Kawasaki 691204 - Manual
Kawasaki 691204 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 4 – FIGURE 1. CONNECTING THE CUT-OFF SAW TO THE AC POWER RECEPTACLE
- Page 12 – THE LASERLIGHT; LASER LIGHT; LASER RADIATION
- Page 13 – CARBON BRUSHES
COMPONENT
#691204
14" CUT-OFF SAW
INSTRUCTION MANUAL
FOR CUSTOMER SERVICE
POUR LE SERVICE APRÉS VENTE
OU DU CONSOMMATEUR
PARA EL SERVICIO
PARA EL CONSUMIDOR
1-800-590-3723
Printed in China
87-1904-60957
KAWASAKI™ IS A TRADEMARK LICENSED BY KAWASAKI™
MOTORS CORP., U.S.A., WHICH DOES NOT MANUFACTURE OR
DISTRIBUTE THIS PRODUCT. CONSUMER INQUIRES SHOULD BE
DIRECTED TO:
©COPYRIGHT 2007 ALLTRADE TOOLS, LLC.
1431 VIA PLATA
LONG BEACH, CA 90810-1462 USA
691204 – 14" Cut-off Saw_Rev. 1/30/07
THIS MANUAL CONTAINS IMPORTANT INFORMATION REGARDING SAFETY, OPERATION,
MAINTENANCE AND STORAGE OF THIS PRODUCT. BEFORE USE, READ CAREFULLY AND
UNDERSTAND ALL CAUTIONS, WARNINGS, INSTRUCTIONS AND PRODUCT LABELS. FAILURE TO DO
SO COULD RESULT IN SERIOUS PERSONAL INJURY AND/OR PROPERTY DAMAGE.
IF YOU SHOULD HAVE ANY QUESTIONS OR EXPERIENCE A PROBLEM WITH YOUR ALLTRADE
PRODUCT, DO NOT RETURN THIS PRODUCT TO THE STORE. PLEASE CALL OUR CUSTOMER SERVICE
DEPARTMENT AT
1-800-590-3723
. BEFORE YOU CALL, HAVE THE FOLLOWING INFORMATION
AVAILABLE: MODEL No., DATE PURCHASED AND STORE LOCATION. AN ALLTRADE
REPRESENTATIVE CAN RESOLVE YOUR PROBLEM OVER THE PHONE. IF YOU WOULD LIKE TO MAKE
A SUGGESTION OR COMMENT, GIVE US A CALL OR EMAIL US AT: [email protected].
YOUR FEEDBACK IS VITAL TO US.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
This Cut-off saw is equipped with a grounded 3-wire power cord with a 3-prongplug. If the power cord will not fit into the wall plug, an approved adapter can beused as long as it is connected to the center screw in the wall plate. See Figure 1and the steps below to use an AC grounding adapter: 1. Re...
L LA AS SE ER R S SA AFFE ET TY Y N NE EV VE ER R L LO OO OK K IIN NT TO O T TH HE E L LA AS SE ER R B BE EA AM M.. Any contact with the eyes by the beam could cause injury. Do not use the laser when cutting reflective materials. D DO O N NO OT T A AIIM M T TH HE E L LA AS SE ER R B BE EA AM M A AT ...
T TO O R RE EP PL LA AC CE E T TH HE E C CA AR RB BO ON N B BR RU US SH HE ES S:: 1. Locate the brushes. They should be both sides of the motor housing at 180˚ degrees apart. 2. Use a slotted blade screwdriver and turn the brush caps counterclockwise. 3. Remove the caps, tension springs, and carbon ...
