Kathrein CCR 512 - Manual - manualsarea.com

Page 2 - EPG – P; FOR EXPERTS; LNB; GITAL

1. SAFETY INSTRUCTIONS ............................................................................................................. 3 2. CONNECTIONS ................................................................................................................................. 4 3. OPERATION ........

Page 3 - Safety instructions; Extended absence / thunderstorms

1. Safety instructions The following section contains important information regarding operation, place of installation and connection of the receiver. Read these instructions carefully before putting the unit into operation. Extended absence / thunderstorms Always switch the unit off via its mains s...

Page 4 - Important notes for siting and installation; Protect the unit against humidity, drips and splashing.

Important notes for siting and installation Place of installation Every electronic device generates heat. The rise in temperature, however, lies within a safe range. Slight colour changes may occur to sensitive furniture surfaces and veneers over the course of time due to the constant effect of heat...

Page 5 - within one second the; TV; Display of TV programmes; The points are displayed, when the unit is muted.; V c r; The unit is in standby and can be switched on by pressing the; and

3. Operation 3.1. Local control Open (and close) the flap on the front panel of the unit by pressing the dotted area (left). The local control consists of the buttons [STANDBY], [ ▲ ] and [ ▼ ] for switching the programmes (up/down), as well as [ - ] and [ + ] for adjusting the volume. VOLUME CHANNE...

Page 6 - and list; Switch to the next / previous programme with the [; Programme management with 10 favourite lists; NEW S

3.3. Programme 3.3.1 Programme selection with the numerical buttons [0...9], [ ▲ ] , [ ▼ ] and list Setting a programme is carried out by direct entry of the programme number with the numerical buttons (0 is also a programme number). Switch to the next / previous programme with the [ ▲ ] / [ ▼ ] but...

Page 7 - After selecting a programme, the following display appears:; Current favourite list; Das Erste; Current programme; The volume of the receiver can be adjusted in 20 steps using the [

All programmes from the programme pool are also saved in the favourite list 0 = „ALL“ upon delivery. The favourite list F0 = ALL contains all the programmes known thus far for satellite receivers. Some of the programmes from the satellites Astra 19 and Eutelsat Hotbird are additionally contained in ...

Page 8 - The „timer programming“ menu is called up by pressing the [; r E c; The timer recording can; Deleting a timer programming:; or

3.7. Timer The „timer programming“ menu is called up by pressing the [ ¹ ] button. Up to 8 timer events can be alternatively entered with TV or radio programmes. Note: Keep in mind, that the video recorder must also be set to the same recording time. Note: Please make sure, that no remote control co...

Page 11 - The switch-over to the left menu window is done with the; Changing names of the favourite lists; The letters (capitalised a. small) or digits can be selected with the

Deleting: Move the programme, which is to be deleted, to the red bar using the [ ▼ ] [ ▲ ] buttons (or by entering the programme number). Place it in the centre field by pressing the [ W ] button. Exit the menu with the [E] button and ‚delete‘ with the [OK] button – finished! Note! „Deleted“ program...

Page 12 - pool; antenna signal

4.1.3 Programme pool The programme pool contains all programmes in alphabetical order. Press the [M] button to select the satellites. Press the [TV] button to select free or encrypted programmes. In „All Free“ („All CA“) you will find all the free (all unencrypted) programmes of the selected satelli...

Page 13 - lock; Please note, that after activating the parental lock, the menus,

4.1.4 Parental lock The 5-digit password (PIN) is set to 00000 at the factory. a) Changing the password (PIN) Select the „Parental lock“ menu with the [4] button in the main menu „Programme!“ Select the entry field {PIN} by using the [2] button or the [ ▼ ] button, and activate it by pressing [OK]. ...

Page 14 - ASTRA; (only possible, if the symbol rate has been changed to; rate; .“ Programmes, which you do not want to include in the

4.2. Search 4.2.1. Satellite search The satellite search occurs via all frequencies of the selected satellite. Select the desired settings in the order of the menu: The selection of the individual parameters is carried out after the activation with the [OK] button and then with the [ ► ] or [ ◄ ] bu...

Page 17 - Di; gital; Eq; uipment

4.4.4. LNB settings (1) LNB {ON} Standard setting {OFF} Operation without LNB signal (e.g. on special systems with several subscribers) (2) In standby {OFF} Standard setting Attention! Only use the setting {OFF} for individual systems, otherwise the receiver supplies the LNB with power even in stand...

Page 18 - Save the downloaded data.

4.4.6. Download-over-air (Software update via satellite) In the submenu „Download“ you can individually download operating software and programme lists of your receive via the satellite ASTRA (Update via download-over-air). To do so, your receiving system must be aligned to the satellite ASTRA 19.2°...

Page 19 - onditional; information; your

4.5. CA ( C onditional A ccess) = Encrypted programmes (CCR 512) 4.5.1 General information To receive encrypted programmes, you need a Common Interface CA module (CAM) and a Smartcard from your service provider. Note, that the CA modules with the respective Smartcards only decode programmes from you...

Page 23 - CityCom

998 70 18 /0 70 2/sc hw , S ubj ect to tec hni ca l c ha nges ! CityCom ® Communication systems, a company of the Kathrein group, Schlierseestraße 4, 83022 Rosenheim

Kathrein CCR 512 - Manual

Table of Contents:

Summary

Other Kathrein Models