Lowrance 000-0124-69 - Manual
Lowrance 000-0124-69 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – General NMEA 2000 Installation Rules; Powering a NMEA 2000 Network; It is very important to use only one of these
- Page 3 – Adding Devices, a Network Node or Extension Cable; Power Node
- Page 4 – Compatibility; Bow; Small boat example
- Page 5 – Large boat example
- Page 6 – Blank Page
- Page 8 – How to Obtain Service...; ...outside Canada and the USA:; Accessory Ordering Information
NMEA 2000 Network
Installation Instructions
This instruction sheet covers the configuration and installation of a NMEA 2000
network.
HDS Units
If you have an HDS unit, you must make a one-time purchase of a NMEA 2000
Starter kit to create a NMEA 2000 network.
NMEA 2000 Starter kit (p/n: 000-0124-69)
2-ft extension cable
120 ohm male terminator
15-ft extension cable
120 ohm female terminator
2 T connectors
Power node
Inline Terminator Cable
Some Lowrance LCX and LMS units and LGC-3000 antennas pack with an inline
terminator cable — a cable with a 120 ohm terminator built into each end. You must
discard the inline terminator cable and purchase a NMEA 2000 Starter Kit if you
want to add more devices to that type of network.
Network Construction
To add a power node, display unit or device to a NMEA 2000
network, you MUST connect it to the bottom of a T connector
as shown in the diagram on the right.
The top of a T connector can be connected to other T
connectors, a terminator or to an extension cable that runs to
other T connectors in a different part of the boat.
NMEA 2000 Network Components
Nodes
T connector connected to a NMEA 2000 device
Terminators Male and female 120 ohm terminators are connected to
network at opposite ends of the NMEA 2000 backbone
Backbone
Consists of network cabling, T connectors and two 120
ohm terminators
Top of T connector
Bottom of T connector
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
General NMEA 2000 Installation Rules Only devices/sensors should be connected to the bottom of a T • connector; the connectors at the top of the T connector are only used for extension cables, terminators and other T connectors Power the Network only once • A terminator must be connected to each end...
To install a power node: Connect the black (ground) wire to a ground. 1. Connect the Red (positive) wire to a switched 12-volt power 2. source. Plug the black power node connector into the bottom of a T connector 3. on your NMEA 2000 network. Adding Devices, a Network Node or Extension Cable NMEA 20...
Compatibility NMEA 2000 Sonar/GPS combo units purchased in 2005 had Blue Style connectors. The Blue Style connectors can be used with NMEA 2000 Style connector display units and components with the purchase of an adapter cable. NAC-FRD2FBL (P/N: 000-0127-05): connects NMEA 2000 Style connector devic...
