Page 2 - Before applying power; The marking of products using lasers; Introduction; WARNING; Safety precautions; Caution : Read this section carefully to ensure safe operation.
2 Before applying power Caution : Read this section carefully to ensure safe operation. Units are designed for operation as follows. Europe and U.K. ..................................................................... AC 230 V only The marking is located on the rear panel and says that the compo-ne...
Page 3 - Unpacking; Special features; Contents
3 Unpacking Unpack the unit carefully and make sure that all accessories are put aside so they will not be lost.Examine the unit for any possibility of shipping damage. If your unit is damaged or fails to operate, notify your dealer immediately. If your unit was shipped toyou directly, notify the sh...
Page 4 - IMPORTANT SAFEGUARDS
4 Caution : Read this page carefully to ensure safe operation. IMPORTANT SAFEGUARDS 1 0 . C l e a n i n g – U n p l u g t h i s a p p l i a n c e f r o m t h e w a l l o u t l e t b e f o r e c l e a n i n g . D o n o t u s e v o l a t i l e s o l v e n t s s u c h a sa l c o h o l , p a i n t t h i...
Page 6 - System connections; Caution
6 System connections Caution: Do not plug in the power lead until all connections are com-pleted. Malfunction of microcomputer If operation is not possible or erroneous display appears eventhough all connections have been made properly, reset themicrocomputer referring to “In case of difficulty”. ™ ...
Page 7 - To use the headphone; Connection to a general-use amplifier
7 Adjusting the output levels of the output jacksand headphone output The OUTPUT level (UP/DOWN) keys of the remote control unit canadjust the output levels from the LINE/OUT jacks and PHONES jackof the unit. To use the headphone Connect a stereo headphone to the PHONES jack of the CD player. Adjust...
Page 8 - SYSTEM CONTROL OPERATIONS; SYSTEM CONTROL CONNECTIONS
8 SYSTEM CONTROL OPERATIONS Remote Control Lets you operate this unit with the system remote control unit supplied with the amplifier or receiver. Automatic Operation Automatically switches the input selector on the amplifier or receiver when you start playback from this unit. Synchronized Recording...
Page 9 - Maintenance; Caution on condensation; Discs which can be played with this unit; Disc handling precautions; Never play a cracked or warped disc; n o; d 1 S C; Cleaning
9 Maintenance Be specially cautious against condensation in a following circumstance: When this unit is carried from a place to another across a largedifference in temperature, when the humidity in the room where thisunit is installed increases, etc. Caution on condensation Condensation (of dew) may...
Page 10 - Controls and indicators; DISPLAY
10 T R A C K EDIT CCRS TRACK NO. P.C. TOTAL TIME SINGLE TIME 6 1 11 16 7 2 1217 8 3 1318 9 4 1419 10 5 1520 P G M REPEAT 8 _ : 8 8 8 8 8 POWER - ON – OFF PHONES P.MODE EDIT CHECK CLEAR PEAK SEARCH TIME DISPLAY OPEN/CLOSE 1 2 3 4 5 6 7 8 9 0 +10 REPEAT 24 bit D.R.I.V.E. II RANDOM 0 7 6 4 ¢ 1 ¡ 1 9 0 ...
Page 12 - Playing tracks in order from track No. 1; To pause playback; Press the POWER switch to ON.; To stop playback
12 Normal play (TRACK mode) 2 Load a disc. 3 Start playback. 1 Open the tray. Use the following procedure to play a CD in the original orderof tracks from track No. 1. : Keys and control used in the operations described on this page. 3 Close the tray. Playing tracks in order from track No. 1 ÷ Playb...
Page 15 - To check or change the programmed tracks; Auto space function; To add a track to the program
15 ÷ When a track No. is selected, the track will be added to the end of theexisting program. Press to clear tracks from the end. To check or change the programmed tracks To clear tracks from the program 1 Press the CHECK key. Press until the track No. tobe changed is displayed. 2 Select the new tra...
Page 16 - Repeated playback; To repeat only the programmed tracks; Preparation; To cancel repeated playback
16 Repeated playback To repeat only the programmed tracks : Keys and control used in the operations described on this page. ™ Preparation To cancel repeated playback Press the REPEAT key again. Lights up. 1 Press so that the "PGM" indicator lights. 2 Select the desired track No. Press the nu...
Page 17 - To repeat the entire disc
17 To repeat the entire disc 1 Press so that the “TRACK” indicator lights. 2 Switch REPEAT ON. 3 Start playback. To cancel repeated playback Press the REPEAT key again. : Keys and control used in the operations described on this page. Goes off. Lights up. Lights up. 1 2 3 4 5 6 7 8 9 0 +10 0 7 6 4 ¢...
Page 18 - Editing; Light the “EDIT” indicator.; Enter the recording time of the tape.; The CD contents are edited as follows.; Playing or recording the edited contents
18 The following procedure allows to record a CD within thespecified tape length so that no music is interrupted in themiddle at the ends of sides A and B. Editing Preparation : Keys and control used in the operations described on this page. Press the numeric keys as shown below. 30-minute tape : 00...
Page 19 - To clear the edited contents; To check the edited contents; To cancel Peak search:; F I L E
19 : Keys and control used in the operations described on this page. Press any one of these keys. ÷ The edited data is cleared entirely. To clear the edited contents ÷ When the CHECK key is pressed, track numbers and remaining time in the file A are displayed first, then those in the file B. ÷ The &...
Page 20 - Playback in a random order (Random playback); To select another track in the middle of playing one; Press the RANDOM key.
20 Playback in a random order (Random playback) ÷ Pressing the 4 key once returns to the beginning of the track being played. ÷ Press the RANDOM key to start normal playback. ™ As tracks are selected at random, you can enjoy listening tofor a long time. ÷ Load a disc in the CD player. @ Preparation ...
Page 21 - Timer operations; Set the amplifier volume.; Adjusting the volume:
21 12 F 00 1 2 3 4 5 6 7 8 9 0 +10 0 7 6 4 ¢ 1 ¡ Timer operations Timer playback of CD can be started at any time using anaudio timer which is available in audio stores. Preparation ÷ Connect the power cords of the associatedcomponents so that their power can be turnedON through the audio timer.(Als...
Page 22 - In case of difficulty; Operation to reset; CD player unit
22 ÷ Insert the power plug firmly to the AC outlet. ÷ Turn the amplifier’s power ON. ÷ Load the disc again with its label side up. ÷ Insert the disc properly. ÷ Wipe off the dust on the surface of the discreferring to “Disc handling precautions”. 9 ÷ Replace the disc with a new one. ÷ Leave the play...
Page 23 - Specifications
23 Specifications [ Format ] System ..................................................................................... Compact disc digital audio systemLaser ................................................................................................................ Semiconductor laser [ D/A ...
Page 24 - For your records
For your records Record the serial number, found on the back of the unit, in the spacesdesignated on the warranty card, and in the space provided below. Referto the model and serial numbers whenever you call upon your dealer forinformation or service on this product. Model Serial Number
