Launch CReader 319 User Manual

Page 2 - End User License Agreement

LAUNCH CReader 319 User’s 2 End User License Agreement IMPORTANT: PLEASE READ THIS END USER LICENSE AGREEMENT CAREFULLY. USING LAUNCH OR LAUNCH-SUPPLIED PRODUCTS AND SOFTWARE CONSTITUTES ACCEPTANCE OF THIS AGREEMENT.LAUNCH IS WILLING TO LICENSE THE PRODUCTS, INFORMATION, SOFTWARE AND DOCUMENTS (COLL...

Page 4 - business; General Notice; Disclaimer; Safety Precautions and Warnings; safety precautions at a minimum whenever working on a vehicle:

LAUNCH CReader 319 User’s 4 Customer Records. Customer grants to LAUNCH and its independent accountants the right to examine Customer’s books, records and accounts during Customer's normal business hours to verify compliance with this Agreement. In the event such audit discloses non- compliance with...

Page 7 - OBD II Readiness Monitors

LAUNCH CReader 319 User’s 7 2.3 Location of the Data Link Connector (DLC) The DLC (Data Link Connector or Diagnostic Link Connector) is the standardized 16-cavity connector where diagnostic code readers interface with the vehicle's on-board computer. The DLC is usually located 12 inches from the cen...

Page 8 - OBD II Monitor Readiness Status

LAUNCH CReader 319 User’s 8 strategy. Continuous Monitors -- Some of the vehicle components or systems are continuously tested by the vehicle’s OBD II system, while others are tested only under specific vehicle operating conditions. The continuously monitored components listed below are always ready...

Page 9 - OBD II Definitions; DTC; Enabling Criteria

LAUNCH CReader 319 User’s 9 monitors are constantly evaluating, they will be reported as “Ready” all of the time. If testing of a particular supported non-continuous monitor has not been completed, the monitor status will be reported as “Not Complete” or “Not Ready.” In order for the OBD monitor sys...

Page 10 - Freeze Frame Data

LAUNCH CReader 319 User’s 10 force the vehicle to run its onboard diagnostics. Some form of a drive cycle needs to be performed after DTCs have been erased from the PCM’s memory or after the battery has been disconnected. Running through a vehicle’s complete drive cycle will “set” the readiness moni...

Page 11 - Product Descriptions

LAUNCH CReader 319 User’s 11 3. Product Descriptions

Page 15 - Main Menu

LAUNCH CReader 319 User’s 15 4.2 Diagnostic Select [Diagnostic] in Main Menu and press [ok ] then screen will display Monitor Status interface as following figure 4-3 Press [ ] to back to the Main Menu of Diagnostic, the screen will display as following figure 4-4: Figure 4-4 14

Page 16 - Warranty; Order Information; Customer Service

16 LAUNCH Manuel d'utilisation Creader Figure 4-5 You can use [ ] [ ] key to change the first letter. It can be switched among “P”, “B”, “C” and “U”. And press [ ] moves the cursor to next. And then press [ ] [ ] key to input number. After you input the code number, press [ ] to view the definition ...

Launch CReader 319 - User Manual

Table of Contents:

Was this manual helpful?

About this manual

Summary

Ask a question