Page 3 - BASICS; Faceplate
3 KDC-X397 KDC-MP155U KDC-155U KMR-355U KDC-X397 KDC-255U KDC-355U KDC-MP255U BASICS To Do this (on the faceplate) Do this (on the remote control) Turn on the power Press L SRC . • Press and hold to turn off the power.* 1 Press and hold SRC to turn off the power. ( Pressing SRC does not turn on the ...
Page 4 - GETTING STARTED
4 GETTING STARTED Cancel the demonstration When you turn on the power (or after you reset the unit), the display shows: “CANCEL DEMO” \ “PRESS” \ “VOLUME KNOB” 1 Press the volume knob. [YES] is selected for the initial setup. 2 Press the volume knob again. “DEMO OFF” appears. For KMR-355U , [DEMO OF...
Page 5 - RADIO
5 ENGLISH | RADIO Search for a station 1 Press L SRC to select TUNER. 2 Press repeatedly (or press * AM– / #FM+ on RC-406) to select FM1/ FM2/ FM3/ AM. 3 Press 4 / ¢ to search for a station. • To store a station: Press and hold one of the number buttons ( 1 to 6 ). • To select a stored station: Pres...
Page 7 - AUX
7 ENGLISH | Direct Music Search (using RC-406) (except for KMR-355U ) 1 Press DIRECT . 2 Press the number buttons to enter a track/file number. 3 Press 4 / ¢ ( + ) to search for music. • To cancel, press . • Not available if Random Play is selected.• Not applicable for iPod, KME Light/ KMC file. ( ➜...
Page 8 - PANDORA®; SiriusXMTM
8 PANDORA® (for KDC-X397 / KDC-355U / KDC-255U / KDC-155U / KMR-355U ) Preparation: Install the latest version of the Pandora® application into your device (iPhone/ iPod touch), then log in and create an account with Pandora®.• Select [ON] for [PANDORA SRC] . ( ➜ 4 ) Start listening 1 Open the Pando...
Page 10 - AUDIO SETTINGS
10 AUDIO SETTINGS While listening to any source... 1 Press the volume knob to enter [FUNCTION] . 2 Turn the volume knob to select [AUDIO CONTROL] / [AUDIO CTRL] , then press the knob. 3 Turn the volume knob to make a selection (see the table below), then press the knob. Repeat step 3 until the desir...
Page 11 - DISPLAY SETTINGS; MORE INFORMATION
11 ENGLISH | DISPLAY SETTINGS 1 Press the volume knob to enter [FUNCTION] . 2 Turn the volume knob to select [SETTINGS] , then press the knob. 3 Turn the volume knob to make a selection (see the table below), then press the knob. Repeat step 3 until the desired item is selected or activated. 4 Press...
Page 12 - TROUBLESHOOTING
12 TROUBLESHOOTING Symptom Remedy Sound cannot be heard. • Adjust the volume to the optimum level.• Check the cords and connections. “PROTECT” appears and no operations can be done. Check to be sure the terminals of the speaker wires are insulated properly, then reset the unit. If this does not solv...
Page 13 - SPECIFICATIONS
13 ENGLISH | SPECIFICATIONS Tuner FM Frequency Range For KDC-X397 / KDC-355U / KDC-255U / KDC-155U / KMR-355U : 87.9 MHz to 107.9 MHz (200 kHz space) For KDC-MP255U / KDC-MP155U : 87.5 MHz to 108.0 MHz (50 kHz space) Usable Sensitivity (S/N = 26 dB) 11.2 dBf (1.0 μV/75 Ω) Quieting Sensitivity(DIN S/...
Page 14 - INSTALLATION / CONNECTION; Warning; How to remove the unit
14 INSTALLATION / CONNECTION Warning • The unit can only be used with a 12 V DC power supply, negative ground. • Disconnect the battery’s negative terminal before wiring and mounting. • Do not connect Battery wire (yellow) and Ignition wire (red) to the car chassis or Ground wire (black) to prevent ...
Page 15 - Wiring connection
15 ENGLISH | REMOTE CONT STEERING WHEEL REMOTE INPUT ANT CONT P. CONT MUTE MARINE REMOTE FRONT R L REAR/SW R L REAR/SW KDC-155U KDC-255U SW FRONT R L REAR KDC-355U KDC-X397 KDC-MP155U KDC-MP255U KMR-355U Wiring connection Part list for installation Fuse (10 A) Rear/subwoofer output Rear/subwoofer ou...
Page 17 - FONCTIONNEMENT DE BASE; Façade
3 KDC-X397 KDC-MP155U KDC-155U KMR-355U KDC-X397 KDC-255U KDC-355U KDC-MP255U FONCTIONNEMENT DE BASE Pour Faire (sur la façade) Faire (sur la télécommande) Mettez l’appareil sous tension Appuyez sur L SRC . • Maintenez la touche enfoncée pour mettre l’appareil hors tension.* 1 Maintenez SRC enfoncée...
Page 18 - PRISE EN MAIN
4 PRISE EN MAIN Annulez la démonstration Quand vous mettez l’appareil sous tension (ou après une réinitialisation de l’appareil), l’affichage apparaît: “CANCEL DEMO” \ “PRESS” \ “VOLUME KNOB” 1 Appuyez sur le bouton de volume. [YES] est choisi pour le réglage initial. 2 Appuyez de nouveau sur le bou...
Page 24 - RÉGLAGES AUDIO
10 RÉGLAGES AUDIO Pendant l’écoute de n’importe quelle source... 1 Appuyez sur le bouton de volume pour entrer [FUNCTION] . 2 Tournez le bouton de volume pour choisir [AUDIO CONTROL] / [AUDIO CTRL] , puis appuyez sur le bouton. 3 Tournez le bouton de volume pour réaliser une sélection (voir le table...
Page 25 - RÉGLAGES D’AFFICHAGE; PLUS D’INFORMATIONS
11 FRANÇAIS | RÉGLAGES D’AFFICHAGE 1 Appuyez sur le bouton de volume pour entrer [FUNCTION] . 2 Tournez le bouton de volume pour choisir [SETTINGS] , puis appuyez sur le bouton. 3 Tournez le bouton de volume pour réaliser une sélection (voir le tableau ci-dessous), puis appuyez sur le bouton. Répéte...
Page 26 - EN CAS DE DIFFICULTÉS
12 EN CAS DE DIFFICULTÉS Symptôme Remède Le son ne peut pas être entendu. • Ajustez le volume sur le niveau optimum.• Vérifiez les cordons et les connexions. “PROTECT” apparaît et aucune opération ne peut être réalisée. Assurez-vous que les prises des fils d’enceintes sont isolées correctement, puis...
Page 27 - SPÉCIFICATIONS
13 FRANÇAIS | SPÉCIFICATIONS Tuner FM Bande de fréquences Pour KDC-X397 / KDC-355U / KDC-255U / KDC-155U / KMR-355U : 87,9 MHz à 107,9 MHz (intervalle de 200 kHz) Pour KDC-MP255U / KDC-MP155U : 87,5 MHz à 108,0 MHz (intervalle de 50 kHz) Sensibilité utilisable (S/B = 26 dB) 11,2 dBf (1,0 μV/75 Ω) Se...
Page 28 - INSTALLATION / RACCORDEMENT; Avertissement
14 INSTALLATION / RACCORDEMENT Avertissement • L’appareil peut uniquement être utilisé avec une alimentation de 12 V CC, à masse négative. • Déconnectez la borne négative de la batterie avant le câblage et le montage. • Ne connectez pas le fil de batterie (jaune) et le fil d’allumage (rouge) au châs...
Page 29 - Connexions
15 FRANÇAIS | REMOTE CONT STEERING WHEEL REMOTE INPUT ANT CONT P. CONT MUTE MARINE REMOTE FRONT R L REAR/SW R L REAR/SW KDC-155U KDC-255U SW FRONT R L REAR KDC-355U KDC-X397 KDC-MP155U KDC-MP255U KMR-355U Connexions Liste des pièces pour l’installation Fusible (10 A) Sortie arrière/caisson de grave ...
Page 31 - PUNTOS BÁSICOS; Placa frontal
3 KDC-X397 KDC-MP155U KDC-155U KMR-355U KDC-X397 KDC-255U KDC-355U KDC-MP255U PUNTOS BÁSICOS Para Hacer esto (en la carátula) Hacer esto (en el mando a distancia) Encender la unidad Pulse L SRC . • Pulse y mantenga pulsado para apagar la unidad.* 1 Pulse y mantenga pulsado SRC para apagar la unidad....
Page 32 - PROCEDIMIENTOS INICIALES
4 PROCEDIMIENTOS INICIALES Cancele la demostración Cuando enciende la unidad (o después de reposicionarla) la pantalla muestra: “CANCEL DEMO” \ “PRESS” \ “VOLUME KNOB” 1 Pulse la rueda de volumen. Se selecciona [YES] para la configuración inicial. 2 Pulse de nuevo la rueda de volumen. Aparece “DEMO ...
Page 38 - AJUSTES DE AUDIO
10 AJUSTES DE AUDIO Mientras se escucha desde cualquier fuente... 1 Pulse la rueda de volumen para ingresar en [FUNCTION] . 2 Gire la rueda de volumen para seleccionar [AUDIO CONTROL] / [AUDIO CTRL] y luego púlsela. 3 Gire la rueda de volumen para seleccionar (consulte la tabla de abajo) y luego púl...
Page 39 - AJUSTES DE VISUALIZACIÓN; MÁS INFORMACIÓN
11 ESPAÑOL | AJUSTES DE VISUALIZACIÓN 1 Pulse la rueda de volumen para ingresar en [FUNCTION] . 2 Gire la rueda de volumen para seleccionar [SETTINGS] y luego púlsela. 3 Gire la rueda de volumen para seleccionar (consulte la tabla de abajo) y luego púlsela. Repita el paso 3 hasta que se seleccione o...
Page 40 - LOCALIZACIÓN Y SOLUCIÓN DE PROBLEMAS
12 LOCALIZACIÓN Y SOLUCIÓN DE PROBLEMAS Síntoma Solución El sonido no se escucha. • Ajuste el volumen al nivel óptimo.• Inspeccione los cables y las conexiones. Aparece “PROTECT” y no se puede realizar ninguna operación. Asegúrese de que los terminales de los cables de altavoz estén correctamente ai...
Page 41 - ESPECIFICACIONES
13 ESPAÑOL | ESPECIFICACIONES Sintonizador FM Gama de frecuencias Para KDC-X397 / KDC-355U / KDC-255U / KDC-155U / KMR-355U : 87,9 MHz a 107,9 MHz (espacio 200 kHz) Para KDC-MP255U / KDC-MP155U : 87,5 MHz a 108,0 MHz (espacio 50 kHz) Sensibilidad útil(Relación señal/ruido = 26 dB) 11,2 dBf (1,0 μV/7...
Page 42 - INSTALACIÓN / CONEXIÓN; Advertencia; Precaución; Instalación de la unidad (montaje en el tablero)
14 INSTALACIÓN / CONEXIÓN Advertencia • La unidad puede utilizarse solamente con una fuente de alimentación de 12 V CC con negativo a masa. • Desconecte el terminal negativo de la batería antes de realizar el cableado y el montaje. • Para evitar un cortocircuito, no conecte el cable de la batería (a...
Page 43 - Conexión del cableado
15 ESPAÑOL | REMOTE CONT STEERING WHEEL REMOTE INPUT ANT CONT P. CONT MUTE MARINE REMOTE FRONT R L REAR/SW R L REAR/SW KDC-155U KDC-255U SW FRONT R L REAR KDC-355U KDC-X397 KDC-MP155U KDC-MP255U KMR-355U Conexión del cableado Lista de piezas para la instalación Fusible (10 A) Salida posterior/subwoo...