Life fitness SU50 - Manual
Life fitness SU50 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Seated Row SU50 Customer Assembly Instructions; Bolt holes on Seat
- Page 3 – INCLUDED PARTS; ASSEMBLING THE SU50; Line up the Weight Stack Subframe and the Seat Subframe sections.; Line up the; Figure 3. Lined up sections of the Seated Row SU50.; Slide the flat
- Page 4 – Moving to the W eight Stack Subframe side of the SU50, place end cap
- Page 5 – INSTALLLING THE CABLE; Once the W eight Stack Subframe is bolted to the Seat Subframe
- Page 6 – Thread the 7/8” nut up on the cable bolt as shown in; Figure 8. Screw the cable into the weight stack.; From the weight stack, run the cable through
- Page 7 – Replace the; Figure 10. Pulley bolt assembly configuration.
M051-K50-A104
1
SEATED ROW SU50
ASSEMBLY INSTRUCTIONS
The Seated Row SU50 comes disassembled in two pieces. Follow the steps below to
assemble it.
TOOLS NEEDED
9/16”
socket wrench
9/16”
box wrench
7/8” open end
wrench or
crescent wrench
15 min
45 min
30 min
1 hr
ASSEMBLY TIME
One person can accomplish this assembly in approximately ½ hour.
UNPACKING AND PARTS
CAUTION:
ASSEMBLING THE SEATED ROW SU50 REQUIRES THE ABILITY TO
MOVE HEAVY COMPONENTS. THE WEIGHT STACK SUBFRAME OF THE SU50 IS
LARGE AND HEAVY AND MAY CAUSE INJURY OR DEATH IF IT FALLS ON
SOMEONE. USE CAUTION WHEN ASSEMBLING THIS MACHINE.
1. Unpack the Weight Stack Subframe and the Seat Subframe from the crate.
Stand
the W eight Stack Subframe up on its four feet. Stand the Seat Subframe up as shown in
Figure 1. Remove the cable and bolts pack.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Seated Row SU50 Customer Assembly Instructions 2 Figure 1. Seated Row SU50. 1. Bolt holes on Seat Subframe 2. Bolt holes on W eight Stack Subframe 3. Cable Pulleys 4. Cable 0 1 2 3 4 5 6 ½ ½ ½ ½ ½ ½ Figure 2. Configuration for bolts, end caps, washers and nuts.
Seated Row SU50 Customer Assembly Instructions 3 INCLUDED PARTS Included parts are: 1. 3-3/4” Hex head bolts (4) 2. End caps (bolt covers) (8) 3. Flat washer (used to “shorten” bolt so end cap will fit on the nut) (4) 4. End cap washers (end caps snap onto them) (8) 5. 3/8” Locknut (4) 6. Cable (1) ...
Seated Row SU50 Customer Assembly Instructions 4 Figure 4. Bolt (viewed from the Seat Subframe section). 3. Tighten the nuts. Moving to the W eight Stack Subframe side of the SU50, place end cap washers and nuts onto the four bolt ends. Tighten the nuts so that they are completelyover the threads of...
