Kenwood KVWA146SL - Manual - manualsarea.com

Page 3 - SECTION 1:BEFORE USING; SAFETY WARNINGS

SECTION 1:BEFORE USING SAFETY WARNINGS • Do not use a multiple socket or extension cord. • Do not insert a plug with damaged or broken cord into the socket. • If the cord is damaged it should be replaced by the manufacturer or aqualified service engineer in order to avoid a hazard. • Never remove th...

Page 4 - SECTION 2: INSTALLATION; REMOVAL OF TRANSPORTATION SCREWS; Do not install your machine on rugs or similar surfaces.

• If you are not using your machine for a long time, unplug from themains supply, close the water supply and leave the door open inorder to keep the inside of the machine dry and prevent unpleasantodours. • As a result of the quality control procedures, a certain amount ofwater may remain in your ma...

Page 5 - A B; ELECTRICAL CONNECTION; This model is designed for cold fill only.

• You can adjust the balance of your machine from its feet. • First, loosen the plastic adjustment nut by turning clockwise(A). • Adjust by rotating the feet upwards or downwards. • After the balance has been reached, tighten the plastic adjustmentnut again by rotating it counter clockwise(B). • Nev...

Page 6 - Be sure that water inlet hoses are not folded, broken or crushed.; WATER DRAIN CONNECTION; Never attempt to extend the water drain hose by adding extra parts.

• Water pressure of 1-10 bars from your tap will enable your machineto work more efficiently.(1 bar pressure means water flow of morethan 8 liters in 1 minute from a fully opened tap). • After connections are completed, check for leakage of the connectionjoints by turning on your tap completely. • B...

Page 7 - SECTION 3: GETTING TO KNOW YOUR WASHING MACHINE

SECTION 3: GETTING TO KNOW YOUR WASHING MACHINE 1 2 3 4 5 6 7 1-Upper tray 5-Handle 2-Detergent drawer 6-Filter cover 3-Control panel 7-Kickplate 4-Door 6

Page 8 - SECTION 4:CONTROL PANEL; START/PAUSE BUTTON; lights up on the electronic instrument.; WARNING; MODE BUTTON; During pause mode and at the end of a cycle the machine must be

SECTION 4:CONTROL PANEL 1 2 3 4 5 6 1-Detergent drawer 4-Electronic display 2-Mode button 5-Start/pause button 3-Select button 6-Program knob START/PAUSE BUTTON This key is used for starting a programme selected or pausing by anoperating programme. Once a programme selected is started, the symbol li...

Page 9 - clothes.This function is recommended to be used for your

FUNCTION BUTTONS Rinse hold This function is recommended to be used when the clothes cannot be taken immediately after the end of the program.This will prevent occurrence of wrinkles. When this button is pressed, the last rinsing water is not drained. For the program to continue from the same point,...

Page 10 - Adjusting wash water temperature; Adjusting the spin cycle; Ensure the spin setting is correct for delicate items.; Child lock; Adjustment of the programme start time; Time Indicator

Adjusting wash water temperature You can adjust the wash water temperature acording to the programme that you have selected, using this function. WARNING You can not set the wash water temperature into more than the temperature of the programme that you have selected. Adjusting the spin cycle Using ...

Page 11 - PROGRAM KNOB; STOP; Off

PROGRAM KNOB With the program knob, you can select the program with which you desire towash your clothes. You can adjust the program selection process by turningthe program knob in both directions. You must be careful that the adjustmentsign of the program knob is exactly on the program you want to ...

Page 12 - SECTION 5: WASHING YOUR LAUNDRY; First wash cycle

SECTION 5: WASHING YOUR LAUNDRY • Plug in the machine. • Open the water supply. First wash cycle We recommend the first wash cycle should be made without any laundry.Useprogramme 1 without any detergent. BEFORE WASHING • Arrange your clothes according to their types (cotton, synthetic,sensitive, woo...

Page 13 - THE WASHING MACHINE; Selection of the programme

Filling detergent in the machine The quantity of the detergent that you will fill in your machine depends on the following criteria: • Your detergent consumption will change according to the soil levelof your clothes. For your slightly dirty clothes, do not pre-wash andput a small amount of detergen...

Page 16 - To change additional function; To remove a selected function from the washing operation:; To change the programme; To remove a programme:; Cancelling the programme; If you want to finish a programme early:

To change additional function To remove a selected function from the washing operation: • Select the additional function by using the modekey. “ ON” signal will appear on the timeindicator. • Press the select key. “ OFF” signal will bedisplayed on the time indicator. The additional function you do n...

Page 17 - Completion of the programme; Turn the programme knob into the position 0 (stop

Completion of the programme • Your machine stops when the programme thatyou have selected finishes and “END” signal willappear on the time indicator. • Turn the programme knob into the position 0 (stop ). • The door lock of your machine will open itself about two minutes after theprogramme ends. Pul...

Page 21 - OPTION COMPATIBILITIES

OPTION COMPATIBILITIES Rinse Hold Extra Rinse Easy Ironing Plus Water Stain Remove Soak Rinse Hold YES NO YES YES YES Extra Rinse YES NO YES YES Easy Ironing YES YES YES Plus Water YES YES Stain Remove YES Soak 20

Page 22 - Remove the water inlet hose.; PUMP FILTER; Turn of the machine at the electricty supply.

SECTION 6: MAINTENANCE AND CLEANING • Unplug your machine. • Close the water tap. WATER INLET FILTERS On the tap part of your machine’s water inlet hose and at the ends of waterinlet valves, there are filters to prevent entrance of the dirt and foreignmaterials in the water to the machine. If the ma...

Page 23 - Danger of being scalded!; DETERGENT DRAWER; Wash with an old toothbrush and water.

WARNING! Danger of being scalded! The pump maybe hot, wait for it to cool. DETERGENT DRAWER Detergents may form a sediment in your detergent drawer or in housing of thedetergent drawer. To clean the sediment, pull out the detergent drawer: • Pull the detergent drawer to the end.(DIAGRAM-1) • Lift th...

Page 24 - Disconnect from the mains supply before cleaning.; THE DRUM; REMOVAL OF LIMESCALE FROM YOUR MACHINE

SIPHON PLUG Pull out the detergent drawer. Remove the siphon plug and clean theresidues of the softener thoroughly.Replace the plug. THE CABINET NOTE: Disconnect from the mains supply before cleaning. Clean the exterior surface of the cabinet of your machine with lukewarm waterand a cleaning substan...

Page 25 - SECTION 7:PRACTICAL INFORMATION-STAIN REMOVAL; Chocolate and cocoa:

SECTION 7:PRACTICAL INFORMATION-STAIN REMOVAL Alcoholic beverages: Wash with cold water, then wipe with glycerine and water. Rinse with water mixed with vinegar. Shoe Polish: Scratch the stain without ruining the cloth, rub with detergent and rinse. In case it is not eliminated, it should be rubbed ...

Page 26 - Mould; be washed with detergent.; SECTION 8: AVOIDING MINOR FAULTS; Contact a qualified engineer.

Mould : Mould stains should be cleaned as soon as possible. The stain should be washed with detergent. Ink: Hold the stained area under cold water and wait until the inky water completely runs off. Then rub with water diluted with lemon juice anddetergent, wash after 5 minutes. Fruit: Stretch the st...

Page 27 - Your fuse is defected.

FAILURE PROBABLE CAUSE METHODS OF ELIMINATION It is unplugged. Insert the plug into thesocket. Your fuse is defected. Change your fuse. Power is off. Check the electricpower. Start/pause button hasnot been pressed. Press the start/pausebutton. The program knob is inO(off) status. Bring the programkn...

Page 30 - SECTION 9: AUTOMATIC FAILURE DETECTION SYSTEM

FAILURE PROBABLE CAUSE METHODS OF ELIMINATION The spining process isnot done or starts withdelay . No failure. Anunbalanced load cancause this. The unbalanced loadcontrol system will tryto distribute yourclothes evenly. Afteryour clothes aredistributed the spiningprocess willbegin.Ensure the washloa...

Page 33 - SECTION 10: INTERNATIONAL WASHING SIGNS; Washing; SECTION 11:TECHNICAL SPECIFICATIONS

SECTION 10: INTERNATIONAL WASHING SIGNS Washing temparature. Do not wash (hand wash) Lukewarm iron. Medium hot iron. Hot iron. Do not iron. Do not tumble dry. Hang to dry. Drip dry. Dry flat. Do not bleach. Handy to bleach. All of these are dry cleaning symbols. The letters areto instruct the cleane...

Kenwood KVWA146SL - Manual

Table of Contents:

Summary

Other Kenwood Models