Lindy ATA-133 - Manual
Lindy ATA-133 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – RAID - Redundant Array of Independent Disks
- Page 6 – Windows 98/Me Operating System
- Page 7 – Windows XP Operating System
- 1 -
Low Profile Ultra ATA-133 RAID PCI Host
1. Introduction
This Low Profile Ultra ATA-133 RAID PCI Host Adapter is a PCI to dual Ultra
A TA - 1 3 3 h o s t c o n t r o l l e r b o a r d w h i c h c a n s u p p o r t L o w p r o f i l e P C I a n d
regular size PCI both. It provides a 32bit, 33/66 MHz PCI interface on the
host side and dual, fully compliant Ultra ATA-133 ports on the device side to
access ATA Hard disk drive.
The board can be used to upgrade your desktop computer to have dual Ultra
ATA-133 Channels and support RAID 0, RAID 1 and RAID 0+1 features. It
c o m e s c o m p l e t e l y w i t h d r i v e r s f o r W i n d o w s 9 8 , W i n d o w s M i l l e n n i u m ,
Windows NT 4.0, Windows 2000 and XP.
RAID, Redundant Array of Independent Disks, greatly enhances two main
areas of data storage: performance and data integrity. By using RAID 0, also
known as Striping, performance of sustained data transfer rates is greatly
enhanced by simultaneously writing data to 2, 3 or 4 drives. The second
benefit of RAID is data redundancy. RAID 1, Mirroring, writes identical data
on two drives or sets of drives, thus protecting the data from a disk failure. If,
for any reason, one drive were to fail, your data is secure and available from the
mirrored second drive.
1.1. Features
1.1.1. PCI Interface
=
Compliant with PCI Specification, revision 2.2.
=
Integrated PCI DMA engines.
=
32 bit, 33/66MHz fully compliant PCI host interface.
1.1.2. High Speed Ultra ATA-133 Interface
=
Supports two independent ATA channels.
=
Supports ATA 133.
=
Supports full speed burst transfers on the ATA bus.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
- 2 - = Supports software-controlled ATA bus tri-state. = Supports device specific timing registers. = Supports device read-ahead and write-ahead capability under Virtual DMA. = Features one 256-byte FIFO (32-bit x 64 deep) per IDE channel for host reads and writes. = Features ATA to PCI interrupt m...
- 6 - the operating system boots, click on the Start button located at the bottom left hand corner of the Desktop, select Settings and then Control Panel . Find and click on the SCSI Adapters . Click Drivers and Add . The next window is asking for the location of the driver to be installed. Since th...
- 7 - 1. After computer restarts, insert floppy disk in floppy disk drive. 2. Double-click on My Computer. 3. Double-click on 3 1/2 Floppy [A:]. 4. Double-click on InstallSiIConfig.exe. 5. Follow on-screen instructions to complete installation. Note: Do NOT install in the Start Up folder. Choose the...
