Lanier 600-HP - Manual

Lanier Worldwide, Inc.

2300 Parklake Dr., N. E.

Atlanta, GA 30345-2979

Emergency Telephone:

(800)526-4371

MATERIAL SAFETY DATA SHEET

1

Section 1: Chemical Product and Company Information

Identity:

Toner for 6113, 6213, 6413, 6514

MSDS No.

CP-300

Product ID:

117- 0225

Issued:

9/17/98

Synonyms
& Common
Names:
Uses:

Chemical
Formula:

Toner, Black Toner for Lanier
M6113, 6213, 6413, 6514

M6113, 6213, 6413, 6514 Copier

Mixture, Inert resinated black
powder

Supersedes:

Date:

Prepared by:

European

Contact:

3/11/96
9/17/98
Lanier QA/EH&S Department

Lanier Worldwide

, WSM Europe,

Walter Fricke,
Im Taubental D-41468 Neuss,
Germany +49-2131-387-177

Section 2: Composition / Information on Ingredients

PERCENT

CAS No.

EXPOSURE LIMITS

SOURCE

Styrene-acrylic resin

85 ~ 90

25767-47-9

not listed

n/a

Carbon black

5 ~ 10

1333-86-4

3.5mg/m

3

3.5mg/m

3

OSHA PEL ACGIH TLV

Wax

1 ~ 5

9003-07-7

not listed

n/a

Organic pigment

1 ~ 5

102561-46-6

not listed

n/a

Silica

< 1

7631-86-9

not listed

n/a

*PEL of the product: 15mg/m

3

(total dust), 5mg/m

3

(respirable dust)

*TLV of the product: 10mg/m

3

(total dust), 5mg/m

3

(respirable dust)

Section 3: Hazards Identification

HMIS Rating:

FLAMMABILITY = 0 HEALTH = 0
REACTIVITY = 0 SPECIAL = none

Health Hazards (Acute, Chronic, Immediate and Potential):

Minimum irritation to respiratory tract may occur as with exposure to any non-toxic dust. May

cause gasping if inhaled. Inhalation should be avoided. May cause temporary eye discomfort.

Health Hazards of Long Term exposure (Chronic):

A manufacturer sponsored chronic inhalation study in rats using a special test toner revealed there

were no lung changes at all in the lowest exposure level (1mg/m

3

), the most relevant level to potential human exposures. A very slight degree of fibrosis was

noted in 25% of the animals at the middle exposure level (4mg/m

3

), while a slight degree of fibrosis was observed at the highest exposure level (16mg/m

3

) in

all animals. These findings are attributed to “Lung Overloading”, a generic response to excessive amount of any dust retained in the lungs for a prolonged
interval. The special test toner was ten times more respirable than commercially available toner to comply with EPA testing protocol and would not function
properly in xerographic equipment.

Section 4: First Aid Measures

Inhalation

:

Remove to fresh air if effects occur. Consult
local medical personnel

Eye Contact

:

In case of contact, immediately flush eyes with

water for 5 minutes.

Skin Contact

:

Wash with soap and water.

Ingestion

:

Dilute stomach contents with water. Call a

physician.

Section 5: Fire Fighting Measures

Suitable extinguishing media:

CO

2

, dry chemical, foam or water.

Extinguishing media which may not be used for safety reasons: none

This material will burn in case of fire.

The decomposition products are CO, CO

2

, and No

x

. Avoid inhalation of smoke.

Special protective equipment for fire fighters: none
UEL: n/a LEL: n/a