Page 2 - Copyright and Trademarks
ADSL2 Modem with USB and Ethernet Copyright and Trademarks Specifications are subject to change without notice. Linksys is a registered trademark or trademark of Cisco Systems, Inc. and/or its affiliates in the U.S. and certain other countries. Copyright © 2004 Cisco Systems, Inc. All rights reserve...
Page 3 - Table of Contents
ADSL2MUE Modem with USB and Ethernet Table of Contents Chapter 1: Introduction 1 Welcome 1 What’s in this Guide? 1 Chapter 2: Getting to Know the ADSL2 Modem 3 The Back Panel 3 The Front Panel 4 Chapter 3: Connecting the ADSL2 Modem 5 Overview 5 Connecting the Modem using an Ethernet Connection 5 Co...
Page 4 - Appendix D: Specifications
ADSL2MUE Modem with USB and Ethernet Appendix C: Glossary 28 Appendix D: Specifications 35 Appendix E: Warranty Information 36 Appendix F: Regulatory Information 37 Appendix G: Contact Information 39
Page 5 - List of Figures
ADSL2MUE Modem with USB and Ethernet List of Figures Figure 2-1: Back Panel 3 Figure 2-2: Front Panel 4 Figure 3-1: Modem 5 Figure 3-2: ADSL Connection 5 Figure 3-3: Ethernet Connection 5 Figure 3-4: Power Connection 5 Figure 3-5: USB Connection 6 Figure 4-1: XP Welcome 7 Figure 4-2: XP Complete 7 F...
Page 7 - Chapter 1: Introduction; Welcome
1 Chapter 1: IntroductionWelcome ADSL2 Modem with USB and Ethernet Chapter 1: Introduction Welcome Thank you for choosing the ADSL2 Modem. The Linksys ADSL2 Modem gives you an instant, high-speed connection to the Internet. ADSL technology lets you access the Internet using your existing phone lines...
Page 9 - Chapter 2: Getting to Know the ADSL2 Modem; The Back Panel
3 Chapter 2: Getting to Know the ADSL2 ModemThe Back Panel ADSL2 Modem with USB and Ethernet Chapter 2: Getting to Know the ADSL2 Modem The Back Panel The Modem's ports, where a network cable is connected, are located on the back panel. ADSL This ADSL port is where you connect your ADSL service. USB...
Page 10 - The Front Panel
4 Chapter 2: Getting to Know the ADSL2 ModemThe Front Panel ADSL2 Modem with USB and Ethernet The Front Panel The Modem's LEDs, where information about network activity is displayed, are located on the front panel. Power Green. The Power LED lights up when the Modem is powered on. Ethernet Green. Th...
Page 11 - Chapter 3: Connecting the ADSL2 Modem; Overview
5 Chapter 3: Connecting the ADSL2 ModemOverview ADSL2 Modem with USB and Ethernet Chapter 3: Connecting the ADSL2 Modem Overview In this chapter, you will connect the Modem to your ADSL line and to a computer in your home or business. You have a choice of using an Ethernet or USB connnection. Procee...
Page 12 - Connecting the Modem using a USB Connection
6 Chapter 3: Connecting the ADSL2 ModemConnecting the Modem using a USB Connection ADSL2 Modem with USB and Ethernet Connecting the Modem using a USB Connection 1. Connect one end of the phone cable to the ADSL (RJ-11 phone) port on the back of the Modem. (See Figure 3- 2.) Connect the other end of ...
Page 13 - Chapter 4: Installing the USB Driver; Windows XP
7 Chapter 4: Installing the USB DriverOverview ADSL2 Modem with USB and Ethernet Chapter 4: Installing the USB Driver Overview The first time you connect the Modem using a USB connection, you will need to install the USB driver. Installing the USB Driver If you are connecting the Modem to your compu...
Page 16 - Windows Millennium
10 Chapter 4: Installing the USB DriverInstalling the USB Driver ADSL2 Modem with USB and Ethernet Windows Millennium 1. Power on your computer. 2. Windows Millennium will automatically detect the ADSL2 Modem. Insert the User Guide and USB Drivers CD- ROM into your computer’s CD-ROM drive. 3. On the...
Page 19 - Chapter 5: Configuring the ADSL2 Modem; Internet Setup
13 Chapter 5: Configuring the ADSL2 ModemOverview ADSL2 Modem with USB and Ethernet Chapter 5: Configuring the ADSL2 Modem Overview The ADSL2 Modem has been designed to be functional right out of the box, with the default settings. However, if you'd like to change these settings, the ADSL2 Modem can...
Page 23 - Administration Tab; System Log
17 Chapter 5: Configuring the ADSL2 ModemAdministration Tab ADSL2 Modem with USB and Ethernet • Number of Address. Enter the maximum number of computers that you want the DHCP server to assign IP addresses to. This number cannot be greater than 253. By default, as shown in Figure 5-9, the range is 1...
Page 24 - Diagnostics; Factory Default
18 Chapter 5: Configuring the ADSL2 ModemDiagnostics ADSL2 Modem with USB and Ethernet Diagnostics Ping Test. This feature is used to find out if an IP Address is operating and available to receive and respond to traffic. • Ping Target IP. Enter the IP Address that you want to ping in the field. Thi...
Page 25 - Status Tab
19 Chapter 5: Configuring the ADSL2 ModemStatus Tab ADSL2 Modem with USB and Ethernet Status Tab Firmware Upgrade To upgrade the Modem’s firmware: 1. Go to the Linksys website at www.linksys.com/international and download the firmware that you want to use. Extract or unzip the file. 1. Click the Bro...
Page 27 - Appendix A: Troubleshooting; Common Problems and Solutions
21 Appendix A: TroubleshootingCommon Problems and Solutions ADSL2MUE Modem with USB and Ethernet Appendix A: Troubleshooting This appendix consists of two parts: “Common Problems and Solutions” and “Frequently Asked Questions.” Provided are possible solutions to problems that may occur during the in...
Page 30 - Frequently Asked Questions
24 Appendix A: TroubleshootingFrequently Asked Questions ADSL2MUE Modem with USB and Ethernet 7. The Power LED flashes continuously. The Power LED lights up when the device is first powered up. In the meantime, the system will boot up itself and check for proper operation. After finishing the checki...
Page 33 - Appendix B: Upgrading Firmware
27 Appendix B: Upgrading Firmware ADSL2 Modem with USB and Ethernet Appendix B: Upgrading Firmware The Modem’s firmware is upgraded through the Web-Utility's Security tab. Follow these instructions: 1. Download the firmware from Linksys's website at www.linksys.com/international . 2. Click Upgrade F...
Page 42 - Appendix E: Warranty Information
36 Appendix E: Warranty Information ADSL2 Modem with USB and Ethernet Appendix E: Warranty Information WARRANTY Linksys warrants to You that, for a period of two years (the “Warranty Period”), your Linksys Product will be substantially free of defects in materials and workmanship under normal use. Y...
Page 43 - Appendix F: Regulatory Information
37 Appendix F: Regulatory Information ADSL2 Modem with USB and Ethernet Appendix F: Regulatory Information FCC STATEMENT This product has been tested and complies with the specifications for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonab...
Page 46 - Appendix G: Contact Information; In Europe
39 Appendix G: Contact Information ADSL2 Modem with USB and Ethernet Appendix G: Contact Information Need to contact Linksys?Visit us online for information on the latest products and updates to your existing products at:http://www.linksys.com/international If you experience problems with any Linksy...
