Lenco CR-334 - Manual - manualsarea.com

Page 2 - IMPORTANT SAFETY INSTRUCTIONS; GREETINGS

2 TO PREVENT FIRE OR SHOCK HAZARD, DO NOT USE THIS PLUG WITH AN EXTENSION CORD, RECEPTACLE OR OTHER OUTLET UNLESS THE BLADES CAN BE FULLY INSERTED TO PREVENT BLADE EXPOSURE. TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. IMPORTANT SAFETY INSTRUCTIONS 1.) Read thes...

Page 3 - Before Setting Up the Unit; Unpacking and Setting Up

3 Before Setting Up the Unit • Operate controls and switches as described in the manual. • Before turning on the power, make certain that the power cord is properly installed. • When moving the set, be sure to first disconnect the AC power cord. • Avoid installing this unit in places exposed to dire...

Page 4 - LOCATION OF CONTROLS AND INDICATORS

4 LOCATION OF CONTROLS AND INDICATORS 1.) ALARM 1 Time (Month/Date) Display 2.) DIMMER ( HIGH - LOW-OFF/WAVE ) Selector Switch 3.) ALARM 2 ( RADIO / BUZZER / OFF ) Selector Switch 4.) ALARM 1 ( RADIO / BUZZER / OFF ) Selector Switch 5.) Time Display 6.) WAVE SENSOR 7.) DAY OF WEEK ( MON , TUE , WED ...

Page 5 - Setting The Time, The First Time

5 Setting The Time, The First Time IMPORTANT: The first time you connect your new automatic time setting clock radio to the AC outlet, the internal computer will automatically set the time for the area you live which is the initial default setting. The displays will scroll for a few seconds and then...

Page 7 - Checking The Wake Up Times and Alarm Mode; Antenna Information

7 To check the Alarm Mode setting for Alarm 1, press the ALARM 1 setting button. The ALARM 1 display will show the Alarm 1 wake up time and the day of the week indicators will show you the alarm mode which is selected. • If all 7 indicators are ‘On’, the Everyday mode is selected. • If only the Mond...

Page 8 - Wake To RADIO

8 Wake To RADIO 1.) Turn the radio ‘On’ by pressing the RADIO ON/OFF button and select the Band, Station, and volume level that you wish to hear when the alarm comes on, then turn the radio ‘Off’ again. 2.) Reconfirm the wake up time and alarm mode settings for the alarm you are using, Alarm 1, Alar...

Page 10 - SLEEP To Music Timer

10 SLEEP To Music Timer You can program the sleep timer to play the radio for up to “99” minutes and then shut off automatically. 1.) Press the SLEEP button. The display will briefly show “ L:30 ” and the radio will begin to play. After 30 minutes the radio will shut ‘Off’ automatically. 2.) To incr...

Page 11 - Changing The Lithium Battery

11 NOTES: A.) The clock radio must be at room temperature for the WAVE SENSOR to function properly. If the radio has been in a cold location the WAVE SENSOR may not operate immediately. Place the radio in the room where it will be used, connect it to the AC outlet, and allow approximately 30 minutes...

Page 12 - CARE AND MAINTENANCE

12 If you do not change the built-in lithium battery within a reasonable period of time after you see the warning indicator, the lithium battery may become exhausted and will no longer be able to supply back up power to the automatic time setting system internal computer. If the unit is disconnected...

Lenco CR-334 - Manual

Table of Contents:

Summary

Other Lenco Models