Makita HR3000C - Manual - manualsarea.com

Page 2 - SPECIFICATIONS; Symbols; Read instruction manual.; Intended use; Sound pressure level (L; Wear ear protection

2 ENGLISH (Original instructions) SPECIFICATIONS Model HR3000C Concrete 30 mm Core bit 90 mm Steel 13 mm Capacities Wood 30 mm No load speed (min -1 ) 360 - 720 Blows per minute 1,650 - 3,300 Overall length 391 mm Net weight 5.1 kg Safety class /II • Due to our continuing programme of research and d...

Page 3 - EC Declaration of Conformity

3 used. • Be sure to identify safety measures to protect the operator that are based on an estimation of exposure in the actual conditions of use (taking account of all parts of the operating cycle such as the times when the tool is switched off and when it is running idle in addition to the trigger...

Page 5 - Switch action; Selecting the action mode; Rotation with hammering; a twist drill bit or wood bit.

5 14. Some material contains chemicals which may be toxic. Take caution to prevent dust inhalation and skin contact. Follow material supplier safety data. SAVE THESE INSTRUCTIONS. WARNING: DO NOT let comfort or familiarity with product (gained from repeated use) replace strict adherence to safety ru...

Page 6 - Hammering only; Torque limiter; ASSEMBLY; Side grip; Service indicator

6 Hammering only 1 2 003134 For chipping, scaling or demolition operations, depress the lock button and rotate the change lever so that the pointer points to the symbol. Use a bull point, cold chisel, scaling chisel, etc. CAUTION: • Do not rotate the change lever and/or shift lever when the tool is ...

Page 7 - Installing or removing the bit; symbol. Then make sure; Depth gauge

7 Installing or removing the bit 2 1 003150 Clean the bit shank and apply bit grease before installing the bit. Insert the bit into the tool. Turn the bit and push it in until it engages. 1 2 003160 If the bit cannot be pushed in, remove the bit. Pull the chuck cover down a couple of times. Then ins...

Page 8 - OPERATION; Hammer drilling operation; Set the change lever and the shift lever to the; Drilling in wood or metal; Drilling in wood; assembly

8 B i t d i ameter D ust c up 5 6 mm - 14. 5 mm D ust c up 9 1 2 mm - 1 6 mm 006406 OPERATION Hammer drilling operation 003198 Set the change lever and the shift lever to the symbol. Position the bit at the desired location for the hole, then pull the switch trigger. Do not force the tool. Light pre...

Page 9 - MAINTENANCE; Replacing carbon brushes; cover

9 serve to damage the tip of your bit, decrease the tool performance and shorten the service life of the tool. MAINTENANCE CAUTION: • Always be sure that the tool is switched off and unplugged before attempting to perform inspection or maintenance. • Never use gasoline, benzine, thinner, alcohol or ...

Page 10 - ACCESSORIES

10 1 003246 Reinstall the crank cap and tighten with the hex wrench. Connect the connector and reinstall the handle. 1 2 3 003248 CAUTION: • Do not tighten the crank cap excessively. It is made of resin and is subject to breakage. • Be careful not to damage the terminals or lead wires especially whe...

Page 12 - Makita Corporation

12 Makita Corporation Anjo, Aichi, Japan www.makita.com 884253E223

Makita HR3000C - Manual

Table of Contents:

Summary

Other Makita Models