Kawasaki MULE 600 SERIES - Manual
Kawasaki MULE 600 SERIES – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – BEFORE YOU START
- Page 3 – lower seat rotated up 90 degrees
- Page 4 – For Hard Rear Window:; INSTALL REAR ROOF MOUNT; For Soft Rear Curtain:
- Page 5 – INSTALL LEFT SIDE FRAME; behind; the rear roof mount which was
- Page 6 – Note: hinges are plastic components. Do not; INSTALL RUBBER FILLER; plastic hinge with spacer block
- Page 8 – For Hard Sided Doors only:; FINISHING TOUCHES
- Page 9 – ACCESSORIES
INST
ALLA
TION & OWNER’S MANUAL
Rev. G
p. 1 of 9
CAB INSTALLATION INSTRUCTIONS
KAWASAKI MULE 600 SERIES
HARD AND/OR SOFT SIDED CAB KIT (p/n KAF600-012)
(Note: hard sided doors, soft sided doors, and anti-draft panel are
sold separately but are included in these instructions.)
The contents of this envelope are the property of the owner.
Be sure to leave with the owner when installation is complete.
This cab is shown with the following optional equipment: hard sided doors, work lights,
windshield wiper, strobe light, and antenna for overhead console. Other options not
shown are: soft sided doors and an anti-draft panel for underneath the bench seat.
RECOMMENDATIONS:
1) It is recommended that the tire pressure be adjusted as follows when installing a cab
on this vehicle: front tires to have 11.5 p.s.i. and rear tires to have 18.0 p.s.i.
2) It is recommended that two (2) heavy-duty springs (p/n 92145-0400) be used in the
rear suspension when installing a cab on this vehicle. It is also recommended to set
the spring adjusting sleeve of the rear shock unit at the circled position in the chart
below (position 4).
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
DESIGN CONCEPT Curtis cabs feature an assembly of parts designed for your vehicle which require adjustment and alignment of components to accommodate vehicle variations and provide proper weather protection. For accurate installation, proper operation, and years of satisfaction, please read and unde...
Rev. G p. 3 of 9 1. INSTALL ANTI-DRAFT PANEL Note: this item is sold separately from the cab kit and the door kits. 1.1 If a hard rear window will be installed, make sure the sheetmetal filler underneath the expanded metal screen is reversed so the small bent lip faces forward as shown in Fig. 1.1 (...
Rev. G p. 4 of 9 remove this protective film before installation rear roof mount shown in place Fig. 3.2 (view from front of vehicle) Fig. 4.1 (view from front driver’s side of vehicle) 90 degree mounting flange on rear roof mount locknuts to be installed against this flange surface 3. INSTALL HARD ...
