Lowrance LGC-4000 - Manual
Lowrance LGC-4000 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Mounting the LGC Module; Surface Mount
- Page 3 – Powering Your GPS Module; Your LGC GPS module is powered by the NMEA 2000 network, so your net; Expanding a NMEA 2000 network; If you want to expand your NMEA 2000 network by adding more devices,
- Page 4 – Notes
- Page 8 – How to obtain service outside Canada and the U.S.; Accessory Ordering Information
1
Pub. 988-0154-65C
LGC-4000 & LGC-Baja
GPS Modules
Installation Instructions
This document covers the installation of the LGC-4000 or LGC-Baja GPS
modules and how to connect them to a NMEA 2000 network.
All Lowrance NMEA 2000 capable devices are either NMEA 2000 certified
or certification is pending. See our web site for the latest product status
information.
LGC-
4000 Module, bottom view (left) and top view (right).
The LGC module consists of a male threaded cable connector and the GPS
module. The GPS module contains a 16-parallel channel GPS+WAAS receiver.
The cable length from the connector to the GPS module is 18 inches (45.7 cm.
The module packs with a 15’ extention cable, a T connector and parts needed to
mount the module on a flat surface or on a pole.
CAUTION:
You should read all of the installation
instructions before proceeding. Decide where to install all
components before drilling holes in your vessel or vehicle
.
!
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 Tools and Supplies Recommended tools include pliers and a flathead screwdriver. If you need to route the module connector through a bulkhead, you will need a drill and a 7/8” (22 mm) drill bit. If you are mounting the module directly to flat, horizontal surface, you will need a #31 (3 mm) drill bi...
3 Pole Mount The GPS module attaches to the pole mount adapter with the supplied 4 mm screws. You can route the cable through the notch in the module housing and down the side of the pole or you can pass it through the pole mount adapter and run the cable inside the pole. The 1”-14 threads on the po...
