Lowrance LDT-3003 - Manual

Lowrance LDT-3003 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

Page 3 – The LDT-3003 can use the following sensors:
Page 5 – Set Clock
Page 7 – Set Fahrenheit or Celsius
Page 8 – Please include your name, address, and daytime telephone number.
Page 9 – Accessory Ordering Information; or call
Page 10 – LOWRANCE ELECTRONICS
Page 11 – Accessory Ordering Information - All Countries
Page 12 – replacement parts. If you're in the United States

Loading the manual

LDT-3003

Installation and Operation

Instructions

The LDT-3003 combines a clock, hour meter, voltmeter, and up to three
temperature sensors in one housing. (Since the LDT-3003 is packed
with different options, you may not have all three temp sensors.) It
shows the temperature in either °F or °C, selectable by the user. This
unit fits in a standard 2 1/8" (54 mm) hole used by most marine equip-
ment manufacurers.

Mounting

The LDT-3003 mounts in any dash or flat panel that's at least 2 1/2" (64
mm) in diameter. To mount the unit, first make certain there is at least
3 3/4" (95 mm) from the

front of the dash to any obstruction behind the

dash. Also, be sure there is room to route the power and sensor cables.
The

maximum usable dash thichness is 1 1/8" (28.5 mm).

1234567

3 3/4" minimum

When you determine the location for the LDT-3003, drill a 2 1/8" (54
mm) hole in the dash. Slide the LDT-3003 through the hole from the
front of the dash. Align it so that it's straight, then tighten the two
screws with a phillips-head screwdriver.

Place the pushbuttons into the holes in the bezel and snap it on to the
LDT-3003. The unit is now ready for wiring.

DASH

T I G H T E N
THESE
SCREWS

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 3 - The LDT-3003 can use the following sensors:

3 WIRING Connect the wires as shown in the diagrams on the opposite page. TheLDT-3003 operates from 10 to 15 vdc (12-volt system). You can connectthe wires as shown in the diagram at the top of the page using only oneaccessory switch (not included), which switches the unit's lights on at thesame tim...

Page 5 - Set Clock

5 T3 Temperature If you have the T3 temperature sensor installed, itappears after T2. This sensor can also be mountedin a live well, on the hull to measure outside airtemperature, or just about any other location. Engine Hour Meter This shows the total number of hours the enginehas operated. It sens...

Page 7 - Set Fahrenheit or Celsius

7 You can turn the temperature alarm off by pressing the SET key until thetemperature alarm appears, then press the MODE key once, then pressthe SET key again. The word "OFF" appears on the display. Press theSET key to exit the set clock alarm. Set Fahrenheit or Celsius To change the tempera...