Linksys SS210 - Manual - manualsarea.com

Page 2 - General Safety Precautions; draft control must be fully open

General Safety Precautions 1. If this solid-fuel room heater is not properly installed, a house fire may result. For your safety, follow the installation direc- tions. Contact local building or fire officials about restrictions and installation inspection requirements in your area. 2. Wear gloves du...

Page 3 - Table of Contents

Table of Contents General Safety Precautions ................................................................. Testing Information ...........................................................................4 Draft Requirements ............................................................................

Page 4 - Overfiring Damage; Selecting the Proper Venting System; A draft test should read greater than

4 Testing Information This manual describes the installation and operation of the Per- former™ S210 non-catalytic wood heaters. These heaters meet the U.S. Environmental Protection Agency’s emissions limits for wood heaters sold on or after July 1, 1990. This heater has been developed, tested and co...

Page 6 - Proper Venting System on Page 4 to assist you in choosing the; Components Required For Installations; Note: The cover plate is not necessary if a blower

6 Clearances to Combustibles WARNING: BE ABSOLUTELY SURE THE DISTANCE BE- TWEEN THE HEATER AND THE SURFACE OF ANY COM- BUSTIBLE CONSTRUCTION IS NOT LESS THAN SHOWN ON THE DIAGRAM BELOW. Floor Protection USA - The floor in front and under the heater must be protected with a minimum of 3/8” thick nonc...

Page 7 - Installation Clearances - Refer to Diagrams A, B and C

7 A B D L †E †E K C H I J Floor Protection FLOOR PROTECTION I M F F T Floor Protection G G K 48” Max. Depth Diagram C: Top View Corner Clearance, Stove and Flue to Wall NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE. 6” Ø Flue Collar PIPE INSTALLATION A B (1) C D (1) E† F (1,4) Single Wall Resi...

Page 8 - Outside Air Kit Installation; Figure 3). Install the outside air adapter box on the stove by slid-; Figure 3; Leg and Heatshield Installation; Note: The threaded rods used to bolt the legs to the stove are; Residential and Mobile Homes; Wear gloves during installation in case of; Leg Installation

8 NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE. Heatshield Mounting Holes Air Channel Front Figure 2 Figure 1 Outside Air Kit Installation To install the “Outside Air Kit,” position the clip so that the nut is directly above the hole punched in the back of the heatshield (See Figure 3). Insta...

Page 9 - Stove Installation; YOUR; Figure 4

9 NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE. Stove Installation 1. If not previously installed, install floor protection and move the heater into the desired location. 2. Position the stove on your floor protection in the exact location where it is to be located, making sure all minimum cl...

Page 10 - Pedestal Installation; Figure 5

10 NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE. 5. If required, install the Outside Air Kit (P/N 71112) as per the following instructions. To locate the hole in the hearth for outside air mark and cut a 4” (102 mm) hole in the hearth. The hole’s center should be 3” (76 mm) directly forward f...

Page 11 - Note: Installation of the baffle bricks and insulating blanket is

11 Post Installation Checks 1. Check that all chimney pipe joints are securely fastened. 2. Check that the heater is securely fastened to the floor (if applicable). 3. Make sure the intake vent has clear access to outside air (if applicable). 4. Make sure the outside air vent has been sealed properl...

Page 12 - and mark bricks with their numbers when removing.; Firebox Brick Layout as Viewed from the Front; Figure 6; Brick Sizes

1 NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE. 3. Included with the stove are two 15-1/4”x 11-1/2”x 1/2” thick ceramic fiber blankets. Install one blanket above the baffle brick and to each side of the support bracket. Make sure that the blankets are fully to the rear. 4. Next, install the f...

Page 13 - The cover plate is not necessary if a blower has never; CAUTION; Figure 9

1 NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE. Operating Hints 1. Burn only dry, well-seasoned wood for maximum heat output. In some states it is illegal to burn wet wood or anything other than clean, dry wood products. 2. Your stove is designed to operate with the door closed! Operate only ...

Page 14 - Starting and Maintaining a Fire

14 NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE. 4. Light the paper and allow sufficient time for the kindling to become fully engulfed in flames. Close the door. Your door may or may not need to be left slightly open during this process, depending on your stove model and chimney draft. Once ...

Page 17 - Maintenance; WARNINGS; Inspect and clean chimney and connector frequently.

17 Experiment with different loading configurations to achieve longer burns. Try loading the wood from side to side and nesting it in the ashes to prevent airflow under and around the wood. Fresh wood should be loaded to the back of the firebox or to the sides. Hot coals or half burned wood should b...

Page 18 - Troubleshooting; Problem; SMOKES WHEN; ) The draft control must be closed further.; PAINT GIVES OFF

18 Troubleshooting Problem Solution POOR DRAFT: Extend chimney in length or have the chimney realigned to the proper size flue. Oversized chimneys nor-mally have poor drafts. Remember, the stoves’ draft depend solely on the natural draft of the chimney (See Drafting section on Page 4). If your stove...

Page 19 - Do’s and Don’ts; Install or operate this stove before reading this manual.; fully opening; Close the door tightly during Burn-In Period.; Complete and return your warranty card.; DO; Enjoy the warm feeling of your new CountryTM Collection stove.

19 Do’s and Don’ts DO NOT: Install or operate this stove before reading this manual. DO NOT: Close the draft beyond the point at which the flames are completely extinguished. DO NOT: Open the stove door without fully opening the draft first. DO NOT: Burn driftwood or wood that has been in salt water...

Page 20 - Replacement Parts - Models SS10; Contact an Authorized Lennox Hearth Products dealer to obtain

0 Replacement Parts - Models SS10 Contact an Authorized Lennox Hearth Products dealer to obtain any of these parts. Never use substitute materials. Use of non-approved parts can result in poor performance and safety hazards. BLOWER PARTS H5658 Fan Blade (FSB700) H5657 Fan Cage (FSB700) H5660 Blower ...

Page 23 - Notes

Page 24 - WARRANTY

Printed in U.S.A. © 2007 by Lennox Hearth Products P/N 775,15M REV. C 05/008 Lennox Hearth Products reserves the right to make changes at any time, without notice, in design, materials, specifications, prices and also to discontinue colors, styles and products. Consult your local distributor for fir...

Linksys SS210 - Manual

Table of Contents:

Summary

Other Linksys Models