Master Bilt TAF-74 ERC2 - Manual

Page 3 - TABLE OF CONTENTS; Inspection for ShippingDamage........................................................................................; INSTALLATION INSTRUCTIONS............................................................................................... 6; General

3 TABLE OF CONTENTS INTRODUCTION………………………………….…………………………………………………………………… 4 STORE CONDITIONS…………………………….……………….…..…………………………………………….. 4 WARNING LABELS AND SAFETY INSTRUCTIONS………..…..……………………………………………… 5 PRE-INSTALLATION INSTRUCTIONS………………………..…..………………………………….…………… 6 Inspection for ShippingDamage…………...

Page 4 - INTRODUCTION; case. A parts list is included in with this manual. Read all these; TAF ERC2; store. The store temperature should be at or below 75; TAF ERC2; NOTICE

4 INTRODUCTION Thank you for purchasing a Master-Bilt cabinet. This manual contains important instructions for installing, using and servicing a Master-Bilt TAF ERC2 case. A parts list is included in with this manual. Read all these documents carefully before installing or servicing your equipment. ...

Page 5 - WARNING LABELS AND SAFETY INSTRUCTIONS; Severe injury or death will occur if you ignore the message.

5 CAUTION! GROUND REQUIRED FOR SAFE OPERATION WARNING LABELS AND SAFETY INSTRUCTIONS This symbol is the safety-alert symbol. W hen you see this symbol on your cabinet or in this manual, be alert to the potential for personal injury or damage to your equipment. Be sure you understand all safety messa...

Page 6 - PRE-INSTALLATION INSTRUCTIONS; INSPECTION FOR SHIPPING DAMAGE

6 PRE-INSTALLATION INSTRUCTIONS INSPECTION FOR SHIPPING DAMAGE You are responsible for filing all freight claims with the delivering truck line. Inspect all cartons and crates for damage as soon as they arrive. If damage is noted to shipping crates or cartons or if a shortage is found, note this on ...

Page 8 - If cabinet must be located next to; Low Temperature Freezers – TAF Models; Programming

8 CONDENSATE PAN INSTALLATION FOR TOP MOUNT CABINETS ONLY 1. Before moving cabinet into place, remove the condensate pan from the top unit compartment. 2. Using the two screws supplied with the pan, attach the pan to the back of the cabinet at the two holes near the bottom of the plastic drain line....

Page 11 - Low temperature

11 Minimum Compressor On Time Con Minimum time that the compressor remain turned on Range: from 0 to 15 min 2 min. Alarm Delay ALrd Time delay before the alarm goes off after the temperature fall off the two alarm set points Range: from 0 to 59 min 30 – for LT 45 – for MT Compressor Run Time CPrn Ti...

Page 12 - ALHi; High temperature; dFIn; Press DOW N ten times to exit the programming level; Display Control; ERC Fault – software or hardware failure

12 High Temperature Alarm ALHi High temperature setpoint that will make the alarm go off and the error message appear on the display Range: from – 40 to 83 ° F or –40 to 23 ° C 50 ° F Important Note: To change from degrees C to F or vice-versa, the user must reprogram all the parameters that are rel...

Page 13 - SENSOR PROBE TEMPERATURE AND RESISTANCE

13 FINAL CHECK LIST A. Check operating pressures. B. Check electrical requirements of unit to supply voltage. C. Set temperature control for desired temperature range. D. Check system for proper defrost settings and operation. E. Check condensing unit for vibrating or rubbing tubing. Dampen and clam...

Page 14 - SERVICE INSTRUCTIONS (Trouble Shooting Guide)

14 SERVICE INSTRUCTIONS (Trouble Shooting Guide) 1. High head pressure and high back pressure: A. Condenser coil clogged or restricted. B. Condenser fan motor defective. 2. Low back pressure and low head pressure: A. Restriction in system. B. Refrigerant undercharged. C. Leak in system. 3. Pressures...

Page 15 - MASTER-BILT PART NUMBERS; TAF

15 MASTER-BILT PART NUMBERS The table below gives Master-Bilt part numbers. Use this chart when ordering replacement parts for your TAF ERC2 cases. Description TAF-27 TAF-48 TAF-74 Bulb 23-00343 23-00343 23-00343 Bulb Holder 23-01080 23-01080 23-01080 Bulb Shield 23-01465 23-01465 23-01465 Caster W ...

Page 16 - SALE AND DISPOSAL; OWNER RESPONSIBILITY

16 SALE AND DISPOSAL OWNER RESPONSIBILITY If you sell or give away your Master-Bilt cabinet you must make sure that all safety labels and the Installation - Service Manual are included with it. If you need replacement labels or manuals, Master-Bilt will provide them free. Contact the customer servic...

Master Bilt TAF-74 ERC2 - Manual

Table of Contents:

Summary

Other Master Bilt Models