Kidde 1276 - Manual

Kidde 1276

Kidde 1276 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
Page: / 7

Table of Contents:

  • Page 2 – CONTENTS OF THIS MANUAL; RECOMMENDED LOCATIONS FOR ALARMS; MOBILE HOME INSTALLATION; DIAGRAM “A”; DIAGRAM “B”
  • Page 3 – LOCATIONS TO AVOID; INSTALLATION INSTRUCTIONS; WIRING REQUIREMENTS; BATTERY INSTALLATION
  • Page 4 – always stand an arms length away from the unit when testing.; Tamper Resist Features; Smoke Alarm Tamper Resist Feature; Install; Battery Carrier Tamper Resist Feature; OPERATION AND TESTING; Standby Condition
  • Page 5 – Alarm Condition; ALARM REMOVAL; Alkaline type; YOUR ALARM SHOULD BE CLEANED AT LEAST ONCE A YEAR
  • Page 6 – LIMITATIONS OF SMOKE ALARMS; GOOD SAFETY HABITS; DEVELOP AND PRACTICE A PLAN OF ESCAPE; WHAT TO DO WHEN THE ALARM SOUNDS; NFPA REQUIRED PROTECTION
  • Page 7 – FIVE YEAR LIMITED WARRANTY; SERVICE AND WARRANTY; QUESTIONS OR FOR MORE INFORMATION
Loading the manual

A.C. Wire-in Single and/or Multiple Station (24 Devices) Ionization Smoke
Alarm with 9 Volt Battery Back Up and “HUSH” Control to temporarily
silence nuisance alarms.

Thank you for purchasing this smoke alarm. It is an important part of
your family’s home safety plan. You can trust this product to provide
the highest quality safety protection. We know you expect nothing less
when the lives of your family are at stake.

This alarm is interconnect compatible with the following alarms and
accessories:

·Smoke alarms: 1235, 1275, 1276, 1285, PE120, PI2000, KN-COSM-IB

·Heat alarm: HD135F

·CO alarms: KN-COB-IC, KN-COP-IC

·Relay modules: 120X, SM120X, CO120X

·Strobe Light: SL177I

See User’s Guides for specific application information.

For your convenience, write down the following information.

If you call our Consumer Hotline, these are the first questions

you will be asked.

Smoke Alarm Model Number (located on back of alarm):

Date Code (located on back of alarm). The National Fire Protection
Association (NFPA) and the manufacturer recommend replacing this alarm
ten years from the date code:

Date of Purchase:

Where Purchased:

Smoke Alarm

User’s Guide

For models: 1276

Manual P/N 820-0394 Rev. A

LISTED

1276

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 2 - CONTENTS OF THIS MANUAL; RECOMMENDED LOCATIONS FOR ALARMS; MOBILE HOME INSTALLATION; DIAGRAM “A”; DIAGRAM “B”

This product is designed to detect products of combustion using the ionization technique. It contains0.9 microcurie of Americium 241, a radioactive material. Distributed under U.S. NRC License No. 32-23858-01E. Manufactured in compliance with U.S. NRC safety criteria in 10 CFR 32.27. The pur-chaser ...

Page 3 - LOCATIONS TO AVOID; INSTALLATION INSTRUCTIONS; WIRING REQUIREMENTS; BATTERY INSTALLATION

WARNING: TEST YOUR SMOKE ALARM OPERATION AFTER R.V. OR MOBILE HOME VEHICLEHAS BEEN IN STORAGE, BEFORE EACH TRIP AND AT LEAST ONCE A WEEK DURING USE. 2. LOCATIONS TO AVOID • In the garage. Products of combustion are present when you start your automobile. • Less than 4” (10cm) from the peak of an “A”...

Page 4 - always stand an arms length away from the unit when testing.; Tamper Resist Features; Smoke Alarm Tamper Resist Feature; Install; Battery Carrier Tamper Resist Feature; OPERATION AND TESTING; Standby Condition

4. Plug the AC QUICK CONNECTOR into the back of the alarm (see Figure 3), making sure thatthe locks on the connector snap into place. Then push theexcess wire back into the electrical box through the hole in thecenter of the mounting bracket. 5. Install the alarm on the mounting bracket and rotate t...

Other Kidde Models

All Kidde Other