Page 3 - BASICS; How to reset
3 ENGLISH | KMM-100U BASICS To Do this (on the faceplate) Do this (on the remote control) Turn on the power Press L SRC . • Press and hold to turn off the power. Press and hold SRC to turn off the power.( Pressing SRC does not turn on the power. ) Adjust the volume Turn the volume knob. Press VOL or...
Page 4 - GETTING STARTED
4 GETTING STARTED Cancel the demonstration When you turn on the power (or after you reset the unit), the display shows: “CANCEL DEMO” \ “PRESS” \ “VOLUME KNOB” 1 Press the volume knob. [YES] is selected for the initial setup. 2 Press the volume knob again. “DEMO OFF” appears. Set the clock 1 Press t...
Page 5 - RADIO
5 ENGLISH | GETTING STARTED Default: XX PRESET TYPE NORM : Memorizes one station for each preset button in each band (FM1/ FM2/ FM3/ AM). ; MIX : Memorizes one station for each preset button regardless of the selected band. KEY BEEP ON : Activates the keypress tone. ; OFF : Deactivates. PANDORA SRC ...
Page 9 - Pandora®
9 ENGLISH | Pandora® (for KMM-100U ) To Do this Pause or resume playback Press 6 38 (or ENT 38 on RC-406). Thumbs up or thumbs down Press 1 / 2 . • If thumbs down is selected, the current track is skipped. Skip a track Press ¢ (or ¢ on RC-406). Create a new station 1 Press and hold the volume knob. ...
Page 10 - AUX; DISPLAY SETTINGS
10 AUX Preparation: Select [ON] for [BUILTIN AUX] . ( ➜ 5 ) Start listening 1 Connect a portable audio player (commercially available). 2 Press SRC to select AUX. 3 Turn on the portable audio player and start playback. Auxiliary input jack Portable audio player 3.5 mm (1/8") stereo mini plug wit...
Page 11 - AUDIO SETTINGS
11 ENGLISH | AUDIO SETTINGS While listening to any source... 1 Press the volume knob to enter [FUNCTION] . 2 Turn the volume knob to select [AUDIO CTRL] , then press the knob. 3 Turn the volume knob to make a selection (see the following table), then press the knob. Repeat step 3 until the desired i...
Page 12 - MORE INFORMATION; Maintenance
12 MORE INFORMATION General Detailed information and notes about the playable audio files are stated in an online manual on the following site: www.kenwood.com/cs/ce/audiofile/ Playable files • Playable Audio file: MP3 (.mp3), WMA (.wma), FLAC (.flac), WAV (.wav) • Playable USB device file system: F...
Page 13 - TROUBLESHOOTING
13 ENGLISH | Symptom Remedy Sound cannot be heard. • Adjust the volume to the optimum level.• Check the cords and connections. “PROTECT” appears and no operations can be done. Check to be sure the terminals of the speaker wires are insulated properly, then reset the unit. If this does not solve the ...
Page 14 - INSTALLATION / CONNECTION; Part list for installation
14 Warning • The unit can only be used with a 12 V DC power supply, negative ground.• Disconnect the battery’s negative terminal before wiring and mounting.• Do not connect Battery wire (yellow) and Ignition wire (red) to the car chassis or Ground wire (black) to prevent a short circuit. • Insulate ...
Page 15 - Basic procedure; How to remove the unit
15 ENGLISH | Basic procedure 1 Remove the key from the ignition switch, then disconnect the · terminal of the car battery. 2 Connect the wires properly. (See Wiring connection. ( ➜ 16) ) 3 Install the unit to your car. (See Installing the unit (in-dash mounting).) 4 Connect the · terminal of the car...
Page 16 - Wiring connection
16 ANT CONT P. CONT MUTE R L REAR/SW Wiring connection Fuse (10 A) Rear/subwoofer output Antenna terminal Rear ground terminal Car fuse box Car fuse box Battery Ignition switch Blue/White (Power control wire) Red (Ignition wire) Yellow (Battery wire) Black (Ground wire) To the metallic body or chass...
Page 17 - SPECIFICATIONS
17 ENGLISH | SPECIFICATIONS Tuner FM Frequency Range KMM-100 87.5 MHz to 108.0 MHz (50 kHz space) KMM-100U 87.9 MHz to 107.9 MHz (200 kHz space) Usable Sensitivity (S/N = 26 dB) 11.2 dBf (1.0 μV/75 Ω) Quieting Sensitivity (DIN S/N = 46 dB) 19.2 dBf (2.5 μV/75 Ω) Frequency Response (±3 dB) 30 Hz to 1...
Page 19 - FONCTIONNEMENT DE BASE; Comment réinitialiser
3 FRANÇAIS | KMM-100U FONCTIONNEMENT DE BASE Pour Faire (sur la façade) Faire (sur la télécommande) Mettez l’appareil sous tension Appuyez sur L SRC . • Maintenez la touche enfoncée pour mettre l’appareil hors tension. Maintenez SRC enfoncée pour mettre l’appareil hors tension.( Appuyer sur SRC ne m...
Page 20 - PRISE EN MAIN
4 PRISE EN MAIN Annulez la démonstration Quand vous mettez l’appareil sous tension (ou après une réinitialisation de l’appareil), l’affichage apparaît: “CANCEL DEMO” \ “PRESS” \ “VOLUME KNOB” 1 Appuyez sur le bouton de volume. [YES] est choisi pour le réglage initial. 2 Appuyez de nouveau sur le bou...
Page 26 - RÉGLAGES D’AFFICHAGE
10 AUX Préparation: Sélectionnez [ON] pour [BUILTIN AUX] . ( ➜ 5 ) Démarrez l’écoute 1 Connectez un lecteur audio portable (en vente dans le commerce). 2 Appuyez sur SRC pour choisir AUX. 3 Mettez sous tension le lecteur audio portable et démarrez la lecture. Prise d’entrée auxiliaire Lecteur audio ...
Page 27 - RÉGLAGES AUDIO
11 FRANÇAIS | RÉGLAGES AUDIO Pendant l’écoute de n’importe quelle source... 1 Appuyez sur le bouton de volume pour entrer [FUNCTION] . 2 Tournez le bouton de volume pour choisir [AUDIO CTRL] , puis appuyez sur le bouton. 3 Tournez le bouton de volume pour réaliser une sélection (voir le tableau suiv...
Page 28 - PLUS D’INFORMATIONS; Entretien
12 PLUS D’INFORMATIONS Généralités Des informations détaillées et des remarques à propos des fichiers audio pouvant être lus se trouvent dans le manuel en ligne disponible sur le site suivant: www.kenwood.com/cs/ce/audiofile/ Fichiers pouvant être lus • Fichier audio reproductible: MP3 (.mp3), WMA (...
Page 29 - EN CAS DE DIFFICULTÉS
13 FRANÇAIS | Symptôme Remède Le son ne peut pas être entendu. • Ajustez le volume sur le niveau optimum.• Vérifiez les cordons et les connexions. “PROTECT” apparaît et aucune opération ne peut être réalisée. Assurez-vous que les prises des fils d’enceintes sont isolées correctement, puis réinitiali...
Page 30 - INSTALLATION / RACCORDEMENT; Liste des pièces pour l’installation
14 Avertissement • L’appareil peut uniquement être utilisé avec une alimentation de 12 V CC, à masse négative.• Déconnectez la borne négative de la batterie avant le câblage et le montage.• Ne connectez pas le fil de batterie (jaune) et le fil d’allumage (rouge) au châssis de la voiture ou au fil de...
Page 31 - Procédure de base; Comment retirer l’appareil
15 FRANÇAIS | Procédure de base 1 Retirez la clé de contact, puis déconnectez la borne · de la batterie de la voiture. 2 Connectez les fils correctement. (Reportez-vous à Connexions. ( ➜ 16) ) 3 Installez l’appareil dans votre voiture. (Reportez-vous à Installation de l’appareil (montage encastré).)...
Page 32 - Connexions
16 ANT CONT P. CONT MUTE R L REAR/SW Connexions Fusible (10 A) Sortie arrière/caisson de grave Borne de l’antenne Borne arrière de masse Boîte de fusible de la voiture Boîte de fusible de la voiture Batterie Interrupteur d’allumage Bleu/Blanc (Fil de commande d’alimentation) Rouge (Câble d’allumage)...
Page 33 - SPÉCIFICATIONS
17 FRANÇAIS | SPÉCIFICATIONS Tuner FM Bande de fréquences KMM-100 87,5 MHz à 108,0 MHz (intervalle de 50 kHz) KMM-100U 87,9 MHz à 107,9 MHz (intervalle de 200 kHz) Sensibilité utilisable (S/B = 26 dB) 11,2 dBf (1,0 μV/75 Ω) Seuil de sensibilité (DIN S/N = 46 dB) 19,2 dBf (2,5 μV/75 Ω) Réponse en fré...
Page 35 - PUNTOS BÁSICOS; Cómo reinicializar
3 ESPAÑOL | KMM-100U PUNTOS BÁSICOS Para Hacer esto (en la placa frontal) Hacer esto (en el mando a distancia) Encender la unidad Pulse L SRC . • Pulse y mantenga pulsado para apagar la unidad. Pulse y mantenga pulsado SRC para apagar la unidad.( La unidad no se enciende pulsando SRC . ) Ajustar el ...
Page 36 - PROCEDIMIENTOS INICIALES
4 PROCEDIMIENTOS INICIALES Cancele la demostración Cuando enciende la unidad (o después de reinicializarla) la pantalla muestra: “CANCEL DEMO” \ “PRESS” \ “VOLUME KNOB” 1 Pulse la rueda de volumen. Se selecciona [YES] para la configuración inicial. 2 Pulse de nuevo la rueda de volumen. Aparece “DEMO...
Page 42 - AJUSTES DE VISUALIZACIÓN
10 AUX Preparativos: Seleccione [ON] para [BUILTIN AUX] . ( ➜ 5 ) Comience a escuchar 1 Conecte un reproductor de audio portátil (disponible en el mercado). 2 Pulse SRC para seleccionar AUX. 3 Encienda el reproductor de audio portátil e inicie la reproducción. Toma de entrada auxiliar Reproductor de...
Page 43 - AJUSTES DE AUDIO
11 ESPAÑOL | AJUSTES DE AUDIO Mientras se escucha desde cualquier fuente... 1 Pulse la rueda de volumen para ingresar en [FUNCTION] . 2 Gire la rueda de volumen para seleccionar [AUDIO CTRL] y luego púlsela. 3 Gire la rueda de volumen para seleccionar (consulte la siguiente tabla) y luego púlsela. R...
Page 44 - MÁS INFORMACIÓN; Mantenimiento
12 MÁS INFORMACIÓN General En un manual en línea en el siguiente sitio, encontrará información detallada y notas acerca de los archivos de audio que pueden reproducirse: www.kenwood.com/cs/ce/audiofile/ Archivos reproducibles • Archivos de audio que pueden reproducirse: MP3 (.mp3), WMA (.wma), FLAC ...
Page 45 - LOCALIZACIÓN Y SOLUCIÓN DE PROBLEMAS
13 ESPAÑOL | Síntoma Solución El sonido no se escucha. • Ajuste el volumen al nivel óptimo.• Inspeccione los cables y las conexiones. Aparece “PROTECT” y no se puede realizar ninguna operación. Asegúrese de que los terminales de los cables de altavoz estén correctamente aislados y luego reinicialice...
Page 46 - INSTALACIÓN / CONEXIÓN; Lista de piezas para la instalación
14 Advertencia • La unidad puede utilizarse solamente con una fuente de alimentación de 12 V CC con negativo a masa. • Desconecte el terminal negativo de la batería antes de realizar el cableado y el montaje.• Para evitar un cortocircuito, no conecte el cable de la batería (amarillo) ni el cable de ...
Page 47 - Procedimiento básico; Cómo desmontar la unidad
15 ESPAÑOL | Procedimiento básico 1 Quite la llave del interruptor de encendido; después, desconecte el terminal · de la batería del automóvil. 2 Conecte los cables correctamente. (Consulte Conexión del cableado. ( ➜ 16) ) 3 Instale la unidad en su automóvil. (Consulte Instalación de la unidad (mont...
Page 48 - Conexión del cableado
16 ANT CONT P. CONT MUTE R L REAR/SW Conexión del cableado Fusible (10 A) Salida posterior/subwoofer Terminal de la antena Terminal de tierra posterior Caja de fusibles del vehículo Caja de fusibles del vehículo Batería Interruptor de encendido Azul/blanco (Cable de control de potencia) Rojo (Cable ...
Page 49 - ESPECIFICACIONES
17 ESPAÑOL | ESPECIFICACIONES Sintonizador FM Gama de frecuencias KMM-100 87,5 MHz a 108,0 MHz (espacio 50 kHz) KMM-100U 87,9 MHz a 107,9 MHz (espacio 200 kHz) Sensibilidad útil (Relación señal/ruido = 26 dB) 11,2 dBf (1,0 μV/75 Ω) Sensibilidad de silenciamiento (DIN S/N = 46 dB) 19,2 dBf (2,5 μV/75...