Lantronix A104 - Manual
Lantronix A104 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 3 – This device is equipped with a USOC RJ11C connector.
- Page 9 – modem and the ADSL network through a twisted-pair phone wire
- Page 59 – User Network Interface signaling for ATM communications.
Model Name: A104 (For Conexant Chipset)
Version: 1.0
FCC Part 68
FCC Part 15
Chapter 1.
Introduction
Chapter 1.1
Overview
Chapter 1.2
Features
Chapter 1.3
System Requirements
Chapter 2.
Installation
Chapter 2.1
Checklist
Chapter 2.2
The Front LEDs
Chapter 2.3
The Rear Ports
Chapter 2.4
Hardware Installation
Chapter 3
Configuration
Chapter 3.1
Determine your connection setting
Chapter 3.2
Connecting the ADSL Router to your network
Chapter 3.3
Configuring with Web Browser
Chapter 3.3.1
Status - Home page
Chapter 3.3.2
Status - ADSL Status
Chapter 3.3.3
Status - LAN
Chapter 3.3.4
Status - PPP
Chapter 3.3.5
Configuration - WAN Configuration
Chapter 3.3.6
Configuration - LAN Configuration
Chapter 3.3.7
Configuration - PPP Configuration
Chapter 3.3.8
Configuration - NAT Configuration
Chapter 3.3.9
Configuration - Virtual Server Configuration
Chapter 3.3.10
Configuration - DNS Configuration
Chapter 3.3.11
Configuration - Bridge Filtering Configuration
Chapter 3.3.12
Configuration - Save Settings
Chapter 3.3.13
Configuration - Reboot Without Saving
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
advance. But if advance notice isn't practical, you will be notified as soon aspossible. You will be advised of your right to file a complaint with the FCC. The telephone company may make changes in its facilities, equipment,operations, or procedures that could affect the proper operation of yourequ...
modem and the ADSL network through a twisted-pair phone wire This section describes how to connect and configure the ADSL router. Connect the router directly to the wall jack using the included ADSL cable. There are two methods to connect the router and workstation. The one usethe crossover Ethernet...
For routing purposes, IP networks can be divided into logical subnets by usinga subnet mask. Values below those of the mask are valid addresses on thesubnet. Transmission Control Protocol - The major transport protocol in the Internetsuite of protocols provides reliable, connection-oriented full-dup...
