Page 2 - LG Plasma Monitor
2 What is a Plasma Display ? If voltage is inputted to gas in glass panels, ultraviolet rays is outputted and fused with a fluorescent substance. At thismoment, light is emitted. A Plasma Display is a next generation flat Display using this phenomenon. 160° - Wide angle range of vision A Plasma Disp...
Page 3 - Contents
After reading this manu-al, keep it in the placewhere the user canalways contact easily. Safety Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4 Equipment Connections and SetupControls of the Monitor . . . . . . . . . . . . . . . . . . . ....
Page 4 - Safety Instructions; WARNING
4 Safety Instructions Do not place the Monitor in direct sunlight or near heatsources such as heat registers, stove and so on. - This may cause a fire. Do not use the Monitor in damp place such as a bath-room or any place where it is likely to get wet. - This may cause a fire or could give an electr...
Page 5 - NOTE
5 This plasma display is designed to be mounted hori-zontally (wide viewing). Never touch the power plug with a wet hand. - This may cause an electric shock. Disconnect from the mains and remove all connec-tions before moving. Do not place the Monitor in a built-in installation suchas a bookcase or ...
Page 6 - Controls of the Monitor; Note : All cables shown are not provided with the Monitor,
Connection to PC Connection to AV equipment 6 AC INPUT (8 Ω ) EXTERNAL SPEAKER ( ) ( ) R COMPONENT(480i/480p) (DVD INPUT) AUDIOINPUT VIDEOINPUT AUDIOINPUT AUDIOINPUT RGB1 OUTPUT (PC OUTPUT) RGB1 INPUT (PC INPUT) RGB2 INPUT (DIGITAL RGB INPUT) RS-232C INPUT(CONTROL/SERVICE) ( ) ( ) L S-VIDEO (8 Ω ) E...
Page 7 - Watching External Equipments; RCA Type
AC INPUT (8 Ω ) EXTERNAL SPEAKER ( ) ( ) R RGB1 OUTPUT (PC OUTPUT) AUDIO INPUT RGB1 INPUT (PC INPUT) RGB2 INPUT (DIGITAL RGB INPUT) RS-232C INPUT(CONTROL/SERVICE) ( ) ( ) L (8 Ω ) EXTERNAL SPEAKER AV1 AV1 7 AC INPUT (8 Ω ) EXTERNAL SPEAKER ( ) ( ) R COMPONENT(480i/480p) (DVD INPUT) AUDIOINPUT VIDEOI...
Page 8 - Watching VCR; Watching external AV source; Watching DVD
8 Watching VCR (When the Interface board is installed.) The interface board(AP-50EA40/41) is not equipped on MT/MZ-50PZ42/43 series models. When connecting the Plasma Monitor with external equipments, match the colours of connecting ports (Video - yellow,Audio(L) - white, Audio(R) -red).Connect the ...
Page 9 - Connecting PC
9 • For further information regarding cable TV service, contact your local cable TV service provider(s).• To avoid picture noise (interference), leave an adequate distance between the VCR and monitor.• To avoid burning an image on the Monitor screen, don’t have a still picture on the screen for a lo...
Page 10 - Displayable Monitor Specification
10 Displayable Monitor Specification (Synchronization input form : separate) • DOS mode may not work depending on video card if using a DVI-I cable. (Synchronization input form : separate) < RGB1 mode > < RGB2 mode > Resolution 640x350 720x400 640x480 800x600 Horizontal Frequency(KHz) 31...
Page 11 - Controls of the remote control; Installing Batteries
11 Controls of the remote control - When using the remote control aim it at the remote control sensor of the Monitor.- There’s maybe defect in consecutive operation of remote control in specified brightness according to this monitor fea- ture. 1 2 3 4 5 6 7 8 0 9 POWER SLEEP INPUT SELECT PSM SSM ARC...
Page 12 - Accessories
12 D-sub 15 pin cable AS mark LG TV Owner’s Manual 1.5V 1.5V Alkaline batteries BNC-RCA adapter (optional) DVI cable Power cord 1 2 3 4 5 6 7 8 0 9 POWER SLEEP INPUT SELECT PSM SSM ARC PIP ARC PIP TWIN PICTURE SWAP MENU MUTE OK VOL POWER STOP PLAY FF REC REW P/STILL WIN.SIZE WIN.POSITION ZOOM + ZOOM...
Page 13 - Monitor Installation; Optional Extras
13 Monitor Installation Video cables Desktop Speaker stand Speakers PC audio cables • The Monitor can be installed in various ways such as wall mounting type, desktop type, etc..• Install this monitor only in a location where adequate ventilation is available. 3cm 10cm 6cm 10cm 10cm 3cm 10cm 10cm 10...
Page 14 - Turning on the Monitor; Turning on the Monitor just after installation; Menu language setup
14 Turning on the Monitor - When using the remote control, aim it at its sensor on the Monitor. Turning on the Monitor just after installation Turning on the Monitor (power cord is still connected) 1. Connect power cord correctly. 2. Press the ON/OFF button on the Monitor. At this moment, the Monito...
Page 15 - VIDEO Menu; Adjusting Auto Colour Control
15 VIDEO Menu - You can adjust picture contrast, brightness, colour, sharpness and tint to the levels you prefer.- PIP settings are not adjustable. 1. Press the MENU button and then D D / E E button to select the VIDEO menu. 2. Press the G G button and then D D / E E button to select the desired pic...
Page 16 - AUDIO Menu
16 AUDIO Menu 1. Press the SSM button to select the picture appearance setup. SSM (Sound Status Memory) 1. Press the MENU button and then D D / E E button to select the AUDIO menu. 2. Press the G G button and then D D / E E button to select the desired sound item. 3. Press the G G button and then F ...
Page 17 - TIME Menu; Setting the On/Off Timer; Auto Off; Setting the Clock
17 TIME Menu - Timer function operates only if current time has been already set.- Off-timer function overrides on-timer function if they are set to the same time.- The monitor must be in standby mode for the On timer to work. - To cancel Off/On Timer function Press the D D / E E button to select Of...
Page 18 - Orbiter; SPECIAL Menu
18 Child lock - The monitor can be set up so that it can only be used with the remote control. - This monitor programmed to remember which option it was last set to event if you turn the monitor off.- In Child lock ‘On’, if the monitor is turned off, press the INPUT SELECT button on the monitor or P...
Page 19 - Setting Picture Format; SCREEN Menu; Split Zoom
19 Auto adjustment (RGB1[PC] mode only) - Automatically adjusts picture position and minimizes image shaking. - Although the image is still not correct, your Monitor is functioning properly but needs further adjustment.- The Auto configure and the Manual config. functions don’t need to be run for RG...
Page 20 - Screen Position
20 Manual Configure (RGB1[PC] mode only) - If the picture isn’t clear after auto adjustment and especially that characters are still trembling, adjust the picture phase manually. - To correct the screen size, adjust Clock. 1. Press the MENU button and then D D / E E button to select the SCREEN menu....
Page 21 - PIP Function
Component Video 1 0 : 3 0 21 Watching PIP - PIP lets you view 2 different inputs (sources) on your monitor screen at the same time. One source will be large, and the other source will show a smaller inset image. - When you select RGB1 or RGB2 for main picture in PIP, you can watch video (AV1 or AV2)...
Page 22 - Selecting a source for the Twin picture; TWIN Picture; Main Picture Size Adjustment; Sub Picture Size Adjustment; Swapping the Twin Picture
22 Selecting a source for the Twin picture TWIN Picture Press the SUB INPUT button to select the input mode for thesub picture. Main Picture Size Adjustment Press the TWIN PICTURE button. • Each press of TWIN PICTURE button changes the screen display as shown below. Sub Picture Size Adjustment Press...
Page 23 - External Control Device Setup; Communication Parameters; RS-232C configurations
23 External Control Device Setup No. Pin name 1 No connection 2 RXD (Receive data) 3 TXD (Transmit data) 4 DTR (DTE side ready) 5 GND 6 DSR (DCE side ready) 7 RTS (Ready to send) 8 CTS (Clear to send) 9 No Connection 1 5 6 9 - Connect the RS-232C input jack to an external control device (such as a c...
Page 30 - Troubleshooting check list
30 Troubleshooting check list No output from one of the speakers • Adjust Balance in the AUDIO menu. (Refer to p.16) Strange sound from the Monitor • Typical sound due to normal Monitor operation, Monitor is not faulty. No picture & No sound • Check whether the Monitor is turned on. • Power cord...
Page 31 - Product specifications; MODEL; Power requirement
31 Product specifications MODEL Width (inches / mm) Height (inches / mm) Depth (inches / mm) Weight (pounds / kg) Power requirement Resolution Colour Temperature (In operation) Humidity (In operation) MT-50PZ40/H/A/B/K/R/S MZ-50PZ42/H/A/B/K/R/S MT-50PZ41/H/A/B/K/R/S MZ-50PZ43/H/A/B/K/R/S MT-50PZ43/H...
Page 32 - PLASMA MONITOR; OWNER’S MANUAL
Please read this manual carefully before operating your set. Retain it for future reference.Record model number and serial number of the set. See the label attached on the back cover and quote this infor-mation to your dealer when you require service. Model number : Serial number : PLASMA MONITOR OW...
