Kenwood SIRIUS DT-7000S- User Manual

Page 2 - DT-7000S Instruction Manual; Table of contents; Safety precautions; TO PREVENT FIRE OR ELECTRIC; CAUTION

DT-7000S Instruction Manual 2 Table of contents Congratulations ............................................................................................................2Box contents .................................................................................................................2...

Page 4 - Connecting the DT-7000S to your audio system

DT-7000S Instruction Manual 4 Connecting the DT-7000S to your audio system Use the cables supplied with the DT-7000S to make these connections. About the RS-232C connection: The RS-232C connection is provided to allow the DT-7000S to be controlled by compatible 3rd-par ty control systems. Kenwood re...

Page 5 - right; Finding a location for the optional Kenwood CX-SRH30 antenna; the best reception in your par ticular situation. See pg. 12

Due to the paths of the SIRIUS satellites over the US, the best location for the antenna will depend on what part of the country you live in, the orientation of your home, and the locations of any obstruc- tions that could prevent the satellite sig- nal from reaching the antenna. The best antenna lo...

Page 6 - Controls; Preset Bank Indicators:; unit and remote with

DT-7000S Instruction Manual 6 Controls and Features POWER Button (unit only): Turns the DT-7000S on and puts it into the Standby mode. Power Off/On Buttons (remote only): Emit discrete codes to turn the DT-7000S off and on. Category Jog Dial (unit)/CAT Buttons (remote): Puts the DT-7000S into the Ca...

Page 7 - Activating your SIRIUS subscription; Antenna Signal; Basic operation; Installing batteries in the remote; Normal Operation Screen; Using the remote

Activating your SIRIUS subscription Before you can listen to the DT-7000S, you must subscribe to SIRIUS Satellite’s service.1. Make sure that the DT-7000S is properly connected to your audio system and that the antenna is oriented to receive the SIRIUS satellite signal (see pages 4 – 5 for details) ...

Page 9 - Saving music information

the presets. Each time you change a preset its number will appear on the display and the stream will play. Option 2: Press the ENTER button. The Preset List Screen will appear on the display, listing all of the stream presets that have been programmed in all 4 banks ( right ) • Use the CH./PRESET jo...

Page 10 - below; Display options; Setup Mode

4. When one (or more) of the selected songs is playing on any stream, an aler t screen will be superimposed over the data on the original screen ( below ). • The number on the screen will count down from ‘10’ to ‘0’. To hear the song, press the ENTER button before the counter reaches zero; to make t...

Page 11 - Using the alarm; Auto Shutoff

5. When the display shows the correct hour and minute, press the ENTER button to turn the alarm on. 6. Press the MEMO button to save your settings. The Step 2—Set Stream screen will appear ( right ). 7. Use the CH/PRESET jog dial (unit) or press the CH buttons (remote) to move through the streams un...

Page 13 - Troubleshooting guide

DT-7000S Instruction Manual 13 Problem Possible Cause Solution No power on DT-7000S (display not illuminated) Power cord is not properly connected Make sure the power cord is properly connected No sound Audio and/or digital cable is not properly connected Incorrect input selected on receiver/control...

Kenwood SIRIUS DT-7000S- User Manual

Table of Contents:

Summary

Other Kenwood Models