Page 2 - Protection against creases; More economical by Intelligent Wash System
2 roduct Features P ontents C Warnings....................................................................................3 Specifications.............................................................................4 Installation..........................................................................
Page 3 - arnings; GROUNDING INSTRUCTIONS; IMPORTANT SAFETY INSTRUCTIONS; SAVE THESE INSTRUCTIONS; WARNING
3 arnings W For your safety, the information in this manual must be followed to minimizethe risk of fire or explosion, electric shock, or to prevent property damage,personal injury, or loss of life. ! READ ALL INSTRUCTIONS AND EXPLANATION OF THE INSTALLATION BEFORE USE WARNING! ❊ Do not push on the ...
Page 4 - pecifications; Accessories
4 pecifications S Spanner Inlet hose(2EA) ■ Accessories ■ Name : Front loading washing machine ■ Power supply : 220-240V~,50Hz ■ Size : 600mm(W) 550mm(D) 850mm(H) ■ Weight/Max.Watt : 58kg / 2100W ■ Wash capacity : Refer to the Rating Label ■ Water consumption : 64 ℓ ■ Permissible water pressure : 1....
Page 5 - nstallation; . To prevent internal damage during; Transit bolts
5 nstallation I 1 . To prevent internal damage during transport, the special 4 bolts are locked.Before operating the washer, remove the bolts along with the rubber bungs. • If they are not removed, it may cause heavy vibration, noise, malfunction andsevere damage. 3 . Take out the 4 bolts along with...
Page 6 - Installation place requirement; materials under the washer.
6 nstallation I Laundry Tub Washer approx. 2cm Drain Hose Installation place requirement Positioning Install the washer on a flat hard floor. Timber base and suspended type floors can causeexcessive vibration and noise.Make sure that air circulation around the washer is not impeded by carpets,rug et...
Page 7 - Electrical connection; CAUTION concerning the Power Cord
7 nstallation I Hot water tap Cold Hot Cold water tap ▶ Water supply pressure must be between 30kPa and 1.0-8 bar (100-800kpa) ▶ Don’t strip or crossthread when connecting Inlet hose to the valve. ▶ If the water supply pressure is more than 800kPa, a pressure reducingdevice device should be installe...
Page 8 - Normal Tap without thread & screw type inlet hose
8 nstallation I Normal Tap without thread & screw type inlet hose Normal Tap without thread & one touch type inlet hose (Single inlet models) 1. Unscrew the fixing screw toattach the tap. 2. Push the connector up till therubber packing is in tight contactwith the tap. Then tighten the 4screw...
Page 9 - Installation of drain hose
9 nstallation I Installation of drain hose • The drain hose should not be placed higher than 100 cm above the floor. • Proper securing of the drain hose will protect the floor from damage due towater leakage. • do not force it back into the machine. This will case abnormal noise and damage thedrain ...
Page 10 - Level adjustment; Concrete floors
10 nstallation I Level adjustment Concrete floors Wooden floors (Suspended floors) 1. Adjusting the washing machine level properly prevents excessivenoise and vibration.Install the appliance on a solid and level floor surface, preferably in acorner of the room. 2. If the floor is uneven, adjust the ...
Page 11 - are before washing; Caring before washing
11 are before washing C 1. Care Labels Look for a care label on your clothes. This will tell you about the fabric content of your garment andhow it should be washed. 2. Sorting To get the best results, Sort clothes into loads that can be washed with the same wash cycle.Water temperature and spin spe...
Page 12 - dding detergent; The Dispenser Drawer; Adding detergent and fabric softener
12 dding detergent A • Main wash only ➔ • Pre Wash + Main Wash ➔ • Do not exceed the maximum fill line. Close the dispenser drawer slowly.Overfilling can cause early dispensingof the fabric softener which could stainclothes. • Do not leave the fabric softener in the detergent drawer for more than 2 ...
Page 13 - • The detergent should be used according to the; • A water softener, such as Anti limescale; * For best washing results, we recommend to; ) Open the door and place Tablets into; ) Close the door and set the desired
13 dding detergent A • The detergent should be used according to the instruction of the detergent manufacture. • If too much detergent is used, too many suds can occur and this will decrease the washing resultor cause heavy load to the motor. (Causingmalfunctions) • If there are too many suds, the d...
Page 14 - unction; Recommended courses according to the laundry type; Program
14 unction F Recommended courses according to the laundry type ❋ Water Temperature : Select the water temperature to the wash cycles. Always follow garment manufacture’s care label or instructions when laundering. ❋ Medic Rinse : For a 40 degree final rinse water temperature, you can choose Medic Ri...
Page 15 - ow to use washer; • Initial conditions; • Press the Power button to start.; • Select the desired program cycle and options; Cotton automatically
15 ow to use washer H • Press the Power button to start. • Press the Start/Pause button. • Initial conditions - Wash : main wash - Rinse : 3 times - Spin : • 1300 rpm [WD13020D] • 1200 rpm [WD12020D] • 1100 rpm [WD11020D] - Water temperature : 40˚C - Program : Cotton • Press the Power button to star...
Page 16 - Power; Initial program; - By turning the Program dial, the program is
16 ow to use washer H (1) Dial : Program(2) Button : Start / Pause(3) Button : Spin(4) Button : Temperature (5) Button : Power(6) Button : Medic Rinse(7) Button : Pre Wash(8) Button : Intensive (9) Button : Crease Care(10) Child Lock(11) Tub Clean(12) Button : Time Delay 1. Power 2. Initial Program ...
Page 17 - Detecting; Option; • By pressing the; The required lamp will light up for identification.; • If the laundry is heavily soiled “Intensive”
17 ow to use washer H Start/Pause Detecting • This Start/Pause button is used to start wash cycle or pause the wash cycle. • If temporary stop of wash cycle is needed, press the Start/Pause button. • When in Pause, the power is turned off automatically after 4 minutes. • NB. The door will not open b...
Page 18 - Child Lock; Tub Clean; NOTE: Do not add any detergent to the
18 ow to use washer H Child Lock If you choose to lock the buttons on the controlassembly to prevent tampering this functionmay be selected. • Child Lock can be set by pressing the Medic Rinse button and Pre Wash buttonsimultaneously. (About three seconds) • To deactivate Child Lock system, press Me...
Page 19 - Spin
19 ow to use washer H Spin [WD13020D] [WD12020D] [WD11020D] 2. No spin 3. Rinse Hold • Rinse Hold is selected by pressing the spin button repeatedly this functionleaves clothes in the machine;suspended in the water after the finalrinse without entering into spin. • To proceed through to a drain or s...
Page 20 - Time Delay; • According to the condition of water supply
20 ow to use washer H Water Temp. • By pressing the Temp. button, the watertemperature can beselected. - Cold - 30˚C / 40˚C / 60˚C / 95˚C • Water temperature can be selected according to the program. The required temperature lamp will light upfor identification.For the more detailed information, ple...
Page 21 - Display; Multi display; Special function display; Status Indicator
21 • If the machine encounters a fault during operation, the associated fault will bedisplayed. “ ” : Water pressure sensing error “ ” : Problem of overfilling water “ ” : Door is not closed “ ” : Over load in motor “ ” : Over load in motor “ ” : Water inlet trouble “ ” : Drainage trouble “ ” : Unba...
Page 22 - aintenance; The water inlet filter; Turn off the water tap.
22 aintenance M The water inlet filter - " " error message will blink on the control panel when water does not enter the detergent drawer. - If water is very hard or contains traces of lime deposit, the water inlet filter may become clogged.It is therefore a good idea to clean it from time t...
Page 23 - The drain pump filter; CAUTION; First drain using the drain hose and then open the pump filter to; Open the lower cover cap (
23 aintenance M 3 2 3 2 1 100 The drain pump filter ❋ The drain filter collects threads and small objects left in the laundry.Check regularly that the filter is clean to ensure smooth running of your machine. CAUTION First drain using the drain hose and then open the pump filter to remove any thread...
Page 24 - Dispenser drawer
24 aintenance M ■ Dispenser drawer ❋ After a while detergents and fabric softeners leave a deposit in the drawer. • It should be cleaned from time to time with a jet of running water.• If necessary it can be removed completely from the machine by pressing the catch downwards and by pulling it out. •...
Page 25 - Cleaning your washer
25 aintenance M ■ Cleaning your washer 1. Exterior Proper care of your washer can extend its life. The outside of the machine can be cleaned with warm water and a neutral non abrasive household detergent. Immediately wipe off any spills. Wipe with damp cloth. Try not to hit surface with sharp object...
Page 26 - roubleshooting guide; Symptom
26 roubleshooting guide ❋ This washing machine is equipped with automatic safety functions which detect and diagnose faults at anearly stage and react appropriatelyWhen the machine does not function properly or does not function at all, check the following points beforeyou contact your service provi...
Page 29 - erms of Warranty
29 erms of Warranty T What Is Not Covered: • Service trips to your home to teach you how to use the product. • If the product is connected to any voltage other than that shown on the rating plate. • If the fault is caused by accident, neglect, misuse or Act of God. • If the fault is caused by factor...
Page 30 - emo
