Kohler 8030A - Manual - manualsarea.com

Page 2 - DIMENSIONS; Please leave these instructions for the consumer.; BEFORE YOU BEGIN

2 1071288-AN2-F 09/03/12 DIMENSIONS 1/2" NPT 79 mm Min Clearance Center of Water Inlet 251 mm 67 mm 60 mm 217 mm 127 mm All information is based on the latest product information available at the time of publication. Kohler Co. reserves the right to make changes in product characteristics, packa...

Page 3 - Before you Begin; Before installation carefully inspect the new; Pressures; The minimum recommended operating pressure is 1.5 bar.; Plumbing Connections; Mixed

3 1071288-AN2-F 09/03/12 INSTALLATION SPECIFICATION Before you Begin 1. Turn off the water supply. 2. Make sure that the Watertile Rainshower is installed by a competent installer. 3. Before installation carefully inspect the new ﬁxture for any signs of damage. 4. Kohler Co. reserves the right to ma...

Page 4 - Install the Supply Pipework - Single Supply; flow

4 1071288-AN2-F 09/03/12 Install the Supply Pipework - Single Supply 1. Install the water supply pipes.2. Use the soldering template to construct a pressure balancing loop, this will ensure correct alignment with the product. Note! The loop pack is made from stronger pipe to give the pipework rigidi...

Page 5 - Install the Support Framework; pressure balancing assembly at the correct depth.; Install the Finished Ceiling; Install the

5 1071288-AN2-F 09/03/12 Install the Support Framework 1. Construct the support framework as shown in the above diagram. The 2 x 2 should be offset 30 mm from the edges of the 2 x 4’s to support the pressure balancing assembly at the correct depth. 2. Install the support framework under the pressure...

Page 6 - finished

6 1071288-AN2-F 09/03/12 Install the Waterway 1. Insert the concealing plate into the opening. The double ribs of the leak shields should be facing up. 2. If any of the leak shields make contact with an elbow, make sure t h a t y o u e n l a r g e t h e h o l e i n t h e b a c k o f t h e l e a k s ...

Page 8 - Install the Sprayface; finishes

8 1071288-AN2-F 09/03/12 6. Applying pressure evenly, press the membrane seal into the sprayhead groove. Install the Sprayface 1. Tilt the sprayhead downward so that the ribs on the top of the sprayhead are exposed. Note! For product with brushed ﬁnishes , align the brush pattern of the sprayfaces w...

Page 9 - SPARE PARTS

9 1071288-AN2-F 09/03/12 SPARE PARTS 1051681 Screen Washer 1036043 Shield Template 1055233 Adapter 1059024** Escutcheon 1055988 Gasket 1044060 O-Ring **Finish/color code must be specified when ordering. 1044058 O-Ring 1044059 O-Ring 1045772 Elbow 1047041 Washer 1059514 Screw 1036040 Spacer 1056104 S...

Page 10 - CARE AND CLEANING

10 1071288-AN2-F 09/03/12 1097221 Flow Control 1097222 Adapter 1080649 Kit - Pressure Balance Loop Like anything of lasting quality, Kohler tapware and ﬁttings require a certain amount of periodic care to preserve their lustrous ﬁnish . Clean your new Kohler tapware and ﬁtting s with a mild soap, ri...

Kohler 8030A - Manual

Table of Contents:

Other Manuals for Kohler 8030A

Summary

Other Kohler Models