John Lewis JLWM 1410 - Manual

Product description 1 Detergent dispenser drawer 2 Control panel 3 Door opening handle 4 Rating plate 5 Drain pump 6 Adjustable feet 1 2 3 5 4 6 7

Detergent dispenser drawer Compartment for detergent used for prewash and soak phase or for stain removerused during the stain action phase (ifavailable). The prewash and soak detergent isadded at the beginning of the washprogramme. The stain remover is addedduring the stain action phase. Compartmen...

Control panel Below is a picture of the controlpanel. It shows the programmeselector dial as well as the buttonsand pilot lights. These are presentedby relevant numbers on the followingpages. 1 3 2 12 4 5 6 7 8 9 10 11 1 Detergent dispenser drawer 2 On/Off and Reset button 3 Programme selector butto...

First use • Ensure that the electrical and water connections comply withthe installation instructions. • Remove the polystyrene block and any material from the drum. • Before the first wash, run a cotton cycle at the highest temperaturewithout any laundry in themachine, to remove anymanufacturing re...

Daily use Load the laundry Open the door by carefully pulling the doorhandle outwards. Place the laundry in thedrum, one item at a time, shaking them outas much as possible. Close the door. Measure out thedetergent Measure out the detergent and thefabric softener Pull out the dispenser drawer until ...

Select the desiredtemperature and spinspeed Press button 5 button repeatedly in order to set the temperature and button 6 to change the spin speed from the one proposed bythe washing machine.The button 6 allows you also to choose «No Spin» («0»), «Rinse Hold » or «Quiet»function. Select the desiredo...

flashes 3 times and the message Err is displayed for a few seconds. Important! You must set the washing machine to Pausebefore you make any change in theprogramme in progress. Programme correction As long as the wash programme has notbeen started yet, the programme selectioncan still be changed.If t...

When you close the door to restart theprogramme select the previous programmeby pressing the buttons 3 , repeat the options previously selected and press thebutton 10 . End of programme The pilot light of the button 10 goes out. «0» blinks and the message Wash timedisappears from the display. The Do...

Before loading thelaundry Never wash whites and coloureds together.Whites may lose their «whiteness» in thewash.New coloured items may run in the firstwash; they should therefore be washedseparately the first time. Make sure that no metal objects areleft in the laundry (e.g. hair clips,safety pins, ...

Washing programmes Programme - Maximum and MinimumTemperature - Cycle Description - MaximumSpin Speed - Maximum Fabrics Load - Type ofLaundry Options Detergent Compartment Cottons 1) 95° - ColdMain wash - RinsesMaximum spin speed at 1400 rpmMax. load 7 kg - Reduced load 3.5 kg White cotton (heavily ...

Programme - Maximum and MinimumTemperature - Cycle Description - MaximumSpin Speed - Maximum Fabrics Load - Type ofLaundry Options Detergent Compartment Off For cancelling the programme which is running or to switch the machine off . 1) Cycle time duration, energy and water consumptions are proporti...

Care and cleaning You must DISCONNECT the appliancefrom the electricity supply, before you cancarry out any cleaning or maintenance work. Descaling The water we use normally contains lime. Itis a good idea to periodically use a watersoftening powder in the machine. Do thisseparately from any laundry...

Cleaning the drawerrecess Having removed the drawer, use a smallbrush to clean the recess, ensuring that allwashing powder residue is removed fromthe upper and lower part of the recess. Replace the drawer and run the rinseprogramme without any clothes in the drum. Washing drum Rust deposits in the d...

Installation Unpacking All transit bolts and packing must beremoved before using the appliance.You are advised to keep all transit devices sothat they can be refitted if the machine everhas to be transported again.1. After removing all the packaging, carefully lay machine on it’s back toremove the p...

5. Open the porthole and remove the polystyrene block fitted on the doorseal. 6. Fill the smaller upper hole and the two large ones with the correspondingplastic plug caps supplied in the bagcontaining the instruction booklet. Positioning and levelling Install the machine on a flat hard floor. Makes...

of connectors are available from goodhardware stores and plumbers merchants tosuit most domestic plumbing. Any alterationto your existing plumbing must be carriedout by a competent person, or qualifiedplumber. Water inlet An inlet hose is supplied and can been foundinside the machine drum. Do not us...

Warning! Installation should comply with local waterauthority and buildingregulations’ requirements.The appliance must beconnected to a cold watersupply. A minimum water pressure of 0.05MPa (0.5 bar) is required for safeoperation of the appliance.If you cannot make the cold waterconnection direct fr...

If the outlet spigot has not been usedbefore, remove any blanking plug that maybe in place. Push the drain hose onto the spigot andsecure with a clip, ensure a loop is formed inthe drain hose (see diagram) to preventwaste from the sink entering the appliance.If you intend to drain the hose from them...

SHOWER BATH BIDET WASHING MACHINE DISHWASHER RAINWATER ‘RUN-OFF’ SURFACE WATER DRAINS & SEWERS UNTREATED DISCHARGE RIVER RIVER FOUL DRAIN FOUL SEWERS SEWAGE TREATMENT WORKS TREATED DISCHRGE SINK TOILET Electrical connection Any electrical work required to install thisappliance should be carried ...

What to do if… Certain problems are due to lack of simplemaintenance or oversights, which can besolved easily without calling out an engineer.Before contacting your local Service Centre,please carry out the checks listed below. Important! if you call out an engineer to a fault listed below, or to re...

Problem Possible cause/Solution The display shows thealarm code EFO: Anti-flooding system has been activated.• Disconnect the appliance, close the water tap and contact the Service Force Centre. Repairs - After Sales Service Repairs - After SalesService Your appliance comes with a three yearwarranty...

inexperienced persons may cause injury orserious malfunctioning. Contact your localJohn Lewis Branch. Environment concerns The symbol on the product or on itspackaging indicates that this product maynot be treated as household waste. Insteadit should be taken to the appropriatecollection point for t...