Lindy 70918 - Manual - manualsarea.com

Page 2 - Introduction; System Requirements

Introduction Thank you for purchasing the RS-232 asynchronous serial PCMCIA card, an ideal solution for adding additional ports to a wide variety of portable systems. This Card Bus is your best solution to utilize the peripheral with serial port in an easy-to-use environment such as plug-n-play and ...

Page 3 - Driver Installation; Next

3 4.0 Pin Assignment 5.0 Driver Installation Windows NT4.0 1. Power up the system. 2. After inserting the Serial Card Bus into PCMCIA Type II slot successfully, please follow the instructions as below: 3. Please run the “ Install_Serial.exe ” program locate within folder of the attached driver CD : ...

Page 5 - Verifying Installation; Device Manager; ” to verify the driver installation completed.

5 5.0 Verifying Installation Please right click “My Computer”, select “Properties”, and “Hardware”, then “ Device Manager ” to verify the driver installation completed. If there is any yellow exclamation mark on "PCcard OX16CF950", please remove this item from the Device Manager by clicking ...

Page 6 - Configure COM Port; Select the COM Port which you want to configure, for example COM4.; Properties; Stop bits and Flow control options, then select “; Advanced Setting; ” to

6 6.0 Configure COM Port 1. Select the COM Port which you want to configure, for example COM4. Right check the mouse, and select the “ Properties ”. 2. You can configure different operating settings through selecting the “ High Speed Communications Port ” properties pages. 3. Please select “ Setting...

Page 7 - FIFOs; ” change the length of receiver and transmitter FIFO.; value, a receiver data interrupt is triggered.

7 3. You can select “ FIFOs ” change the length of receiver and transmitter FIFO. This page is used to configure the FIFO trigger levels, i.e. at what fill levels the device will generate an interrupt, or apply automatic flow control. In addition, the FIFO can be completely disabled; although this i...

Page 8 - Data Rate; ” change the crystal Frequency of input clock.

8 4. You can select “ Data Rate ” change the crystal Frequency of input clock. This page provides a list of common crystal values used with COM ports. Select “Detect crystal frequency” to detect the input clock frequency to the UART. (This requires that the port is not currently in use by another ap...

Lindy 70918 - Manual

Table of Contents:

Summary

Other Lindy Models