. 1. Press down on the Ejector Tab and lift up on the Ejector Lever. 2. Pull the drive out of i...
Revision 2.0.03A 4 000001576 4. Click on Apply to commit the changes. The server will automatically reboot. 5. Close the Change Settings window. After the system has rebooted, press the Refresh button. 6. The factory default server name will begin with the letters “MA.” In the MaxNeighborhood window...
